In the figure shown, assume that a 21.3-mm-diameter rivet joins the plates that are each 118 mm wide. The allowable stresses are 119 MPafor bearing in the plate material and 54 MPa for shearing of the rivet. Determine the minimum thickness of each plate. (Answer must be in millimeters) Round your answer to 2 decimal places.

Q: The bar 1 consists of an aluminum cover and a brass core. The data is presented in the table.…

A: Please refer explanationExplanation:Step 1: Step 2: Step 3: Step 4:

Q: steel tube. Total axial deformation is 1 hat is the compressive load, P? Assume: uter dia. =1" nner…

A: Given data :Length of member (L)=20inAxial deformation = 0.5inModulus of elasticity of the steel is…

Q: I section steel profile is not symmetrical as shown. If the tensile stress on the upper side of the…

A:

Q: A T 200 mm 200 mm H |В G -300 mm- C F 200 mm D 300 mm E

A: given - A beam with yielding wires  to find - average normal strain in  a. AH b. CG c. DF

Q: Draw the V&M diagrams and calculate the largest permissible value of P for the beam and loading…

A: Allowable normal stress in tension=-80MPa Allowable normal stress in Compression=-140MPa To find…

Q: What force is required to punch a 21-mm-diameter hole in a plate that is 23.8 mm thick? The shear…

A:

Q: 6.6 Problem: A bracket shown in figure 6.6 is subjected to an eccentric load P acting at an…

A:

Q: What would be the temperature at which the bar will have a compressive stress of 3 MPa given that at…

A: Elongation due to temperature change δT=Lα(ΔT)ΔT=T2-T1=T2-(-20)=T2+20

Q: The truss is made of three A-36 steel members, each having a cross-sectional area of 400 mm². ▼ Part…

A: Given:Cross sectional area = To find:The magnitude P

Q: Two A36 16mm thick steel plates are connected by four rivets shown. 50 0 Pu 50

A: for A36fy=250MPafu=410Mpadesign strength for tension failure on gross…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.