In the casting of steel in the sand mold conditions, the mold constant in Chvorinov's rule is given 3.0 min/cm2. The cast is a square plate whose thickness is twice its width and contains a square hole whose width is half the width of the plate. The hardening time of the riser increases by 30 seconds than the hardening time of the cast. The dimensions of the cylinder riser are 7cm in diameter and 10cm high. What are the dimensions of the product?

In the casting of steel in the sand mold conditions, the mold constant in Chvorinov's rule is given 3.0 min/cm2. The cast is a square plate whose thickness is twice its width and contains a square hole whose width is half the width of the plate. The hardening time of the riser increases by 30 seconds than the hardening time of the cast. The dimensions of the cylinder riser are 7cm in diameter and 10cm high. What are the dimensions of the product?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

In casting experiments performed during a certain alloy and type of sand mould it took 155 second for a cube shaped casting to solidify. The cube was 50 mm on a side. (i) Determine the value of the mould constant in Chvorinov's Rule. (ii) If the same alloy and mould type were used, find the total solidification time for cylindrical casting in which the diameter D = 30 mm and length L = 50 mm. %3D
12:37 ◄ Search A cylindrical riser with diameter-to-length ratio=1.5 is to be designed for a sand casting mold. The casting geometry is illustrated in Figure below. If the mold constant = 19.5 min/in² in Chvorinov's Rule, determine the dimensions of the riser so that the riser will take 0.75 minute longer to freeze than the casting itself. 3.50 inches 12+0.05 inch 0.5 inch 1.4 inch R-20 inch R=1.0 inch 18 inches 05 inch- X 10.375 inch
Determine the time required to fill the mold cavity along with the riser as shown in the following figure.
1. A square section riser be designed for a sand-casting mold. The casting itself is a quarter-cylinder with a diameter of 12cm and a length 20cm. The total solidification time for this casting 0.9 min. The square for the riser will have a height-to-width ratio of 2.0. Determine the dimensions of the riser so that it is total solidification time = 1.2 min. %3D %3D
why is the feeder used in the casting process? what is its significance and how should it be designed? Interpret by drawing in the figure.
11)Q2. Identify the casting process in which the molten metal is injected in mold/die at high pressure and explain its working principle along with a neat diagram.
8
Draw the fallowing in cubic system :- (020) ,(222) , (101) , (201) , (111)
Molten zinc is used in a molding process. It is poured through an inlet whose area is 7,5 m2, The head of metal of pouring basin height is 3 m, and the head of metal of pouring basin plus sprue is 2 m. What would you recommend to be the maximum area of the exit location of the sprue?
i need the answer quickly
Solve briefly otherwise skip it
Q2 /A/ In casting experiments performed using a certain alloy and type of sand mold, casting made of steel with shape as disk, with diameter =700mm and 30mm thickness , it took 20sec for a solidify Determine the value of the mold constant in Chvorinov's rule