In the Figure 6, the absolute force value in the bar AB is (in kN): Figure 6: y 5 m/ A 20 kN 5 m 5 m B الاختيارات 10.55 O 11.55 O 9.55 O 8.55 O

Q: The picture attached shows a boom that supports the weight 2000 N. The boom is supported by the…

A:

Q: Problem 1 Two nozzles having diameters of 4 in (10.16 cm) and 6 in (15.24 cm), respectively,…

A:

Q: Among all the statements below about a 2D stress element, choose all which are true. Normal stress…

A:

Q: Consider the bracket shown in Fig-1. If: • F1 = 10 N@ 120° • F2 = 75 N@ -90° then, what is the…

A: Given: The force, F1 = 10 N The force, F2 = 75 N

Q: 3. Determine the tensions in cables AB, AC, and AD. 4 m Z 5m Y 5m 4m O 800 N B - 4 m 3 m 2 m X

A:

Q: 5. A person pulls on a rope with a force of 100 lbs as shown below. What is the moment about point A…

A:

Q: What total axial force can be generated by a pinnate muscle having the formand dimensions shown in…

A:

Q: Replace the three forces acting on the shaft by a singl resultant force. Suppose that F1 = 650 lb,…

A:

Q: Find the magnitude of the net torque on the wheel in Figure below about the axle through O, taking a…

A:

Q: If a 200 N force F1 is applied to the piston with the 4 cm diameter, what is the magnitude of the…

A: The step by step solution is provided below.

Q: Determine the magnitude and direction of each force. In the figure shown, a=7 in and F= 100 Ibf.…

A:

Q: (d) Figure Q.1(d) shows a 70 m tall tower is supported by three cables that exert forces FAB, FAC,…

A:

Q: Calculate forces (moments if applicable) for all points shown and write them down in a table.

A:

Q: In the Figure 3, if m=15 kg and 8=30°, then the weight component of the block parallel to the…

A:

Q: Three forces are applied to a screweye as depicted on the figure and table of parame Calculate the…

A:

Q: Variable F₁ d₁ d₂2 Values for the figure are given in the following table. Note the figure may not…

A: The beam is supported by rods AB and CD that have different cross-sectional areas. The area of rod…

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.