A microprocessor has a memory space of 4 MB. Each memory address occupies one byte. a) What is the address bus size (number of bits needed for addressing) of this microprocessor? b) What is the range (lowest to highest, in hexadecimal) of the memory space for this microprocessor? c) Complete the memory map by the address ranges (lowest to highest, in hexadecimal) Address 8 bits for each memory chip. 0x 0x 0x Ox 0x 0x Ox 0x 0 1MB 1MB 1MB 1MB

A microprocessor has a memory space of 4 MB. Each memory address occupies one byte. a) What is the address bus size (number of bits needed for addressing) of this microprocessor? b) What is the range (lowest to highest, in hexadecimal) of the memory space for this microprocessor? c) Complete the memory map by the address ranges (lowest to highest, in hexadecimal) Address 8 bits for each memory chip. 0x 0x 0x Ox 0x 0x Ox 0x 0 1MB 1MB 1MB 1MB

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Design a program using the 8085 microprocessor assembly language that performs the following tasks: 1. Initialize register A with a value of OxFF. 2. Load a 16-bit value from memory location 2000H into register pair HL. 3. Subtract the value in register B from the value in register A. 4. Store the result in memory location 3000H. 5. If the result is negative, jump to memory location 4000H.
The instruction queue present in 8086 microprocessor is of bytes.
You buy a ROM memory chip that is 64Kx8. How many memory address lines does the chip have? A 16 B 64K C 512 D 8
17. Provide the starting and ending physical address values, in hexadecimal, for the entire 1/O register memory section for the ATmega2560. Beginning address = Ending address = 18. What are the differences between the standard and extended I/O register sections? 19. Provide the instructions needed to write one byte of data to an 1/O register in the 1) standard and 2) extended I/O register sections.
Fill in blank Consider multi-level page table with 22-bit memory addresses and 1 KB page size. The size of the entire page table will be ---------- (in decimal) bytes. Given a virtual address 1111000110000101001101 (in binary), the page directory index will be ----------- (in binary), and the page table index will be ----------(in binary).
Assume that the contents of 8086 microprocessor registers are: DS= 3300H, CS-1033H, SS= 1614H, SP= 1200H, and IP= 3400H. If the stack memory located at physical memory location 26130H, does the segment cover this range? If not, what changes need to be made?
1. Represent the decimal values 11 and -10 as 8-bit signed integers. Add the two binary representations. What is the binary result? What decimal value does that 2's complement result represent? 2. Perform the following arithmetic operation involving 8-bit binary integers. Give the result and CF and OF flag values for ARM microprocessors. Explain 01011011B + 01011011B 10011011B 01011001B
Q1) Write an assembly program to duplicate each memory location block (size N) starting at address 200h.
Question 4 a) Show the output waveform of a NAND gate with the inputs A, B, and C indicated in the figure below. A C b) A cache has been designed such that it has 1024 lines, with each line or block containing 8 words. Determine the line number, tag, and word position for the 20-bit address 3E9D216 using the direct mapping method. c) The table below represents 10 lines from a 256 line cache that uses direct mapping with a block size of 4 words. Identify the address of the shaded data (8C16). 3 Line# |Tag Word 00 Word 01 Word 10 Word 11 10 110101 12 34 56 78 01010154 l000111 29 32 6A D3 8C A2 BC 12 ED F3 3 001100 33 2C C8 14 110011 9A D8 FO
A two-way set associative cache memory uses blocks of four words. The cache can accommodate a total of 512 words from main memory. The main memory size is 4096 x 16 bits. Formulate all information required to construct the cache memory. How many bits are there in TAG, BLOCK (row) and WORD (column) fields?
For the 8085 microprocessor, the instruction (MVI B, 8-bit data) requires Fetch and Read machine cycles. What is the time in microseconds is required to execute it for a clock frequency of 3 MHz
Question: Assume a system comprises 16 GB physical memory with B KB page/frame sie and the instruction set comprises instructions that may need access to one (RET). two (PUSH AL or three (MOV A, B) memory locations to fetch the opcode and operands. Assuming that the system is configured with virtual memory: (a) What is the MINIMUM number of memory frames that must be allocated to a process running in the system? (b) What is the MAXIMUM number of memory frames that can be allocated to a process running in the system?