III. DETERMINE TOTAL AREA USING DMD METHOD. ,L = 11.25 mB =S 79° 41' EL = 9.20 mL = 6.40 mL = 9.25 mB =S 77° 28' WB =S 38° 39' wB = N 12° 31' EABD Show complete solution.Convert angles into degrees and minutes.Round off lengths to 3 decimal places.Do not forget the units.

Answered: Image /qna-images/answer/496284ee-8317-486a-a8b4-d5621944cd5e.jpg

Answered: III. DETERMINE TOTAL AREA USING DMD…

III. DETERMINE TOTAL AREA USING DMD METHOD. , L = 11.25 m L = 9.20 m L = 6.40 m L = 9.25 m B =S 79° 41' E B =S 77° 28' W B B =S 38° 39' w B = N 12° 31' E

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: In levelling across a wide river on Pampanga, a reciprocal level reading were taken between points B…

Q: Question 21 Provide the slope of water surface line in m/m. Section 1 water surface elevation = 80m…

Q: A closed traverse shown has the following data: LINES BEARING DISTANCE АВ S 15°36' W 24.22 m BC S…

A: Considering the above table and we have, Latitude=lcosθDeparture=lsinθ Lines Bearing Quadrat…

Q: Situation 2] A surveyor was tasked to cut off a required area by a line throi the process of…

Q: 3. The boundary of the water surface of a reservoir is shown by iregular outline KLMNOPQR. Soundings…

A: we have to determine a. Areas (sq.m.) of the cross-sections of ranges QK, PL, and OM. b. Volume…

Q: Using Theissen Polygon Method, calculate the average rainfall of the given section. 5km Skm Skm SI =…

Q: SITUATION 3. a) The base and altitude of a triangle lot were measured to have certain probable…

A: a) The base of a triangle, B = 314.60±0.16 The altitude of the triangle, H = 92.60±0.14 To…

Q: B) Based on the data given below, calculate the reduced levels of all points using rise and fall…

A: Given, point BS IS FS RL BM 0.92 783.21 A 0.412 1.382 B 2.165 C 3.23 1.63…

Q: Using Theissen Polygon Method, calculate the average rainfall of the given section. Skm Skm Skm SI =…

Q: Define the Effective Area Method (Meyerhoff, 1953) ?

A: When foundations are exposed to both moment and vertical loads, this is a common occurrence.…

Q: ecimal places) of hen the FS was ta o not include the hat is the elevatio eters - 3 decimal at…

A: to find elevation of TP1 and BM2

Q: A-Figure (1) shown the dividing a tract of land into two parts by a line between two Given the data…

A: Lattitude is measured in N-S direction Departure is measured in E-W direction Lets take A as…

Q: Three points A, B, and C are established in the surveying trat shown in Figure 3. It is required to…

A: In such cases Random line method is most suitable. AB is true direction of line and stations A and B…

Q: Benchmark A has an elevation of 437.596 m. What are the most probable values for B, C, D?

A: Solution:

Q: Find the total volume of the earth to be excavated up to elevation 5m. (red-elevation, blue=grid…

A: To find the total volume of earth to be excavated till an elevation of 5m

Q: 1) A field is bounded by an irregular hedge running between points E and F and three straight fences…

Q: Direct measurements of volume is rarely made in surveying. O a. Only true if computing earthworks O…

Q: Find qu Via Terzaghi's equeatioms: JE ア-132 m C =15 ka/m A=20° %3D D=3 m CirCular Shape

A: Foundation is the last supporting part of the structure known as substructure. Footing/foundation is…

Q: 6.34922 sq yd -3.7073 sq yd

A: Square yardage is a common area measurement in yards that are used in many fields.

Q: 3. If the total difference in elevation of BM4 and BMI is -5.1163 meters, find the value of Х.…

Q: Determine the most probable value of the elevation BM2. Route A: Distance from BM1 = 6.32 km and…

A: We have to find the value of most probable value of the elevation BM2.

Q: A 26m reach of a certain stream AB was selected with cross section shown below. At point A of the…

Q: A surveyor made 4 different routes of level from Point A to Point B. The elevation at A is 250 m and…

A: Most probable value means the mean value of given data . Given Elevation of point A = 250m Point A…

Q: determine the linear error of the closure.

A: Given Data - To Find - linear error of the closure.

Q: Calculate the invert level of the drain and reduce level underneath the bridge. Determine different…

A: The figure given in the question are as follows:

Q: D. Results and Discussion Points Distance Upper crosshair readings Lower crosshair Rod Intercept…

A: Rod Intercept is the difference in reading between upper crosshair and lower crosshair.

Q: A circular duct has a diameter of 0.74m. Find the equivalent width and height of rectangular duct…

A: ASKED: To determine the equivalent size of a rectangular duct for a given circular duct. Given,…

Q: 3. If the total difference in elevation of BM4 and BM1 is -5.1163 meters, find the value of X. Sta.…

Q: C. COMPUTATIONS: 1. Computing Stadia Intercept (S) and Stadia Interval Factor (K). a.) Stadia…

A: Given, Stadia Intercept= Upper Rod reading- Lower Rod reading Stadia Interval(K)= DistanceStadia…

Q: 7. Determine the best site using center of gravity technique Pasig Taguig Mandaluyong Makati Pasay…

Q: 34. Calculate the area by M.D method, if the value of m1, m2, m3 are given as 233.4 m, 12.78 m,…

Q: ne 5. What is the Elevation of BM₂ and TP₁? STA BM₁ BS 2.32 7 BM2 FS 1 2 3 4 TP. | 2.77 | 3.43 5 6…

A: To find out the elevation of BM2 and TP1.

Q: The RL of a point is 120 m and elevation of the instrument is 1 m. If a contour line of 119 m is to…

A: Given - RL of point = 120 m Elevation of the instrument (h) = 1 m Elevation of contour line from…

Q: For following Hydrology data, fit linear equation

A: Given: 18 905.7 6 120.66 1 12.86 3 40.5 1 12.86 20 1108.78 15 639.78 13 488.3 2…

Q: QUESTION 11 A cutting is to be formed on a section of a proposed road. Calculate the volume of cut…

A: To find volume of cut using end area method and prismoidal formula

Q: Problem 5: The sides of a rectangular field are 1193.6 ± 0.60 ft and 582.70 ± 0.40 ft respectively.…

Q: 1. Covert the following volumes to cubic metres: a. 18,192.66 yd³ b. 234,345.65 ft³ 1. Convert the…

A: i have consider it as a part of civil engineering because unit can be used in calculations…

Concept explainers

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.

Question

III. DETERMINE TOTAL AREA USING DMD METHOD. ,
L = 11.25 m
B =S 79° 41' E
L = 9.20 m
L = 6.40 m
L = 9.25 m
B =S 77° 28' W
B =S 38° 39' w
B = N 12° 31' E
A
B
D

Show complete solution.
Convert angles into degrees and minutes.
Round off lengths to 3 decimal places.
Do not forget the units.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The earthworks data of a proposed highway shown on the tabulated data. Length of economic haul = 450 m Stationing of limits of economic haul = 2+498.03 and 2+948.03 Stationing of limits of free haul 2+713.12 and 2+763.12 Free haul distance is 50 m. Assume the ground surface to be uniformly sloping. Area Station Cut Fill 2+440 50 m2 2+740 0. Balancing Point 70 m2 3+040 a) Compute the overhaul volume. b) Compute the volume of waste. c) Compute the volume of borrow.
Draw diagram with computed values.
I need a quick solution within 15 minutes With my best wishesTon.
Given the area of STA 1 + 260 is 140.55 sq.m., and the area of STA 1 + 300 is 143.48 sq.m. Find the volume of earth material for backfill by Prismoidal formula. Kindly put the complete solutions. a) 5681.60 cu.mb) 5680.73 cu.mc) 5680.60 cu.md) 5680.60 cu.m
Surveying
I need complete solutions please, thank you.
SURVEYING II Exercise 4.2.3 I Determine the reduced heights for ABC & d using the given tacheometric field book extract. The heights of A & E are 567.430m and 574.000m respectively. 430m and extract. The neigin From A B C D E To B A C B D C E D HI & MH HI= 1.630 1.690 HI= 1.650 1.500 1.780 HI= 1.750 2.030 1.210 HI= 1.640 1.630 2.250 HI= 1.760 1.420 Top Stadia 3.040 2.850 2.700 2.950 1.780 2.190 3.570 2.750 Bottom Stadia 0.340 0.160 0.870 1.140 0.650 1.100 0.950 0.100 Zenith Angle 86°16'38" 93°43'26" 92°36'20" 87°23'45" 87°15'25" 92°44'40" 90°18'40" 89°41'12"
22.) Line MN, 251m long, was paced five times by the surveyor and recorded as follows: Trial No. Distance 1 121 2 122 3 120 4 124 5 122 Another line OP was paced four times again with the following results: Trial No. Distance 1 122 2 314 3 311 4 322 Determine the actual length of line OP.
P1. Volume Computation using Contour Method The great Lake Buwis was surveyed by Engr. Guanzon. The bathymetric data was used to compute for the area enclosed by each contour line. From the figure below and the computed areas, solve for the ff: Area in km? 10,882.64 8,928.73 8,077.11 6,751.50 5,381.82 4,462.94 3,497.25 A1 A2 A1 A2 АЗ A3 A4 A4 А5 A5 A6 A6 5m A7 A7 * assume A7 is the bottom of the lake 10m 15m 20m 25m 30m 35m (a) Total Volume using Average End Area Method in m3 (b) Total Volume using Prismoidal Method in m3 (c) Difference between total volumes acquired from the two methods
Determine the value of discahrge through rectangular having area of channel 6 m2 and flow through channel 0.8 m/s
RISE AND FALL LEVELLING Reduce the following reading using rise and fall method. Point BS IS FS Rise Fall RL Corr. Adjusted FINAL Height HEIGHT + BM5 10 1,528 1,354 1546,915 1546,915 1,145 11 0,967 1,025 0,814 0,541 12 13 1,462 14 1,324 0,822 15 1,278 1,541 1,298 0,985 16 BM3 1,458 1550,00 1550,00
Civil, Rquired an right answer In a furrow irrigation system, the length of the furrow is 200 metres, the advance time is 240 minutes, and the advance equation is x = p * t_r r, where "p" and "r" are 8 and 0.7, respectively. The separations of the chosen stations from the furrow's starting are 40, 80, 120, 160, and 200 metres. (Using t as the minute and Z as the millimetre) Z = 5t 0.56 is the integrated infiltration equation. Establish the possibility for infiltration and the depth of water in the soil at each station. Determine deep percolation and runoff if the width of the furrow is 0.8 metres, the input discharge into the furrow is 1.5 litres per second, and the root depth is 90 millimetres.