If the battery in the circuit below is 10.44V, resistor R₁=72.74, and resistorR₂-17.330, what is the magnitude of the potential drop across resistor R₂?Please give your answer in units of Volts (V).R₂R₁AIBENote: It is understood that the unit of your answer is in Volts (V), however donot explicitly include units in your answer. Enter only a number. If you doenter a unit, your answer will be counted wrong.

Answered: Image /qna-images/answer/a2ddd2ea-7adb-4a92-9451-bc94accf3c84.jpg

If the battery in the circuit below is 10.44V, resistor R₁-72.74, and resistor R₂-17.330, what is the magnitude of the potential drop across resistor R₂? Please give your answer in units of Volts (V). R₂ R₁ A I ||+ E B

If the battery in the circuit below is 10.44V, resistor R₁-72.74, and resistor R₂-17.330, what is the magnitude of the potential drop across resistor R₂? Please give your answer in units of Volts (V). R₂ R₁ A I ||+ E B

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter10: Direct-current Circuits

Section: Chapter Questions

Problem 55P: An ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations...

See similar textbooks

Related questions

Q: Determine the potential difference, Va-VB, in the circuit segment shown below when / = 26 mA and Q =…

A: Apply Kirchhoff’s voltage law to calculate the potential difference.

Q: For the given circuit, find the equivalent capacitance. C1 = 6µF , C2 = 4µF, C3 = 9µF and C4 = 8µF.…

Q: In the circuit diagram below, R1 = 5.00 N, R2 = 10.0 N, R3 = 15.0 Q, C1 = 5.00 µF, C2 = 10.0 µF, and…

A: Given: The value of R1 is 5.00 Ω. The value of R2 is 10.0 Ω. The value of R3 is 15.0 Ω. The value of…

Q: Consider the circult below. The switch is first closed and after a long time passes, the switch is…

A: Given data: Time t=7×10-2s Voltage V = 20 V Resistances: R1=2 kΩR2=500 ΩR3=3 kΩ Capacitance: C=100…

Q: In the electric circuit shown in figure find the potential of point A with respect to point B (i.e…

Q: Each resistor in the three circuits in the drawing has the same resistance R, and the batteries have…

A: Given: Resistance R = 6 ohm Voltage v = 6 v

Q: a uncharged capacitor and a resistor are connected in series to a battery. If E-12.0 V, C-5.00 μF,…

Q: R2 В >I R1 I- A

Q: V2 R1 V R1 vì R3 A V3

A: R1 = 2.8 ohm R2 = 7.8 ohm R3 = 1 ohm V1 = 8 volts

Q: In the circuit, R= 30.0 kN and C = 0.100 µF. The capacitor is allowed to charge fully, and then the…

A: Given Resistance ,R = 30.0 kilo-ohm Capacitance,C = 0.1000uF X = 64.1 V RC = 3*103-6 = 3ms

Q: Question 1 Find Rab, where each resistance is 3 ohms. a o D bo www

A: “Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: C1 C3 C2

Q: What is the potential difference between points a and b in the circuit shown below for ε = 3 V: a R…

A: The Ohm's law a linear voltage (V) , Resistance (R) and current (I) relation is given byV = RI.

Question

If the battery in the circuit below is 10.44V, resistor R₁=72.74, and resistor
R₂-17.330, what is the magnitude of the potential drop across resistor R₂?
Please give your answer in units of Volts (V).
R₂
R₁
A
I
B
E
Note: It is understood that the unit of your answer is in Volts (V), however do
not explicitly include units in your answer. Enter only a number. If you do
enter a unit, your answer will be counted wrong.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A 160F capacitor charged to 450 V is dischargedthrough a 31.2k resistor, (a) Find the time constant.(b)Calculate the temperature increase of the resistor, given that its mass is 2.50 g and its specific heat is 1.67kJ/kg °C,noting that most of the thermal energy is retained in the short time of the discharge, (c) Calculate the new resistance, assuming it is pure carbon. (d) Does this change in resistance seem significant?
Consider a circuit that consists of a real battery with an emf and an internal resistance of r connected to a variable resistor R. (a) In order for the terminal voltage of the battery to be equal to the emf of the battery, what should the resistance of the variable resistor be adjusted to? (b) In older to get the maximum current from the battery, what should the resistance variable resistor be adjusted to? (c) In order for the maximum power output of the battery to be reached, what should the resistance of the variable resistor be set to?
Using your understanding of the nature of internal energy and temperature, explain why we might expect the resistance of a solid to increase if its temperature increases.
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Six resistors, all having the same temperatures and compositions, are each attached to a battery with voltage V to form a simple circuit. The resistors have different lengths, l, but the same diameters. Rank the circuits according to the current that flows through the resistor from smallest to greatest. If two (or more) circuits have the same current flowing, give them the same ranking. Explain the rationale you used to establish your rankings. Circuit 1: l = 2 cm; V = 3 V Circuit 2: l = 2 cm; V = 6 V Circuit 3: l = 1 cm; V = 3 V Circuit 4: l = 1 cm; V = 6 V Circuit 5: l = 3cm; V = 2 V Circuit 6: l = 3cm; V = 6 V
Car bon-zinc dry cells (sometimes referred to as non- alkaline cells) have an emf of 1.54 V, and they are produced as single cells or in various combinations to form other voltages. (a) How many 1.54-V cells are needed to make the common 9-V battery used in many small electronic devices? (b)What is the actual emf of the approximately 9-V battery? (c) Discuss how internal resistance in the series connection of cells will affect the terminal voltage of this approximately 9-V battery.
In Figure 21.41. does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
(a) What is the resistance of a 1.00 102-O, a 2.50-k O, and a 4.00-kresistor connected in series? (b) In parallel?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
Consider the circuit shown in Figure P28.21 on page 860. (a) Find the voltage across the 3.00-0 resistor, (b) Find the current in the 3.00-12 resistor.