In the figure (a) shown, fluid A is alcohol with SG = 0.79, fluid B is mercury, z = 450 mm, y = 900 mm x = 200 mm . Compute the pressure difference between m and n. FLUID A FLUID A z = 450 FLUID B MERCURY a. -88.66 kPa b. -89.17 kPa C. -101.93 kPa d. -98.73 kPa

In the figure (a) shown, fluid A is alcohol with SG = 0.79, fluid B is mercury, z = 450 mm, y = 900 mm x = 200 mm . Compute the pressure difference between m and n. FLUID A FLUID A z = 450 FLUID B MERCURY a. -88.66 kPa b. -89.17 kPa C. -101.93 kPa d. -98.73 kPa

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1.- In the following figure the liquid of A and B is water and the liquid of the manometer is oil…

Q: The fluid is air (y = 12 N/m³) and the manometer fluid has a sp.gr of 0.827. Assuming no head…

Q: Problem 5: Hydrostatic Pressure Consider the swimming pool light fixture shown below. It has a…

A: Given data,D=Dia=15cm=0.15mR=radius=mz=depth=2.5mFINDvertical hydrostatic force (N)

Q: Two pipes A and B contain water and are connected by an inverted manometer as shown in figure below.…

Q: In the figure shown, determine the gage pressure at B when its absolute pressure is 290 kPa. Encode…

A: DETERMINATION OF GAUGE PRESSURE AT B ###

Q: Pipe Water Ah SG = 2.6 D = 30 mm Figure Q2 (a)

Q: 1. The gage pressure of the air in the tank shown in the figure below is measured to be 65 kPa.…

Q: Container has some fluid as shown in figure if container is moving with uniform velocity 10 m/s,…

A: Uniform velocity of container V=10 m/s, Pressures- PabsA=130 kPa&Patm=100 kPa. To Find- The…

Q: 2. Consider a double fluid manometer attached to an air pipe shown. determine the specific gravity…

Q: Initially, a U-tube manometer which is 12-mm in diameter contains a mercury with same height in its…

Q: Air at a temperature of 40°C flows through the duct at A with a velocity of 2.0 m/s. Pair = 1.127…

Q: The cylinder shown in the figure extends 9 ft into the paper. If the cylinder has the radius of 4…

Q: One side of the tank is open to the atmosphere and the other side is sealed with air above the…

A: To determine: gage pressure at various given locations of the water tank shown in the given figure…

Q: Q9: For the shown figure, what is the difference in pressure between points A, B? S.9. = 0.92 water…

A: To find pressure difference between point A and B

Q: pressure of air in the pipe

A: P=ρgh at any point Given h1=0.33mh2 =0.36mh3 =0.20m h4=0.50m h5 =0.10m h6 =0.30

Q: Consider an oil flow of 14 m³/h in a long, straight and smooth pipe with diameter of 4 cm. What is…

Q: In the figure below, a fluid with a specific gravity of 0.77 is flowing. The mass flow rate is…

A: Given data, Specific gravity = 0.77 Mass flow rate = 18.5 kg /s Diameter of nozzle = 4.87 cm θ =…

Q: 16. Fluid Flow through a Compression Chamber A compressible gas flows into and out of a compression…

Q: A vertical pipe is shown in figure 1 below. The pipe tapers from 50 mm in diameter to 25 mm in…

Q: A fluid of specific gravity 0.8 is flowing in a pipe. The pressure drop across a flow secti between…

A: specific gravity of fluid is 0.8

Q: An engineer sees a water flow through a 0.4 km long and 200 mm diameter pipe having a roughness of…

A: Given: Length of pipe Diameter Viscosity Discharge To find: Velocity Reynolds number Pressure drop

Q: A U-tube manometer is used to check the pressure of natural gas entering a furnace. One side of the…

Q: Consider the system shown in the figure. If a change of P kPa in the pressure of air causes the…

A: Given P= 35 kPa d= 7mm To find The ratio of A2/A1

Q: 1. The figure shows a tank discharging through a pipe witha nozzle at its end. Find the discharge…

Q: Estimate the velocity at point (2) and discharge of oil that as a petroleum engineer want to release…

A: Estimate the velocity at point 2,V2=?

Q: A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A…

A: Specific weight of fluid in manometer, γm=112lbft3The pressure drop between two taps, δP =0.7lbin2

Q: What is the difference in the heights of the two water columns? Assume that the glass is very smooth…

A: To determine the difference in height of the water columns. To solve the given problem, one must…

Q: The mercury manometer shown in (Figure 1) reads h = 0.28 in. Take Hg = 867 lb/ft³. % 57.4 lb/ft³,…

Q: Question 1 a) Figure Q1 (a) shows manometer connected a piston A. The piston A has diameter 0.1m…

A: Figure is as shown

Q: Figure shows below a Fluid 1 (SG = 0.88) and fluid 2 (SG = 2.93). If Pa = 98 kPa, determine the…

Q: meter consists of 8-mm diameter cylinder of length 20cm nd the mass of the sphere is 12.80g. At what…

Q: 3. Figure 3 shows a manometer being used to indicate the difference in pressure between two points…

Q: 100 пm mercury B OIL

Q: Determine the specific weight on each liquid by using the concept of P2 = P1+γh. Start with the…

Q: Question 13 In the illustration: A B 2 D All friction factorf = 0.02 All pipe lengths L = 250m…

A: This problem is related to pipe flow from Fluid Mechanics. In this problem given about Diameter and…

Q: Water in the pipe is shown in the figure. Determine the pressure at Point A in kPa(abs), to the…

A: Given Data for first question: Height of mercury=135 mm specific gravity of mercury=13.54 Height…

Q: vertical component of the hydrostatic force of

A: Dear students, here i am answering to this problem according to our guidelines Stpe-1 included…

Q: 6. A liquid having long. The head loss of the pipe due to friction is 22 m. a. Compute the friction…

A: Given the fluid flow through pipe with Reynolds number less than 2000. The flow is Laminar. So…

Q: c) The orifice flowmeter shown in Figure 4 is used to obtain the flowrate of oil inside a conduit.…

A: Given: d=1/3D, D=6cm, x=7cm, Pressure difference=25KPa, SG of oil=0.95, Cd=0.6 To calculate the flow…

Q: 4. The open tank shown in the figure have 2 piezometers attached on one side, containing two…

Q: oil (56 0.8) Patm - lol KR. For the shown figure, determine the pressure in gas pipe? Pgas =? 2,02 1…

A: Given:- The specific gravity of the oil = SG = 0.8 The atmospheric pressure = Patm = 101 kPa at 20o…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

In the figure (a) shown, fluid A is alcohol
with SG = 0.79, fluid B is mercury, z =
450 mm, y = 900 mm x = 200 mm .
Compute the pressure difference
between m and n.
FLUID A
FLUID A
z = 450
FLUID B
MERCURY
a. -88.66 kPa
b. -89.17 kPa
C. -101.93 kPa
d. -98.73 kPa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The cage system shown in the figure is made of EC rod. The Flow Limit of the material is 180 MPa and the Safety Coefficient is 4 is desired to be. Accordingly, the circular cross section EC rod Calculate the diameter.
A docs.google.com/forms/d/e/1FAlpQLSetk8UE/ PROBLEM 6: A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 260 kPa, determine the gage pressure of the gasoline line. Assume the density of air to be 1.225 kg/m3 * Oil SG = 0.79 P gage = 260 kPa Gasoline SG= 0.70 Pipe Air 45 cm 50 cm 22 cm 10 cm Mercury SG= 13.6 Water Your answer
show complete solution and diagram
I need the answer to the question in fluids
Paint issues from the tank at a flow rate of 45 ft^3/s. Find the kinetic viscosity in ft^2/s. Assume the flow is laminar. Note: In answering the question, it must be in exponential form but in the text box just write the value no need to include the x10^-1.. 9 ft L=6 ft d=in B Q
The gage pressure of the air in the tank shown in figure is measured to be 65 kPa. Determine the differential heighth of the mercury column. 65KPA Oil ŚG = 0.72 75cm Air Water Mercury SG - 13.6 30cm
A gasoline line is connected to a pressure gage through a double-U manometer, as shown. If the reading of the pressure gage is 40 psi, determine the gage pressure of the gasoline line. Assume the unit weight of air to be 0.0765 lb/ft3.
(Bernoulli/continuity/Pitot tube) Two Pitot tubes and two static pressure taps are placed in the pipe contraction shown in the figure below. The flowing fluid is water, and viscous effects are negligible. Determine the two manometer readings, h and H. V=1.7 ft/s h = H= 6.4 in. Air ↓ SG= 1.10 ft ft TH 3.8 in.
Paint issues from the tank at a flow rate of 45 ft^3/s. Find the kinetic viscosity in ft^2/s. Assume the flow is laminar. Note: In answering the question, it must be in exponential form but in the text box just write the value no need to include the x10^-1.. A 9 ft L = 6 ft d = 1/2 in ܪ e
A flow rate measuring device is installed in a horizontal pipe through which water is flowing. A U-tube manometer is connected to the pipe through pressure taps located 3 in. on either side of the device. The gage fluid in the manometer has a specific weight of 112 lb/ft3. Determine the differential reading of the manometer corresponding to a pressure drop between the taps of 0.5 lb/in². h = ft
Given The tank shown has one curved surface restraining a body of static fluid, with the following dimensions: w- 5.00 m h1 = 2.5 m R1 = 0.85 m Required Determine the value of x-bar in metres, to the nearest 1000th. Water hl R1
A glass 12 cm tall filled with water is invert the pressure at the closed end? Barometric pressure is 101.325 kPa. What is Ans. 100.15 kPaa Problem 2- 51 In Figure 13, in which fluid will a pressure of 700 kPa first be achieved? Ans: glycerin Proble Po 90 kPa A diffe water ethyl alcohol p= 773.3 kg/m³ mm, 1 betwe 60 m ol p= 899.6 kg/m 10 m water P= 979 kg/m' glycerin p = 1236 kg/m 5 m 5 m 2021/04/16 18:27