"I need proof in the solution and a supported source with the solution." a. Write an 8086-microprocessor program to clear bits 0 to 5, set bits 6 to 10 and complement bits 11 to 15 of word stored in a memory location 34000H. b. Write an 8086-microprocessor program to added number 5 to each number from (16 to 0) and then store in memory locations starting at the offset address of 3000H.

I need the solution, expert, to be correct with clarification. a. Write an 8086-microprocessor program to perform the result of the logical expression: BP (X₁ X2) + (X₁. X2), where X₁-01FFH, X2=AD58H: b. There are 30 data bytes are stored in memory location with offset address 3100H to 311EH. Write 8086 microprocessor program to transfer the block of data to new location with offset address 4201H to 421F

"Using emu8086 programming, I need two different solutions based on a source." write a program to move a block of 100 numbers consecutive bytes of data strings at offset address 8000 H in memory to another block of memory locations starting at offset address A000 H. assume that both blocks are in the same data segment value 3000H . Write an 8086 program that complements the first byte of flags register.

Solve in 8086 microprocessor

I need to solve the two branches with two different answers. Write an 8086-microprocessor program to clear bits 0 to 5, set bits 6 to 10 and complement bits 11 to 15 of word stored in a memory location 34000H. . Write an 8086-microprocessor program to added number 5 to each number from (16 to 0) and then store in memory locations starting at the offset address of 3000H. (2.5 marks)

02 (a) How many bits do the registers of the 8086 processor have and which registers can be split into halves and accessed separately? (b) Explain the purpose of segmenting memory" How is 20-bit memory address accessed by the processor? For a logical address (c) of OFS7:0552H. calculate the physical address and show the steps.

program to emu8086

Using the emu8086 program, I need to solve two points and explain the difference in the solutions between them. Question: Compute the physical address for the specified each of the following instructions. The register contents and as follows: (CS)=0A00H, (DS)=0B00Н, (DI)=00BOH, (BP)=00EAH and BX-2500H. 1) Destination operand of the instruction 2) Source operand of the instruction (IP)-0000H, (SS)=0D00H, LIST=00FOH, MOV LIST [BP+DI], AX MOV CL, [BX+200H] operand in variable are (SI)=OFFOH, AX=4020H,

2. A microprocessor has a memory space of 4 MB. Each memory address occupies one byte. a) What is the address bus size (number of bits needed for addressing) of this microprocessor? b) What is the range (lowest to highest, in hexadecimal) of the memory space for this microprocessor? c) Complete the memory map by the address ranges (lowest to highest, in hexadecimal) 8 bits for each memory chip. 0x 0x 0x 0x 0x 0x 0x 0x Address 0 1MB 1MB 1MB 1MB

Write an 8086 microprocessor program to transfer 20 words block of data from the first memory locations which is started with offset address of 2000H to the second memory locations which is started with offset address of 3000H. SI 1. The Intel 8086 microprocessor can read/write 16 bit data from or to a. I/O device b. register © memory d. processor 2. Which unit in the 8086 microprocessor is responsible for pre-fetching instructions from memory? a. EU b. ALU c. BIU 3. The memory of 1M byte size could be divided into a. twenty-one b. thirty-four d. CU Kbyte segments. d. sixty-four c. thirty-three 4. Which of the following programming statements is NOT a valid comparison operator in Arduino? a!(not equal to) b. < (less than) c. and (logical AND) d.=(equal to) 5. How many A/D converter inputs pins does port-E in the PIC16F877A ? a. 3-Pins b. 6-Pins c. 4-Pins d. 8-Pins d. 4Kx14 bits 5. How much the size of the program memory space in the PIC16F877A microcontroller? a. 32Kx8 bits b. 16Kx16…