In the given loaded beam determine the resultant force, R and its location from the point show fbd and complete solution. need asap thank you

Q: Tension arrows are always indicated by an arrow from the pin. O close O away

A: Note:- As per our guideline, we are supposed to answer only the first question. Pinned joint:- A pin…

Q: aluminum [E = 70 GPa] links (1) and %3D H.W.3: In Figure (2) support rigid beam ABC. Link (1) has a…

A: GivenE=70 GPaABC=RigidbeamζB= ?

Q: The collapse load for the beam as shown in figure is to G. 3. A. Mp 3. - L/2 L2 He L2

A:

Q: A cantilever beam with a ‘T’ shaped cross-section is loaded with a distributed load as shown below.…

A:

Q: 3. The aluminum block has the rectangular cross-section and is subjected to an axial compressive…

A: To determine: New length of 2 in side.

Q: For the Pratt bridge truss and loading shown, determine the average normal stress in member BE,…

A: Given data in question  Truss Loads Span member length  To find out  Stress in member BE Note We…

Q: Q4) A cast iron beam is of I – section as shown in Figure (3). The beam is simply supported on a…

A: Given, L = 5 mσ = 20 N/mm2Center of gravityy =90.66 mmMoment of inertiaI =bd312I…

Q: What maximum load P can be applied without exceeding an allowable stress of 70 MPa for aluminum or…

A:

Q: building construction. The beam is only reinforced with prestressing steel and no mild reinforcement…

A: Calculating for service limit state: Dead load per unit length, WD=0.3*0.6(25)=4.5 KN/m Eccentric…

Steel Framing

A steel frame consists of a skeleton frame structure comprising of horizontal I-beams and vertical steel columns fitted in a rectangular grid building construction to brace the floors, walls, and the roof of the building held onto the frame. Due to the implementation of this methodology, the construction of the skyscrapers was feasible.