In case of emergency, the gas actuator is used to move a 65-kg block B by exploding a charge C near a pressurized cylinder of negligible mass. As a result of the explosion, the cylinder fractures and the released gas forces the front part of the cylinder, A, to move B forward, giving it a speed of 200 mm/s in 0.4 s. (Figure 1)

In case of emergency, the gas actuator is used to move a 65-kg block B by exploding a charge C near a pressurized cylinder of negligible mass. As a result of the explosion, the cylinder fractures and the released gas forces the front part of the cylinder, A, to move B forward, giving it a speed of 200 mm/s in 0.4 s. (Figure 1)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

given the figure below determine the velovity in (fps) of block A as it hits the surface B
Please display all steps
Question 3: Objects A and B are connected by a rope with fixed length of 7 ft. They start moving from rest at x = 0, being pulled by the constant 20-lb force. If the coefficient of kinetic friction 4 is 0.2 between both objects A, B and the contacting surface, what is the speed of object B when x = 4 ft? Neglect the friction at the pulley. WB= 20 lb B 3 ft x = 4 ft 20 lb W 12 lb
Two masses, m1 and m2, are each suspended on identical springs. They were displaced an equal distance from equilibrium position and were released simultaneously. They are both at position of initial displacement at the instant m1 has completed 5 cycles and m2 has completed 3 cycles. m1=3 kilograms, determine the mass of m2 in kg
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. Block D, initially at rest, having a W = 30 lbf , is supported within the system shown, with x = 13.2 ft. Neglecting the mass of the pulley and the cord on the system, determine the eventual height h after a force P = 60 lbf is applied to make the block rise by ∆sD = 0.625 ft at t = 2.5 s. NOTE: Use Force-Mass-Acceleration (FMA) Method.
A 4-lb collar can slide without friction along a horizontal rod and is in equilibrium at A when it is pushed 1 in. to the right and released from rest. The springs are undeformed when the collar is at A and the constant of each spring is 2800 lb/in. Determine the maximum velocity of the collar.
Question 4 Disk 2 (m₂=0.5 kg, r2 = 0.5 m) is at rest when disk 1 (m₁-0.5 kg, r₁=0.5 m) strikes it with a velocity of v₁ = 0.5 m/s (Figure 5). a) What are the magnitudes of velocities of disks 1 and 2 after the impact if e = 0.5? 0.5 m 2 12 Figure 5 1 ۲۱
ENGS1202 Question 2 A. Figure 2 below shows a ball launched at an angle of 35° to the horizontal from the edge of a cliff of height 100 m. v= 20 m/s 100 m range Figure 2 Determine: i. the maximum height reached by the ball above its launch point. ii. the time taken for the ball to hit the ground. iii. the range of the ball as indicated in Figure 2. iv. the velocity on impact.
Question 3 An uncontrolled 850 kg car strikes squarely a motorway crash cushion in which the car is brought to rest by successively crushing steel barrels. The length of the crash cushion is 4.6 m, and the magnitude Fof the force required to crush the barrels as a function of the distance x the car has moved into the cushion is given by (0 < a < (1
1. Which of the following has impulse/s that is/are NOT considered negligible during the impact of the sphere to member AB? I. Weight of Member ABC II. Weight of Sphere D III. Impact force between Sphere D and Member ABC IV. The reactions at pin B
A gas cylinder sliding off the ramp as shown in Figure, with a horizontal velocity of 46 m/s. If the height of the ramp is h =27 m from the floor, determine the time needed for the object to strike the floor and the range R where bags begin to pile up. "u" m/s C "R" m. "h" m.