If the impedance Z1 = 0 +j10 and the impedance Z2 = 10-j10 are connected in parallel, the equivalent impedance would be:10-j10 ohmsO A.10+j10 ohmsO B.O C. 20 +j10 ohmsNone of the other choices are correctD.OE.20 ohms

Given, Two impedance connected in parallel are, Z1=0+j10 ΩZ2=10-j10 Ω

If the impedance Z1 = 0 +j10 and the impedance Z2 = 10-j10 are connected in parallel, the equivalent impedance would be: 10-j10 ohms 10 +j10 ohms OA. OB. OC. 20 +j10 ohms O D. OE. None of the other choices are correct 20 ohms

If the impedance Z1 = 0 +j10 and the impedance Z2 = 10-j10 are connected in parallel, the equivalent impedance would be: 10-j10 ohms 10 +j10 ohms OA. OB. OC. 20 +j10 ohms O D. OE. None of the other choices are correct 20 ohms

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and…

A: In this question we will write relation between voltage and current and power factor ....Also find…

Q: 4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive…

A: Given A circuit of zero lagging power factor Power factor is defined as the cosine of angle…

Q: + R₁ 44444 R₂ MAMMA ми R5 или M R4 R6₂ AMA R7 www Rq www R8

Q: Determine the total impedance, current and voltage to each of the three impedances. Z1 = 6-j8 ; Z2=…

A: In this question we will find total impedance , current and voltages...

Q: find total equivalent resistance and reactance and total impedance transferred in primary side.

A: Given transformer circuit is - Given value of turn ratio is -

Q: If there is no fault, find the low power profile 1. Pr 2. QT 3. ST 4. pfr

A: The three-phase system is a cost-effective means to transmit large amounts of power across long…

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

Q: Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz ac supply. Z1…

A: Given Z1=6.25+j1.25Z2=5+j10Z3=5-jXc

Q: Two impedances Z1 and Z2 are connected in parallel. Find the equivalent impedance, if Z1 =7 +j3 ohm…

A: Given: Z1= 7+3j ohm Z2=17-13j ohm

Q: Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz ac supply. Z1…

Q: Manufacturers usually specify the impedances of machines and transformers in O Percent O Per-unit O…

A: Need to Find correct option

Q: Impedances are marked in perunit on a 100MVA. 100 KV base. The load at bus 2 is 52 16MW - 132 MVAR,…

A: In this question we need to find a bus voltage at bus 1 and bus 2 .

Q: Impedances Z2 and Z3 in parallel are in series with impedance Z1 across a 100 V, 50 Hz ac supply. Z1…

Q: Use the information below to answer questions 24 un The voltage across and the current through a…

Q: Two impedances, Z1 = 2+j6 N and Z2 = 6-j12 N are connected in series with a 220-V 60-Hz supply. At…

Q: 15. You are working on a power factor correction installation, and you notice with a clip-on ammeter…

Q: A star connected reflector supplies a delta connected load. The impedance of the load branch is (8 +…

Q: A 50 Hz high voltage Schering bridge is shown in the figure. The component parameters are as follows…

Q: Pa balanced sphase system the Sequeuce is Positive and'aline Valtage Voe=208-70V Fhe tot is balancet…

A: We convert the delta connected load to star to draw per phase equivalent circuit

Q: For the circuit of the following figure, if R=26 0, Zc=-J26 0, and ZL=J30 0, and if the value of the…

A: you know, S =VI* =P+jQ where S = complex power V = Supply voltage I = CURRENT…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: Explain current divider rule in ac circuits with two parallel impedances Z1 and Z2. Calculate the…

Q: Determine the impedance, Z2, that will result in the total impedance shown in figure below. Z2 ZT =…

A: If n number of resistor having resistance R1,R2.....................Rn is connected in series then…

Q: If the impedance Z1 = 0 + j10 and the impedance Z2 = 10 - j10 are connected in parallel, the…

Q: Three impedances, Z1 =1000•Q, Z2 =63.2518.43.2 and Z3 =1002-90•Q are connected in star. Convert the…

Q: Two impedances Z1 = 2+j4 & Z2 =R are connected in parallel. Find value of R so that power factor of…

A: Given impedances and power factor are - Z1=2+j4Z2=Rcosϕ=0.9Lagging Given that impedances are in…

Q: Two reactances 1+j2 and 2-j2 are connected in series. Which of them is inductive? What is the total…

Q: 3. Determine current I using superposition theorem. 8A (1) 1822 M 102 M I 2552 + loov

A: In this question, we need to determine the current I using the super position theorem. There are two…

Q: Using Figure 1, Vs 50V-15 339 Hz R1 1100 R2 100 -m XL1 320 HH XC1 700 R3 600 Figure 1 13 R4 400 XL2…

A: Here I am Solving first three subparts as per guide lines.

Q: Problem: Given wye connected source: Ia Ven Van Von Ib 6-j8Q2 6-1892 N 6-1892 I where V = 1200° V =…

Q: Impedances z₂ and z3 in parallel are in series with an impedance z₁ across a 100V,50Hz AC supply. Z₁…

A: For the above given question we need to calculate the value of current, power and XC at resonance.

Q: For the series circuits of the figure below, calculate the total impedance (Z). R1 =4 k2 XLI = 4 k2…

A: In the given circuit all the elements in the circuit are in series .then toal impedance is sum of…

Q: 34 Source Zue 30 Load Zu Source: Zan = Zbn = Zen = 0.1 + j1.5 Q Ean = 12020° v Ebn = 1502 - 143.13°…

Q: For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals…

A: “Since you have posted multiple sub parts,we will provide the solution only to the first three sub…

Q: The impedance Z1 = 6+j8, Z2 = 8 -j6 and Z3 = 10+j0 ohms measured at 50Hz from three branches of a…

A: Given:- Z1 = 6+j8 ohms , Z2 = 8 -j6 ohms Z3 = 10+j0 ohms V=100volt F=50Hz

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

If the impedance Z1 = 0 +j10 and the impedance Z2 = 10-j10 are connected in parallel, the equivalent impedance would be:
10-j10 ohms
O A.
10+j10 ohms
O B.
O C. 20 +j10 ohms
None of the other choices are correct
D.
OE.
20 ohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
6
Three impedance Za= (3+j4) ohms, Zc= (4-j4) ohms and Zr=0+j3 ohms are connected in parallel. Solve for the pf of the combination.
Three impedances, Z1 =10020.Q, Z2 =63.2518.43.2 and Z3 =1002-90•Q are connected in star. Convert the star to an equivalent delta connection. And draw the star network and also the equivalent of delta connection
Two impedances Z1 = 2 + j2 ohms and Z2 = 5cis(-45) ohms, if they will be in parallel, what would be the equivalent circuit impedance ? O 1.53 cis (-20.7) ohms 2.46 cis (-15.5) ohms 2.83 cis(18.5) O 14.14 cis (0) ohms
15. You are working on a power factor correction installation, and you notice with a clip-on ammeter as you add in capacitance the current drops, you add more capacitance and the current drops, you add more capacitance the current rises. How do you know when you are at unity power factor?
I need the answer as soon as possible
In the Anderson Bridge for the measurement of inductance, drive the equations of balance for the unknown impedance L1 and R2.
Two impedances, Z1 = 2+j6 N and Z2 = 6-j12 N are connected in series with a 220-V 60-Hz supply. At what frequency will the circuit act as a purely resistive load? O 84.85 Hz O 116.62 Hz O 82.46 Hz O 120 Hz
DC-AC Circuits Express R1 using Rx, Ry, and Rz when performing wye to delta conversion R3 Rx Rz R2 R1 Ry O A. (Rx+Ry)(Ry+Rz)(Rx+Rz) Rx В. RyRz Rx+Ry+Rz O C. Ry+Rz RXRYRZ O D. RXRYRZ Ry+Rz OE. RxRy+RyRz+RXRZ Rx
Solve the given problem. Round off your answers to 2 decimal places. Show your complete solution.
For the circuit of the following figure, if R=26 0, Zc=-J26 0, and ZL=J30 0, and if the value of the nodal voltage V is 1.743-27 47° V, find the value of the reactive power supplied by the 3L-41 V voltage source. Ze R 15/24 V E ZL 341 V a 0.0377 VAR b.00736 VAR C0.0471 VAR d. 0.0589 VAR le