In the 4- legged intersection, if G1-11.31 sec, G2 1.2 min, G3 =58 sec, N1= 100, N2 = 560 pce/lane, N3 = 448 pce/lane, and N4 =%3D495 pce/lane, then G4 =%3DOa. 44 secO b. 36 secOc. 29 secO d. None of the given answersO e 40 secOf 32 sec

Data Given: G1 = 11.31 sec.G2 = 1.2 min. = (1.2 × 60) = 72b sec.G3 = 58 Sec.N1 = 100N2 = 560…

In the 4- legged intersection, if G1=11.31 sec, G2 1.2 min., G3 = 58 sec, N1= 100, N2 = 560 pce/lane, N3 = 448 pce/lane, and N4 = 495 pce/lane, then G4 = %3D O a. 44 sec O b. 36 sec O c. 29 sec O d. None of the given answers 40 sec 32 sec

In the 4- legged intersection, if G1=11.31 sec, G2 1.2 min., G3 = 58 sec, N1= 100, N2 = 560 pce/lane, N3 = 448 pce/lane, and N4 = 495 pce/lane, then G4 = %3D O a. 44 sec O b. 36 sec O c. 29 sec O d. None of the given answers 40 sec 32 sec

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The design speed of an undivided road is 80 km/h. What is the overtaking time (in second) if there…

Q: H.W) Consider the tabulated design intersection data below, Compute the number of queued vehicles…

A: Traffic flows study travelers' relationships with infrastructure (even roads, road signs and traffic…

Q: Consider the tabulated design intersection data and based on Webster method, then the number of…

Q: 1. Use CLV analysis approach to determine the LOS and v/c ratio of the intersection (usually…

A: Given,

Q: Based on the table below which represents 5-minutes stopped-time delay data at a specific…

Q: The table below show 4hr U.H. drive 12hr U.H by using S-Curve? Time (hr) 04 8 12 16 20 24 28 32 36…

A: Given A 4 HR unit hydrograph ordinates Required 12 HR unit hydrograph using s curve method

Q: signalized intersection approach has an upgrade of 4%. The total width of the cross street is 60 ft.…

Q: Q3- For the traffic signal data below; 1- Fill the table with Data. 2 - calculate optimum cycle…

A: Phases Yellow Time (sec) All Red time (sec) Lost time (s) Geff (sec) Green time (sec) Red time (sec)…

Q: Based on the following traffic speed frequency table, the median and 85th percentile speeds are…

A: Given - speed - frequency Calculate - - the median -85th…

Q: Consider the tabulated design intersection data and based on Webster method, then the number of…

A: Given:- The tabulated design intersection data based on the Webster method is given The saturation…

Q: turn 640 t turn 300 pugh 920

A: Given:- traffic olume summary of T-intersection To find:- intersection diagram

Q: A- For the traffic signal data below : calculate Green Time (GT) and Red Time (RT) for each phase…

A: A phase is generally a green interval added with the change and clearance intervals that follow it.…

Q: highway of (- 4%) grade. The design speed (48mile/hr.), (f = 0.30), (t = 2.50 Sec.). The stopping…

A: Given : Highway gradient = -4% Design Speed = 48 mile/hour or 21.45 kmph OR 70.4 ft/sec f=0.30…

Q: If there is no pedestrian traffic, the yellow interval needed by northbound vehicles to clear the…

A: Approach speed- 35 mphTo find- Yellow interval

Q: 4- The design speed of an undivided road is 80 km/h. What is the overtaking time (in second) if…

A: Introduction : Overtaking distance : Overtaking Sight distance is the least distance required by a…

Q: Problem 4: intersection. AAssume a full-actuated control with unit extension (passage time, PT) of 4…

A: Level-of-Service (LOS) : The notion of a traffic facility's Level-of-Service (LOS) was created to…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

Q: Q4: a. At a certain at grade intersection, it's decided to use a 4 phases traffic signal for the…

Q: An signalized intersection located in Baghdad Capital with four phases, if EYi=0.77, lost time for…

A: Webster method: It is the most rationalized method for desigining traffic signal; in this method,…

Q: 5. Design signal for the intersection shown in Figure 1. Assume no pedestrian activity. Assume amber…

Q: Consider the tabulated intersection design data below, then the number of vehicles stopped during…

A: Traffic can be very high in such an area where the highway meets due to the amount of more vehicles.…

Q: You are assigned to evaluate the level of service for a section of a that stretches along a level…

A: According to given data You are assigned to evaluate the level of service for a section of a…

Q: if the distance is (1000) ft and the travel time is (18.9) second, then the . space mean speed is…

A: The space-mean speed is the average speed of vehicles traveling a given segment of the roadway…

Q: QI: A traffic signal control is being designed for a four-leg intersection on a divided highway with…

A: Step 1

Q: For the through movement of the north-bound approach, what is the minimum change and clearance…

A: Given; Travel speed = 45 mph A geometric layout with a +3% upgrade = +0.03 And a semi truck with a…

Q: Consider the tabulated intersection design data below, then the number of vehicles stopped during…

A: Webster's method procedure This method of traffic signal design is an analytical approach of…

Q: SHOW FULL SOLUTION

A: Given data are- Movements and their approaches: North, South, East, West.Directions: Through +…

Q: dz with equal effective green % left tuming =30. show the following for one of the approaches: A…

A: Given:- cycle time=114sec % left turning =30 width of approach=12m %left turning=30 To find:- a)…

Q: Condition: Left lane must turn left A Condition: Left lane must turn left

Q: Compute the minimum passing sight distance forthe following data. Speed of passing car – 90kph Speed…

A: Given:- The speed of passing car = 90kph The speed of overtaken vehicle = 80 kph The time of initial…

Q: Given the following information about a coordinated signal system, calculate the queue length for an…

A: Coordinated signal : It is important to facilitate the green time for signals that are packed…

Q: A signalized intersection has two lane groups. The two WBT lanes (lane group #1) have a total volume…

Q: Basis of speed limit:

A: Speed limit is the maximum limit above which vehicle is not allowed

Q: An intersection has a four-phase signal with the movements allowed in each phase and corresponding…

A: Terms used in given question q = normal flow S = saturation floe Critical ratio (y) = q/s Total…

Q: what could happen if this section of road way provided a sight distance of (500)ft V=(70)mph , if…

Q: On a two-lane intersection approach, following traffic queue data were observed. Clock Time | Cycle…

A: Number of lane, N=2 Free flow speed, FFS=35 kmph Survey count interval, Is=20 sec Total vehicle in…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

A: Given Data: The number of phases is 3. The lost time per second is 4 seconds. The v/c ratio for the…

Q: What is the calculated stopping sight distance (ft) for a -3% grade when the design speed is 55 mph,…

Concept explainers

Drainage of Pavements

Pavement Drainage holds ample significance, as it prevents the accumulation of water or any liquid on the surface of pavements and ensures proper drainage system. With proper design and gradual slopes provided, the water gets easily removed from the surface into the drains, which are essential during heavy rains and unusual weather conditions keeping it less prone to accidents and increasing the durability of the pavement structure.

Question

In the 4- legged intersection, if G1-11.31 sec, G2 1.2 min, G3 =
58 sec, N1= 100, N2 = 560 pce/lane, N3 = 448 pce/lane, and N4 =
%3D
495 pce/lane, then G4 =
%3D
Oa. 44 sec
O b. 36 sec
Oc. 29 sec
O d. None of the given answers
O e 40 sec
Of 32 sec

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Interpretation of data:

VIEW

Step 2 Calculations for G4

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

None
QUESTION 3 What is the intersection sight distance (ft) needed at a yield controlled intersection for a passenger car to turn left onto a 2- way, 2-lane road with a design speed of 50 mph? [round to the nearest foot]
Subject : Transportation engineering Please give me right solution according to the question...
QUESTION 4 What is the intersection sight distance (ft) needed at a yield controlled intersection for a passenger car to turn right onto a 2- way, 2-lane road with a design speed of 50 mph? [round to the nearest foot]
7 please help will upvote
Traffic engineering ضننذ
Question An four lane road with a conarete median separating directions of travel is built in SL.Jbhn's, NL and has a posted sped limit of 60 km/h. What is the classification? Liten 0 BAUTO D UAD7O 3UADSO 04 RAD6O
Observers stationed at two sections XX and YY, 1000 ft apart on a highway, record the arrival times of four vehicles as shown in the table below. Vehicle Section XX Section YY A T0 T0 + 14.33 sec B T0 + 3.76 sec T0 + 18.14 sec C T0 + 7.94 sec T0 + 22.06 sec D T0 + 12.13 sec T0 + 27.87 sec If the total time of observation at XX was 20 sec, determine (a) the time mean speed, (b) the space mean speed, (c) the flow at section XX, and (d) the density on the highway
i need the answer quickly
A signalized intersection has four approaches. If the north, south, east, and west approaches have average control delays of 21, 25, 34, and 32 seconds, respectively, and their respective volumes are 198, 176, 265, and 303 pc/h, what is the intersection LOS? Group of answer choices LOS C LOS B LOS A LOS D
Q5 / a. Section road: length = 500 m, average travel time = 90 sec., average running time = 60 sec. and speed limit = 60 Km/hr. Find: fixed and operational delay. Q5 / b. Annual average daily traffic volume = 5000vpd and design hour volume = 750 vpd. Find k – factor and type of roadway. Q5 / c. Four vehicles (5.5, 5.6, 6.4, and 6.5) m long are distributed over length of freeway lane100m. Find Lane occupancy and Density.
Under what condition is a value of 1 assigned to the parameter I in the expression for the lane group delay calculation?