I 2. Find the height of the cylinder if the shearing stress is 30 Pascal and the compressive stress is 80 Pa h T 15 inch L

Q: For the given state of plane stress in the r-y plane, determine (a) the maximum in-plane shear…

A:

Q: 4 The state of stress on an element at a point is described by the Figure shown. Stress magnitudes:…

A: The objective of the question.(a) Neatly sketch the Mohr's Circle, identifying the locations of the…

Q: Several forces are applied to the pipe assembly shown. Knowing that Q=250 lb and that the pipe has…

A:

Q: The state of stress at a point in a member is shown on the element. Solve the problem using the…

A:

Q: The tank of the air compressor is subjected to an internal pressure of 90 psi. If the internal…

A:

Q: Determine the equivalent state of stress if an element is oriented 60° clockwise from the element…

A: Given data: The orientation of the element is θ =-60 degrees. The normal stress along X axis is σx…

Q: 3. Calculate the normal stress and shear stresses acting at Point A. Clarify the direction of the…

A: The above approach entails applying material mechanics ideas to the issue of determining the normal…

Q: For the given state of stress, determine the planes with compressive normal stress equal to 15 MPa.…

A:

Q: BP2) A 6" diameter pulley attached to a 1" diameter shaft of 2" length is supporting a load of 2000…

A: Given,   We know that principle stresses are given by,   Which gives,

Q: Solve using Mohr's circle

A: For the given state of stress, To find: The normal and shearing stresses after the element has…

Q: The square deforms into the position shown by the dashed lines in. The dimensions are S=49 mm, S′=54…

A: Given data- S=49 mm, S′=54 mm, Δx1=5 mm, and Δx2=9 mmDetermine-A) the shear strain at A relative to…

Q: Two equal and opposite couples of magnitude M = 23 kN-m are applied to the channel-shaped beam AB.…

A:

Q: at each of those points. Write each state of stress in the form of a tensor, observing the z-y-…

A:

Q: Rods AB and BC have diameters of 4 mm and 6 mm, respectively. If the 3 kNforce is applied to the…

A:

Q: Question 2: The load binder is used to support a load. An external moment, MA is applied to the…

A:

Q: Take that w1 120 N/m and w2 = 180 N/m. W1 B, -6 m - 5 m Ľ. W2 Part A Replace the distributed loading…

A:

Q: The piece of steel shown was initially rectangular in shape. Determine the average shear strain…

A:

Q: Problem A person is doing leg exercises where a 100N weight linked via a pulley is attached to their…

A: Given: The weight linked with pulley:=100 N So the tension in the cable will be→T=100 N Weight of…

Q: Rods AB and BC have diameters of 4 mm and 6 mm, respectively. If the 3 kN force is applied to the…

A: Given, The diameter of AB(dAB) = 4 mm The diameter of BC(dBC) = 6 mm Load (P) = 3 kN For Member…