In the following structure, consisting of a rigid body DBC and a bar AB with a diameter of 24 mm, based on the applied force, determine: a. The normal stress in bar AB.  b. The shear stress of the bolt at B.  c. The shear stress of the bolt at C.

Q: ults in a differential element at the poin a a 0.5 m

A:

Q: 2.23. An aluminum right-circular cylinder surrounds a steel cylinder as shown in Fig. 2-40. The…

A: Summary:-So the stress is 9MPAExplanation:

Q: A strain gauge is mounted to the outer surface of a thin-walled boiler, as shown in Figure. The…

A:

Q: 1.3 Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Determine the…

A: Determine the magnitude of the force P for which the tensile stress in rod AB has the same magnitude…

Q: 2.28. The three bars shown in Fig. 2-45 support the vertical load of 5000 lb. The bars are all…

A: I have attached the image below Explanation:Step 1:Step 2:

Q: a. The beam weighs 3600N. Draw the V and M diagram. b. Assume we do not know the weight of the beam…

A: 1-If Beam weighs 3600 N then drawing of SFD and BMD2- if Beam Weighs is not know then finding of…

Q: 2. The mass of the homogenous bar AB as shown in the figure is 1069kg. The bar is supported by a pin…

A:

Q: 3 ksi S ksi iven the state of stress above (ignore 70° plane): calculate the maximum she ress,…

A: To find maximum shear and principal stress

Q: The column is subjected to an axial force of 8 kN, which is applied through the centroid of the…

A:

Q: For the element with stresses as shown below, find: . The magnitudes and directions of major and…

A: To determine-

Q: Part 2 * Your answer is incorrect. The z-component of momemt M will cause compression at A and B,…

A:

Q: A 52-kip force acts on a machine part at point A as shown below. The diagram shows the internal…

A: It is required to find the bending moment at the rectangular stress element.

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.