In the figure shown below the water comes out of a tank and runs through pipe 1 (D1=10cm) that splits into two smaller pipes open to atmosphere (D2=3cm D3=6.5cm). The pressure shown in the tank manometer is 10kPa. Deermine the flow velocity in pipe 1 considering a perfect fluid.

Q: Jet of liquid (14 mm diameter) ejections vertically into the atmosphere. The pressure inside the jet…

A: Given data Diameter (d) = 14mm = 14x10-3 m Surface tension (σ) = 8.35x10-2 N/m

Q: What time (in second) is required to fill the circular tank with incompressible water from h= 2 m to…

A:

Q: (d) Water flows in two different horizontal pipes having a height difference of 55cm. A U- tube…

A:

Q: fluid passing a boundary of a system is 80,000 ft-lb. Determine the exit pressure if the inlet…

A:

Q: What is the Ah in the mercury differential manometer when the volumetric water flow in the gradual…

A:

Q: Open tank (4 m long, 3 m height and 3 m wide) contains liquid (S-0.8) to height 1.5 m. If this tank…

A:

Q: Q3. As we know, the pump power is proportional to the diameter and speed of the impeller, where P x…

A: Let the diameter of pump 1 is D1 and for pump 2 is D2. Speed of pump 1 is N1 and speed of pump 2 is…

Q: Create the simulation model of the 3-tank system shown in Figure. S= 0,25 m2 S0=0,00065 m2 H=0,2 m…

A: S=0.25m2S0=0.00065m2H=0.2mQ1=0.008m3/sQ2=0.005m3/sQ3=0.004m3/s Case-1 h10=1.2mh20=1mh30=0.7m

Q: A pump is installed in a pipe system, where at the suction side 1 m below the pump, an open…

A:

Q: image, a pressure change of 35 kPa in pressure of air occurs. Here the brine-mercury interface in…

A:

Q: ii. Water is rotated in a pump impeller at a speed of 1500 rpm. The inlet and outlet diameters are…

A:

Q: At point in a pipe that lay flat water in the pipe flows a at spced of S.0 mls and has gauge…

A: by continuity equation Area * Velocity = constantArea at the end of the pipe = 4 Area at the start…

Q: slug ) flows through the pipe system below. Data is given below: ft³ Pipe 1: V₁=1.8 ft, D₁=2.4…

A:

Q: a) Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in the…

A:

Q: garage lift has a 52 cm diameter piston supporting the load. Compressed air with a maximum pressure…

A:

Q: 1. In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing…

A: Given: The height of water in left column, hw,left = 4 cm The height of water in right column,…

Q: Mercury has a volumetric flow rate of 30m³/s. What volume of mercury has flowed after 1 minute?

A: Write the formula for the volume flow rate of mercury. Q=Vt Here, Q is the volume flow rate of…

Q: the gauge pressure at point B. Two reservoirs are connected by a pipe 40 cm diameter and 2000 m…

A: Upon the neglecting the minor losses  we know that pa=pc=0vA=VC=0 Applying the Bernoulli equation…

Q: water Hava Patm Şu h h Civa

A:

Q: In the system given in the figure, the top of the container and the pipe outlet are since it is…

A: Given- H = 151 m,h = 121 mD1 = 40 cm=0.4 m, D2 = 150 mm =0.15 m

Q: A trough with a trapezoidal cross-section, as shown in the figure, contains vegetable oil with…

A: An equation of the side AB is given by,Here, the end on which we need to find the hydrostatic force…

Q: Sometimes the simplest things in nature exhibit a stunning and elegant beauty. Consider the slow…

A: Given Data →Y1=0.26mY2=0mv1=2.0m/sr1=0.011m Part 1→ we need to find out the volume rate of flow…

Q: An incompressible fluid flows through a pipe without significant viscosity. It has a density of 124…

A: Given:r1=2.8 cm =0.028 mV1=13 m/sz1=0 mP1=103,763 Par2=3.87 cm =0.0387 mz2=5m

Q: 37. For a tank (T = 41 C°, volume = 0.051 m³, the rate change of density = 2.6 kg-m³-s*), through a…

A:

Q: If the acceleration of the tank with water in the figure is 18m / s ^ 2, what is the pressure at…

A: The diagram of the water level in case of acceleration in the x-direction, The angle is calculated…

Q: Water enters a fountain through a pipe with a cross-sectional area A₁ at a flowrate Q. The pressure…

A: Given:

Q: Problem (3) Find the rate of change of h(t) (mm/s) if water is the fluid at all locations. Use V₁ =…

A: given data  V1 = 7.2 m/s  Q3= 1000L/min find the rate of change of h(t) in mm/sec

Q: A pipe inclined at 45° to the horizontal (Fig. 2) converges over a length l of 2 m from a diameter…

A: According to the continuity equation, the product of fluid velocity and cross-section area of the…

Q: A Closed tank of water with Length, I = 20 ft Height, h = 10.45 ft %3D Width, w = 5.6 ft %3D Pgage =…

A: Given: Length of the tank→L=20 ft Height of the tank→h=10.45 ft Width of the tank→w=5.6 ft Because x…

Q: an airplane is flying at a 4000 m elevation where the temperature is -11C and the density of air is…

A:

Q: d) An incompressible fluid with density p is flowing through the duct system shown. You may assume…

A:

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively.  The center of the pipe…

A:

Q: 1. This figure shows three tanks that are connected to each other as a part of water storage…

A:

Q: Oil has SG of 0.853 and is flowing through a pipe with a constriction. A manometer with taps…

A: Given data:

Q: Inviscid water Flows as shown. The manometers heights are h1=102.3 cm, and h23D20 cm, what is the…

A:

Q: Q2: The discharge of water inside the pipe is 1 liter/s, the diameter and roughness of the pipe is…

A: Given:Discharge,Q=1litres=1×10-3m3sDiameter of pipe,d=40mm=0.04mRoughness of…

Q: 3. In the figure, ideal fluid (water) flow from the infinity large basin through the atmosphere.…

A:

Q: with oil (ρoil = 900 kg/m3) up to 1 m of its height. It is 3m wide, 2m high and 10 m long. Find the…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.