i) Determine the support reactions and ii) Sketch the axial load, shear force and bending moment diagrams. ,pin 16 kN 5 kN 16 kN D E 8 kN 5 kN B H HA 1.0 m | 2.0 m 3.0 m 3.0 m 3.0 m 2.0 m, 13.0 m 7.0 m 3.5 m 3.5 m 1.0 m 2.0 m 2.0 m 2.0 m 7.0 m

Q: Solve the following problems using method of joint and section. 1. A Fink roof truss is loaded as…

A: We have to determine the value of force in member DF, FE, and EG as per method of joint and section.…

Q: 3. Determine bar forces GE, GF, EF, ED, FD, and FB. Use the method of joints. D 25 KN 30° B 30 60°…

A:

Q: If the distance between E and Bis h= 0.3 m, calculate the maximum absolute values of the shear and…

A: Given Data  Find maximum absolute shear force and bending moment.

Q: If the allowable bearing stress for the material under the supports at A and B is Ob = 810 psi,…

A:

Q: Prob 3. The beam below has an allowable normal stress of oallow = 24 ksi and an allowable shear…

A:

Q: QUESTION 1: [Method of Sections] For the simple truss in figure Q1 below, Figure QI: Simple tras…

A: Given:-    To find: b To draw free Body Diagram;                  To find reactions  at support…

Q: P6-5. Sketch the bending stress distribution over each cross section. (a) M P6-5 (b)

A: Two members cross section are shown in the above figure. We have to draw bending stress distribution…

Q: Determine the force in member BD for the truss using the method of joints.

A:

Q: The maximum allowable tensile force in themembers of the truss is (Ft)max = 5 kN, and the…

A: The free body diagram of joint C is shown below. Consider the summation of force in vertical…

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.