diagram 1in the figure. The arrows of the curve indicate the direction ofthe process, and the points of interest are labeled. The valuesfor the points in the diagram are shown in the table.W02=Volume (m³)Vo = 27.8V₁ = 21.4V₂ = 16.6V3 = 13.9V4 = 13.9V5= 9.55Calculate the amount of work done on the system from 0-2 (W02) and then for the entire curve from 0-5 (W05).W05 =IS SHOPressure (Pa)Po 1.37 x 104P₁ = 1.37 × 104P2= 6.18 x 10³P36.18 x 10³P4 = 2.50 x 10³P5 = 1.19 × 103JJPressure (Pa)2Volume (m³)10

As we know,Area under P-V curve is…

Answered: in the figure. The arrows of the curve…

Similar questions

Question B2i. Give an equation for the infinitesimal change in entropy, ??, of a system in terms of the heat transfer ??? and the temperature ? at which the heat transfer occurs. Explain the sign convention. ii. A litre of water at 20 °C is placed in a fridge at 5 °C. Calculate the change in entropy of the water, including the sign, once all the water has come into thermal equilibrium. iii. Calculate the change in entropy of the fridge from part ii, including the sign. iv. Demonstrate that the Second Law has been obeyed in the process described in ii and iii.
A piston has an external pressure of 8.00 barbar. How much work has been done in joules if the cylinder goes from a volume of 0.180 litres to 0.650 litres. Express your answer with the appropriate units. W=
Give the numerical answers as numerical values of the requested units (number only) to three significant figures. If necessary, use a period as a decimal separator. Consider an ice cube with a mass of 331 g. Ice is initially 0.0°C degrees and melts at 0.0°C into degradable water. The melted water is heated to a temperature of 56.5°C. What is entropy change (J/K)?
In the reaction cycle a gas is given in the PV diagram below. It was known that during the process from C to A, the system experienced a change in internal energy of–200 J.Meanwhile, from process A to B, the system absorbs heat by 180 J, while from B to C the system absorbs heat by 80 J. How much work is imposed on the gas for the process from A to B?
For the heat pump (used for heating) illustrated below, what is its coefficient of performance for heating. Ag? The gas is monatomic. p(Pa) 6 A. 8/3 B. 2 C. 11/3 D. 14/3 E. 19/7 2 V(m³) 34
please do D and E
The temperature at state A is 20.0°C, that is 293 K. During the last test, you have found the temperature at state D is 73.0 K and n = 164 moles for this monatomic ideal gas. What is the change in thermal energy for process A to D, in MJ (MegaJoules)? Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement. P (atm) 4 3 ID B +V (m) 4 5
A heat engine has 216 J of thermal energy as input and 167 J of thermal energy at output. What is its efficiency in percentage? Round to the first decimal place
When 2.1 kg of water at 12.3 °C is mixed with 3.7 kg of water at 39.7 °C in a well-insulated container, what is the change in entropy of the system? Part A Make an estimate. Express your answer to two significant figures and include the appropriate units. HÁ ? AS = Value Units Submit Request Answer Part B Use the integral AS = [dQ/T. Express your answer to two significant figures and include the appropriate units. HA AS = Value Units Submit Request Answer
during a cycle, an engine draws 3.50 x 10^3 j of energy from a hot reservoir and releases 2.25 x 10^3 of energy to a cold reservoir. a. how much work does the engine do in one cycle b. calculate the efficiency of the engine
A gas expands from I to F in the figure below. The energy added to the gas by heat is 212 J when the gas goes from I to F along the diagonal path. Three paths are plotted on a PV diagram, which has a horizontal axis labeled V (liters), and a vertical axis labeled P (atm). The green path starts at point I (2,4), extends vertically down to point B (2,1), then extends horizontally to point F (4,1). The blue path starts at point I (2,4), and extends down and to the right to end at point F (4,1). The orange path starts at point I (2,4), extends horizontally to the right to point A (4,4), then extends vertically down to end at point F (4,1). (a) What is the change in internal energy of the gas? Use the relations between various features of the graph and the work done on the gas to find the energy added by work and then use your result to find the change in internal energy of the gas. J(b) How much energy must be added to the gas by heat for the indirect path IAF to give the same change in…
A mixture of xenon and oxygen gas is compressed from a volume of 87.0 L to a volume of 81.0 L, while the pressure is held constant at 84.0 atm. Calculate the work done on the gas mixture. Be sure your answer has the correct sign (positive or negative) and the correct number of significant digits. KJ x10 X

SEE MORE QUESTIONS