Answered: In a Y-connected ac generator, each…

In a Y-connected ac generator, each phase voltage has a magnitude of 135 VRMS, then the magnitude of each line voltage is: Select one: O a. 270 Ob. 233.8 OC. 190.8 O d. 135

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.14MCQ: The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load...

See similar textbooks

Related questions

Q: Across what direct emf must an impedance coil having a resistance of 20 ohms and an inductance of…

A: given parameters are as follows.

Q: ductive or tor of the ower cons consume

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Problem 6: Given the circuit below, find the total complex, average, and reactive power absorbed by…

A: In this question, We need to determine the total complex power, average power and reactive power.…

Q: A sinusoidal source supplies 20 KVAR reactive power to load Z = 25075° Q. Determine the rms voltage.…

A: First find the impedance in rectangular coirdinates. Real part of impedance is resistance and…

Q: 8. The total power supplied to a balance delta load is found in the same way as for a balance wye…

Q: A SINGLE-PHASE 230 AC, 60 HZ POWER SUPPLY FEEDS A 2400 WATTS AIR CONDITIONING SYSTEM, WITH A POWER…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: Q.22: For the magnetically coupled circuit shown, find the voltage across (-J10Q) 10:00V 52 JS2 JSS…

A: The solution is given below

Q: a. Find the total impedance Z, in polar form b. Draw the impedance diagram c. Find the current I and…

A: As per guidelines we are supposed to solve only first 3 subparts but here I solved 4 subparts. Now I…

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: In the figure, an ac generator with emf E = Em sin wat, where Em = 24.5 V and wd = 381 rad/s, is…

Q: a. Find the total impedance Z, in polar form b. Draw the impedance diagram c. Find the current I and…

Q: 2.3. An inductive load consisting of R and X in series feeding from a 2400- supply absorbs 288 kW at…

Q: FY behavior of circuit elements in an AC circuit. An inductor behaves like a short circuit at high…

A: We need to choose correct option from following option - An induction behaves like a short circuit…

Question

In a Y-connected ac generator, each phase voltage has a magnitude of 135 VRMS, then the magnitude of each line voltage is:
Select one:
O a. 270
O b. 233.8
O c. 190.8
O d. 135

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single phase AC generator winding has an effective resistance of 0.2 ohm and synchronous reactance of 2.2 ohms. Find the generated emf when the load is 50A at a terminal voltage of 500 V at pf 0.8 leading.
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load under sinusoidal-steady-state excitation. is (a) Nonzero constant (b) Zero (c) Containing double-frequency components
The power factor for an inductive circuit (R-L load), in which the current lags the voltage, is said to be (a) Lagging (b) Leading (c) Zero
Consider a single-phase load with an applied voltage v(t)=150cos(t+10)volts and load current i(t)=5cos(t+50)A. (a) Determine the power triangle. (b) Find the power factor and specify whether it is lagging or leading. (c) Calculate the reactive power supplied by capacitors in parallel with the load that correct the power factor to 0.9 lagging.
A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
Is the power factor in Question 6 a leading or lagging power factor? Explain your answer.
A source supplies power to the following three loads connected in parallel: (1) a lighting load drawing 10kW. (2) an induction motor drawing 10kVA at 0.90 power factor lagging, and (3) a synchronous motor operating at 10hp,85 effIciency and 0.95 power factor leading (1hp=0.746kW). Determine the real, reactive, and apparent power delivered by the source. Also, draw the source power triangle.
BY
A load has a leading power factor. a) Is it a capacitive or inductive load? b) Is the reactive power positive or negative? c) Repeat for a load with lagging power factor
Q4 a) A three-phase system has a rms phase voltage of 6.3 kV. What is the line voltage?
A star connected three phase alternator supplies power to a delta connected resistive load. The alternator has a line voltage of 480V. Each resistor of delta load has 8 ohm of resistance. Find the following values. Line voltage of the load (VL(load)) Phase voltage of the load (VP(load)) Phase current of the load (IP(load)) Line current delivered by the alternator (IL(alt)) Phase current of the alternator (IP(Alt)) Phase voltage of the alternator (VP(Alt)) True power