In a water treatment, the temperature of water is 20°C. The diameter of the solid particles present in water is 0.05 mm and has specific gravity of 1.2. Determine the settling velocity of the particles if the kinematic viscosity of water is 1.01 cSt.

In a water treatment, the temperature of water is 20°C. The diameter of the solid particles present in water is 0.05 mm and has specific gravity of 1.2. Determine the settling velocity of the particles if the kinematic viscosity of water is 1.01 cSt.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A ground water with salinity (TDS) of 2850 mg/L is treated with reverse osmosis desalination process…

A: NOTE: As per our policy, we can solve only the first 3 sub-parts. Given Data: The groundwater with…

Q: If is na % air voids (Ratio of volume of air to Volume of soil), S is the saturation and n is the…

Q: Which of the following statements is true?

A: The design parameters of setting tank includes loading rate of solids, overflow rate, side water…

Q: 9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample…

A: Given data - bulk volume of sample = 100 cc Initial weight of saturated sample is 220 gm Increased…

Q: For a sample of water with the ionic composition shown below, the Carbonate and Non-carbonate…

A: given- Concentration of the ions as shown in the table-

Q: After an isocratic elution has been optimized with several solvents, the chromatogram has a…

A: There are basically two solvent delivery system in the gas chromatography technique First is…

Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…

A: "A given sludge with 98% moisture content is X times more bulky than with 95% moisture content."The…

Q: 1 The lower the water turbidity, the higher the allowable scour velocity in sedimentation tank.( ) 2…

A: 1 True - Lower water turbidity allows for higher allowable scour velocity as the particles in the…

Q: A water sample was examined and following observations were made: Species Concentration…

A: Given data,

Q: A water sample is tested to have an alkalinity of 300 mg/L as CaCO3. The Ca^2+ concentration is 120…

Q: for

A: OSTWALDS EQUATION:time=A×μρμ=viscosity=0.98poise=0.98×0.1 Nsecm2ρ=0.02gcc=20kgm3 A=?

Q: The water hardness in an area is reported as 700 ppm total dissolved solids. This is the same…

A: Hardness = 700 ppmWe need to convert the hardness from ppm to %

Q: For a sample of water with the ionic composition shown below, the Carbonate and Non-carbonate…

Q: diameter of 0.085 mm and a solid density of 2000 kg/m3 settle in a water solution. Solids have a…

Q: The average drag coefficient for a laminar boundary layer over a flat plate was obtained as 0.018.…

Q: Biochemical Oxygen Demand A water sample was incubated at 20 °C for 3 days and its BOD3…

A: Using formula to find ultimate BOD

Q: 6 Ydu will obtain 2.0 L of tap water for you water hardness test. The water hardness test uses a…

A: We will solve this question in step no. 2

Q: For a sample of water with the ionic composition shown below, the Carbonate and Non-carbonate…

A: Equivalent weight=( total weight) / valency Eq wt of CaCO3 = 100/2 = 50mg/l To find carbonate…

Q: oh of each phase in a two-phase specimen, how does phase boundary area vary with the shape of the…

A: Physical property differences between the two scenarios will vary depending on the material, the…

Q: AUF system reduces turbidity from 121 to 11 NTU. Which one of the following shows rejection? - 90 O…

A: Ultrafiltration (UF) It is a method of purifying water that involves pushing water against a…

Q: The alkalinity of a water sample is 120 mg/1 as CaCO3. pH of the water sample is found to be 9.…

Q: The particle size of the is .approximately (0.06 – 2) mm اخترأحد الخيارات a. Large particles…

A: The particule size of 0.06-2mm is typical sand which is a mechanical sedimentary rock of fine…

Q: (10) 7. Salt conservation in the ocean takes the form of a(ps) -v. (PS i). at Show that this reduces…

Q: 3.2 If an ion exchange water softener has 0.2 m' of ion-exchange resin with an exchange capacity of…

A: 3.2)

Q: Given a 2° standard gauge, the maximum speed of 160 km/h and the equilibrium superelevation as…

A: The given data are: Standard Gauge, D=2° equilibrium super elevation , V1=90 km/h Maximum speed , V2…

Q: A laboratory test on a suspension of a solid in a liquid gave the following information: 100 mm…

A: Given, critical time = 95 min Original height = 100 mm

Q: 1- Explain the procedure to find the total solid and what's the unit for it? 2- In total dissolved…

A: Procedure to find the total solids and it's unit.

Q: b. Based on concentration and the tendency of particles to interact, particle settling in a water or…

A: Note- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: Compute the velocity by which the particles of size 0.05mm will settle in water having kinematic…

A: Given: Diameter of particle, d = 0.05 mm Specific gravity of particle, Gs = 1.2 Kinematic viscosity,…

Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…

Q: OD of a wastewater sample is determined by incubating the BOD bottles at four different…

A: Ultimate BOD is independent of temperature.

Q: a) Write down the chemical equations for the reactions that take place in the DO test. b) Discuss…

A: Find:The chemical equations for the reactions that take place in the DO test. The environmental…

Q: Significance on relative concentration erro

A: Solution: The relative concentration error is useful when the things are being compared and…

Q: Consider particles in suspension and their settling behaviour at different concentrations select the…

Q: disk, drying the disk at 105°C, and igniting the residue by placing the dried sample in a muffle…

A: The volume of the sample, V = 30 mLmass of filter dish, mass of dish+ dry solid, mass of sish+…

Q: The pOH of a basic solution is 3.33. What is pH?

A: Given,POH of basic solution is 3.33

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Application of Differential Equation The number of bacteria in a culture is growing at a rate of 3000 e2t/5 per unit of time t. At t=0, the number of bacteria present was 7,500. Find the number present at t=5.
Boundary Layer Theory A thin flat plate having dimension 0.5 m x 0.7 m in size settles in a large tank of water with a terminal velocity of 0.12 m/s. The viscosity and density of water are given as 10-3 N-s/m² and 103 kg/m³. Then find the weight(N) of the plate? Given thickness of plate is negligible.
An analysis of water from a surface source yields the following results: Ions Concentration (mg/l) Ca +2 Mg +2 HCO3 SO²- 60 18 91.5 96 The temporary hardness (as CaCO3) and permanent hardness (as CaCO3) present in the water are
I need the answer as soon as possible
Pls show clear and complete solution ty
Salt conservation in the ocean takes the form of (sd)e ーマ-(oS ). | at Show that this reduces to as ージvs at
Estimate the terminal settling velocity in water at a temperature of 15°C of spherical silicon particles with specific gravity 2.4 and average diameter of 0.05mm. Assume p=999 kg/m3 and p= 0.00113 Ns/m2
For quiescent conditions determine the settling velocity of spheres in water as a function of particle diameter. Assume the particle density is 1050 kg/m³ and use a particle diameter range of 0.01 to 10 mm.
Pls ans soon
Consider particles in suspension and their settling behaviour at different concentrations select the correct statement(s). Type 1 settling is called discrete settling. Your option is Correct B Terminal velocity in suspension is achieved when drag force is balanced by gravity force. Your answer is IN-CORRECT Correct Option 24 In Type 1 settling, for Ree(100, 300) Cn = Re 3 +0.34 (Re = Reynold's number) VRe D In Type 2 settling, the velocity of floc does not remain terminal and keeps changing as the size of the floc changes. Your option is Correct
Mean size represents in a sieving analysis: O 80% of the finer, which is smaller than the particles with biggest density bulk O 50% of over size which, is smaller thana specific particle size 50% of the finer which, is bigger than a specific particle size Represents 50% of the smallest particie size. O 50% of the finer, which is smaller than the particles with biggest density real. O 50% of over size which, is bigger than a specific particle size. O 50% of the finer, which is smaller than the particles with biggest density bulk O Represents 50% of the biggest particle size. O 80% of over size which, is bigger than a specific particle size O 80% of the hiner, which is smaller than the particles with biggest density real
In a water treatment, the temperature of water is 20°C. The diameter of the solid particles present in water is 0.05 mm and have specific gravity of 1.2. Determine the settling velocity of the partiles if the kinematic viscosity of water is 1.01 cSt.