In the circuit shown in Fig. P6.42, current source I is 1.1 mA, and at 25°C vBE= 680 mV at iE= 1 mA. At 25°C with B=100, what currents flow in R1 and R2? R₂ 68 ΚΩ R₁ 6.8 ΚΑ www ww è +1₁ OE

Q: = A idence further results in T

A: We need to prove the given statement .

Q: Find equivalent capacitance in the circuit of the figure if all the capacitors are 4 uF.

A:

Q: 18) Find the equivalent inductance between terminals a and b of the circuit shown below. Ceq %3D…

A:

Q: # 26) The current through a 2.5 henries inductor is described by the waveform shown below. Sketch to…

A: Given,  L=2.5H i(t) = 6t20≤t≤2linear2s≤t≤4   We know that, the voltage across the inductor is given…

Q: Ceq ao bo 6pF 36 H m 72 H m (b) Find the equivalent inductance Leg in the following circuit. 7 pF a…

A:

Q: the square plates of a 5000pF capacitor measures 50 mm by 50 mm and are separated by a dielectric…

A: A capacitor is an electronic component that stores and releases electrical energy in an electrical…

Q: 12. 10x = 6.3x 10 the figure shows a simple RC circuit consisting of a 100-V battery in series with…

A:

Q: 3.) A power supply circuit is shown below. For the diodes, assume Vy = 0.7V. Sketch the output…

A:

Q: 4. Six capacitors are connected as shown in the figure. Ci V (a) If Cs-2.30nF, what does C: have to…

A: Given                      C3 =2.30 nFC4 =1.30 nFC5 =1.70 nFC6 =4.70 nF C2+C3 =5 nFC1×C2+C3C1+C2+C3…

Q: A resistor of 20ohms and a capacitance of unknown value when connected in parallel across a 100V,…

A: A resistor of 20 Ohms and a capacitance of unknown value when connected in parallel across a 100 V,…

Q: In the figure a 17 V battery is connected across capacitors of capacitances C1 = C6 = 5.0 µF and C3…

A: given

Q: 5. A series combination of an 18.0 mF capacitor and a resistor are connected to a 125 V battery.…

A: From the given information we can draw the circuit as

Q: help filling out the data using the circuit pls

A: Given R=2 kΩ C=9.9 μF V=10 V We have to find different parameters as mentioned in given table

Q: 1. You are an electrician working in an industrial plant. You discover the problem with a certain…

A: Given that: In an industrial plant, a machine has a defective capacitor and its rating is 10 μF and…

Q: 40. Three capacitors, a 12 µF, a 20 µF, and a 30 µF, are connected in parallel to a 400-Hz source.…

A: In this question we will find reactance...

Q: In the figure a 27 V battery is connected across capacitors of capacitances C₁ = C6 = 4.5 µF and =…

A: For the given capacitance circuit, the value of total capacitance, charge across the total…

Q: What values of capacitance can be obtained by interconnecting a c1-4-uF capacitor, a c2= 6-µF…

A: We need to find out the equivalent capacitance for the given circuit.

Q: The R-L Circuit: An inductor with an inductance of 2.50 H and a resistance of 7.00 n is connected to…

A: given that the R-L circuit hasinductance L  = 2.5 Hresistance R2 = 7 ohmsinternal resistance R1 =…

Q: Q6. Explain why an a.c capacitor that is working in an a.c circuit will get hot, whereas a d.c…

A: AC Capacitor in an AC CircuitReactive Power: Each cycle of AC voltage causes the capacitor to absorb…

Q: In the circuit shown in the following figure(Figure 1) the capacitor has capacitance 17 µF and is…

A: The voltage across the capacitor in the circuit can be written as vct=ε1-e-t/τ Volt, where the time…

Gradient of a Scalar Field

Consider a room or a place where the temperature is denoted by a scalar field T, such that at each point (x, y, z), the temperature is given as T(x, y, z). It is independent of time, in which the temperature rises most quickly. The gradient of T will show the direction at that point by moving away from (x, y, z). How far will the rise in temperature in that direction be determined by the gradient magnitude? Consider a surface that has a height above sea level at point (x, y) which is given by H(x, y). At that point, pointing in the direction of the steepest slope or grade is the gradient of H. The magnitude of the gradient of the vector gives the steepness of the slope at that point. How a scalar field changes in another direction can be measured by the gradient by taking a dot product rather than just the direction of the greatest change?