• In the piezometers of the figure shown, liqui stands 1.37 m above point M. What is the pressure at M in kiloPascal if the liquid is (a) water, (b) oil (sp gr 0.90) and (c) mercury? A В

Q: Problem 4: Inputs: ● ● ● a = 1.2 m b = 0.5 m P = 50 N Table not required, but feel free to use it if…

A: Given data in question  Load 50 N Span 1.7 m To find out  Reaction Fb Reaction Fa Vector sum

Q: A long steel I-beam used in bridge construction has a length of 15.0 m. The beam may be exposed to…

A: Solution: Given Data: Length=15.0 m Low temperature=-22 degree Celsius High temperature= 33 degree…

Q: 2 - Two concentric cylinders are covered by a rigid plate that carries an axial load, as shown in…

A: Rise in temperature, T

Q: spherical steel ball bearing has a diameter of 2.540 cm at 23.00°C. (Assume the coefficient of…

A: Asked: To determine the diameter of the spherical ball as the temperature is increased and the…

Q: I have been over this problem several times I believe the issue may be in my equilibrium equations.

A: F=590N To find value of F2, F3 ,F1

Q: An aluminum pipe has a length of 70 m at a temperature of 20°C. An adjacent steel pipe at the same…

A:

Q: 1) Consider a chunk of fluid that is initially shaped as shown hanging off of the edge of a table in…

A: Let us consider the given shape "A" Assuming that the fluid section labeled is able to maintain its…

Q: Calculate the density, specific weight, and specific volume of oxygen at  and 40 kPa abs. b. If the…

A:

Q: ht of material in in situ sta nt of material submerge ir sity 0.4DD %3D naterialhas a diameter of

A:

Q: can we say about the nature of this flow?

A: To find : To find nature of flow.

Q: 4. A brass weight is to be attached to the bottom of the cylinder so that the cylinder will be…

A:

Q: www (pH=7). What is the total hardness (TH) of water that contains the following ion concentrations…

A: Given:Required:Total hardness of water

Q: As shown in the figure, what is the static gage pressure in kg/cm2 in the air chamber?

A: ASKED: To determine the static gage pressure in the air chamber.   The given problem can be…

Q: need the answer as soon as possible

A:

Q: H.S An open cylinder can has an inside radius of 2 cm and an inside height of 5 cm use the total…

A:

Q: 11. A steel measuring tape used by a civil engineer is 50metres long and calibrated at 200C. The…

A:

Q: PROBLEM 3. Compute the capillary effect of immersion in water of a glass tube of 4mm internal…

A: The values given in the question are as follows Diameter of tube(d)=4 mm or 4*10-3 m Surface…

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: What is the ratio of the dynamic viscosity of air to that of water at standard pressure and a…

A:

Q: A fluid's viscosity and unit weight are reduced to 60% and 80%, due to increase in temperature. If…

A: Given data- Fluid's viscosity & unit weights are reduced to 60% & 80%, All other parameters…

Q: Two concentric cylinders are covered by a rigid plate that carries an axial load, as shown in the…

A: Temperature , T

Q: A thin 15x10 cm plate is pulled at 2.2 m/s horizontally on a 3 mm thick oil layer with a stationary…

A: Given Area 15×10 cmViscosity 0.025 pa secThickness 3 mmVelocity 2.2 m/secTo find out Force required…

Q: a) determine the unit weight of the liquid when it is at the level shown b) determine the weight of…

A: Density of liquid(ρliquid)=2.52 slug/ft3Volume of liquid(Vliquid)=10×5×(7-0.82)=309 ft3a) Unit…

Q: 10. A beaker is filled with a liquid of density p1 up to a certain height. A is a point, h m…

A:

Q: A piece of metal weighs 491 kN in air. When submerged in water, it weighs 67 kN. Find the volume of…

A:

Q: Find the pressure in the pipe cortaining gasoline in kPa. Ir the given conditions, cir has a density…

A:

Q: 10. A beaker is filled with a liquid of density p1 up to a certain height. A is a point, h m…

A: Given, Density of liquid 1 = ρ1 Density of liquid 2 = ρ2 Depth of point A before, replacing the…

Q: 3. What is the diameter change of a 50-ft spherical tank made of ½" steel plate due to internal…

A: Internal diameter = 50 ft.  wall thickness = t = 0.5'' v = 0.3. p = 100 psi. E = 30,000,000 Psi.

Q: Determine the reactions. 6m 10 kN/m B 4 m 25 KN 4 m G E 13 A 20 kN/m

A: In the given problem the structure have two supports  Hinge support at B and roller support at A,…

Q: Q.2) The assembly shown below is composed of an aluminum tube and a cylindrical steel plug. The mass…

A: Given: The mass density of aluminum is 2700 kg/m3. The mass density of steel is 7800 kg/m3. Consider…

Q: c) Illustrate the results of the viscosity test of the above motor oil then fit the viscosity…

A: Solution; (c)  Viscosity at T0=0°C is 1708.84 cSt. We also know that, at T=40°C the viscosity is 140…

Q: A rectangular tank has dimensions 120 x 66 x 60-cm and weighs 1410 N. If the tank is allowed to…

A:

Q: Most common fluids such as water, air, and gasoline are classified under this type of fluid under…

A: According to Issac Newton the higher the viscosity of liquid the greater is the force per unit area…

Q: Consider a cylinder of fluid of length L and radius R flowing steadily in the centre of a pipe of…

A:

Q: A gas expands from 0.03 m3 to 0.05 m3 at constant pressure of 3.5 atm. Determine the work done.

A: The initial volume is V1=0.03 m3. The final volume is V2=0.05 m3. The pressure is P=3.5 atm. The…

Q: 6. Why can't the density be assumed as constant for compressible fluids? a) It shows variation with…

A: Because density vary with temperature and pressure for a fluid.

Q: F9-13. Determine the slope and displacement at point A. El is constant. Use the principle of virtual…

A:

Q: Problem 6. What is the bulk modulus of a liquid which is compressed in a cylinder from a volume of…

A: Given data : Initial pressure (P1)=80 N/cm2Final pressure (P2)=150 N/cm2Initial volume (V1)=0.0125…

Q: A 20 cm diameter cylinder is moving to the right inside a 22 cm diameter pipe at constant velocity…

A: Given data in question  Dynamic viscosity  Outer pipe diameter  Inner cylindrical diameter  Velocity…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?