In 1980 wind turbines in Europe generated about 5 gigawatt-hours of energy. The amount of energy will increased by 59% per year. Estimate how many years it will take for 80 gigawatt-hours of energy to be generated?

In 1980 wind turbines in Europe generated about 5 gigawatt-hours of energy. The amount of energy will increased by 59% per year. Estimate how many years it will take for 80 gigawatt-hours of energy to be generated?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Related questions

Q: An energy meter revolves 190 revolutions of disc for a unit of energy. Find the number of…

A: Need to find the number of revolution for the given load conditions then find error

Q: Ques Mechanical energy is supplied to a d.c. at the 32.2 A at ROV. rode of 4200 Jls. The generator…

A: It is given that:Mechanical energy supplied = 4200 J/sCurrent (I) = 32.2 AVoltage (V) = 120 V

Q: The Upward wind and down wind velocity of a wind turbine are 12m/s and 5m/s respectively. What is…

A: Given: Downward wind velocity, Sd=5 m/s Upward wind velocity, Su=12 m/s

Q: Estimate the AEP for a 3-MW wind turbine in a wind regime that has a CF= 30%. For this turbine…

A: Different energy sources are required in day to day life. These energy sources can be renewable or…

Q: Discuss the importance of reactive power in power systems. How is it controlled, and what are the…

A: Reactive power is a critical component of electrical power systems, and its significance lies in…

Q: 10. With the increase in field excitation of a dc generator, its generator emf a. decreases b.…

A: In this question we need to choose a correct option.

Q: A three-phase synchronous generator with a nominal pole voltage of 3300 V, nominal apparent power of…

A: The objective of the question is to calculate the real power absorbed by the load during nominal…

Q: A generating station has a maximum demand of 30 MW, a load factor of 60% and a plant capacity factor…

A: maximum demand of 30 MW, a load factor of 60% plant capacity factor of 50 %. what is the reserve…

Q: power transformer has a core material with hysteresis coefficient of 120 J/m3. Its volume is 8000…

A: The formula to find out the hysterisis loss is straight forward Convert all the values to meter…

Q: Discuss the various methods and technologies used for power factor correction in industrial power…

A: The various methods and technologies used for power factor correction in industrial power systems.…

Q: Explain the concept of distributed energy resources (DERs) and their impact on the modern power…

A: Distributed Energy Resources (DERs) refer to a diverse set of small-scale, decentralized energy…

Q: Turbine operating efficiency is not influence to maintain the minimum cost of power generation True…

A: Turbine operating efficiency is an important parameter to maintain the minimum cost of power…

Q: 15

Q: Discuss the significance of power factor in an AC power system. How does power factor correction…

A: The power factor is a critical parameter in power distribution systems that measures the efficiency…

Q: Two alternators operating in parallel supply 2516 KW to a load at a lagging power factor of 80%If…

Q: How does power factor correction influence the efficiency of power systems, and what technologies…

A: Here we need to explain how does power factor correction influences the efficiency of power systems…

Q: The power converted from the wind into rotational energy in the turbine is 1.7 MW. Determine the…

A: To find the blade length( L ) Given Power P = 1.7 MW Wind speed v = 36 kmph Power coefficient Cp =…

Q: Question 2 A commercial wind turbine can convert 59% of the energy from the air hitting its rotor…

A: The maximum theoretical efficiency of the commercial wind turbine is 59%, also known as Betz Limit.…

Q: Discuss the different types of power generation methods used in modern power systems, including…

A: Here are some of the primary power generation methods used in modern power systems, along with their…

Q: Discuss the integration of renewable energy sources like wind and solar into the power grid. What…

A: Integrating renewable energy sources like wind and solar into the power grid is crucial for reducing…

Q: The wind turbines in the industry area in ... have a wing diameter of 90 meter. Derive the electric…

Q: A generating station has a maximum demand of 25,000 kW. Calculate the cost per unit generatedfrom…

A: Maximum demand=25000 kW Capital cost = P 120M Annual load factor = 45% Annual cost of fuel and oil =…

Q: If E = 1.05 p.u. leading by 25 degrees, feeding infinite bus bar through a reactance of 0.35. Find…

A: Simple problem on powrt system stability. Look below for solution:-

Q: The following data are given for a wind turbine: Blade length, l = 45 m Wind…

A: Wind power or wind energy is the process of harnessing the wind to generate mechanical or electrical…

Q: Wind-turbine units are rated at 8 KW in a rated wind speed of 22 m/s. The stage efficiencies are Cp…

Q: Wind-turbine units are rated at 6 KW in a rated wind speed of 8 m/s. The stage efficiencies are Cp =…

A: The efficiencies are cp = 0.32 ngb = 0.90 ng = 0.92 V = 8 m/s

Q: A5-MW steam turbine generator power plant has a full-load steam rate of 7.0 kg/KW-hr. Assuming…

A: The solution can be achieved as follows.

Q: A d.c. serier generator, having an external characteristic which is a straight line through zero to…

A: We have a DC series generator having an external characteristics which is straight line through 0 to…

Q: please write introduction of Power and Power factor in AC Circuits

A: We need to tell about the power and power factor in ac circuit

Q: former has the iron loss and full load c espectively. Determine the (i) Full load cy, (iii) Output…

Q: What is Energy crisis? What are the causes of energy crisis? Explain the consequences and possible…

A: The energy crisis is defined as the shortage of energy with respect to the demand. The energy crisis…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Substituting all the values in the formula

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the elements which contribute to the cost of the electricity? And discuss how the “load curves’ and ‘load duration curves’ can helpful in the economics of generation.
How does power factor affect electricity bills for industrial consumers, and what strategies can be employed to improve it?
Wind mill with 2 m diameter works on the principle of converting kinetic energy of the wind in to mechanical energy. If air density = 1.225 Kg. / m°wind speed 20 m/sec then power available from wind mill is 30787.6 w 30787.1 w 30787.3 w
The theoretical maximum efficiency of wind turbines is limited by the velocity of air leaving the turbine preventing air from entering the turbine. TRUE OR FALSE?
step down chopper has Vs = 230 V and R = 10 0. For a duty cycle of 0.4, the power taken by the chopper is 2097 Watts. Find the chopper efficiency. Take the voltage drop across the chopper switch as 2 V. a) 98 % b) 89.96 % c) 99.14 % d) 96.54 %
How do renewable energy sources, such as wind and solar, impact the operation and planning of power systems?
Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
A high-voltage direct-current generating station delivers 5 MW of power at 178 kV to a city, as depicted in Figure below. The city is represented by resistance R₁ and each of the two wires of the transmission line between the generating station and the city is represented by resistance RTL. The distance between the two locations is 1752 km and the transmission lines are made of 7 cm diameter copper wire. Determine how much power is consumed by the transmission line. Please enter your answer 2 decimal places and in terms of Watt. (for copper-1.72 x 10-8) Vo Station RTL RTL ww RL (city)
What is Energy crisis? What are the causes of energy crisis? Explain the consequences and possible solutions of the energy crisis.
In U.S. residences, electrical power is generally utilized at a nominal voltage of 120 V rms. What problems would become pronounced if the power distribution system and household appliances had been designed for a lower voltage (say, 12 V rms)? For a higher voltage (say, 12 kV)?
Explain the role of renewable energy sources, such as solar and wind power, in modern power systems. How does integrating renewable energy impact the operation and control of power grids?
What do you understand by Ferranti effect? Subject Power Transmission and Distribution