Heat transfer problem Water flows through a thin-walled cylindrical tube of diameter 1 cm, maintained at a uniform temperature, ?s = 360 K. The inlet and outlet temperature of water was found to be ?i= 280 K and ?o = 355 K, respectively. (a) What is the log mean temperature difference in this case? (b) If the mass flow rate is 0.005 kg/s, what is the total rate of heat transfer from th

Q: Saturated refrigerant 134a flows in the evaporator tube at 2 °C. The evaporator is made of thin…

A: Write the given data with suitable variables. T°=2 °Cd=1 cm=0.01 mD=2.5 cm=0.25 mT∞=25 °Ch=40…

Q: A DPHX is made of a 6-nom sch 40 commercial steel outer pipe and a 5-nomsch 40S stainless steel…

A: Heat Transfer: According to the second law of thermodynamics, heat is always transferred from a…

Q: Water at 27°C flows with a mean velocity of 1 m/s through a 1 km-long pipe of 0.25 m inside…

A:

Q: Consider the shell and tube heat exchanger where liquid A of density pa is flowing through the inner…

A:

Q: Water at 15°C (p = 999.1 kg/m3, cp 4.18 kJ/kg.K and u = 1.138E-3 kg/m. , k = 0.631 W/m.°C) is…

A: Solution:Given dataT1 = 15°cρ = 999.1 kg/m3cp = 4.18 kJ/kgkμ = 1.138×10-3 kg/msk =0.631 w/mCd =4.3…

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: Water flows in a 3.5-cm-diameter pipe so that the Reynolds number based on diameter is 2000 (laminar…

A:

Q: Water enters a tube of D=5-cm in diameter at Tm,=21°C with a flowrate of rm=0.18- kg/min. The tube…

A: for solution refer below images.

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: Liquid ammonia is transported from a production plant to a processing center via a 0.6-m diameter…

A: Introduction Given data: diameter of pipeD=0.6 mmass flow ratem=0.15 kg/ssurface…

Q: average temperature average flow velocity of m/s, Is flowing by pipeline with an inner diameter of…

A: Given DataTi=80°CV=0.5m/sd=35mm=0.035mL=15mTo=60°Cρ=840kg/m3η=0.233Pa.sλ=0.179W/mK

Q: 48. Water is flowing in a smooth pipe of diameter D. A section of this pipe hav- ing a length of L…

A: Given: length of the pipe=L and diameter of the pipe=D. And turbulent flow is there.

Q: A steam condenser is made of brass tubes,in., 14 gage. There are 150 tubes per pass. The cooling…

A: Given: Brass Tube 3/4'', 14 gage Number of tubes per pass, n=150 cooling water flow rate, v= 1.52…

Q: Liquid ammonia is transported from a production plant to a processing center via a 0.6-m diameter…

A:

Q: Engine oil (c_p%3D2100 J/(kg-K)) is heated from 25 °C to 70 °C. The oil flows at a rate 0.5kgsec in…

A:

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: . Corsidera circular soth pipeof inner diameter D;=0.015mwhose inner surface is covered with a layer…

A: GIVEN: INNER DIAMETER OF PIPE,D=0.015m FREE STREAM VELOCITY, V=1.2m/s AIR TEMPERATURE, T=300K AIR…

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A:

Q: A 6-cm diameter pipe is used to deliver hot water to a residence. A 8-m-long horizontal section of…

A: Given    The mass flow rate of water, m = 0.015 kg/s

Q: As part of an industrial pipe system a 6-meter-long by .5 meter inner diameter copper pipe weighing…

A:

Q: The condenser of a steam power plant consists of AISI 302 Stainless steel tubes, each with outer and…

A: The objective of this question is to determine the outer surface temperature of the tube and the…

Q: Water enters a tube at 29°C with a flow rate of 460 kg/h. The rate of heat transfer from the tube…

A: Solution to first three sub-parts as per our company policy:

Q: Engine oil flows at a rate of 0.05 kg/s through a section of a 2.5 cm diameter tube. The oil enters…

A: Given: Mass flow rate of the engine oil→m=0.05 Kg/s Diameter of the tube→D=2.5 Cm=0.025 m Initial…

Q: Choose the right answer 1. The mean Nusselt number for fully developed laminar flow in a circular…

A:

Q: Water with a mass flow rate of 0.002 kg/s at 18oC flows inside a tube while the flow is already…

A:

Q: Consider pressurized water, engine oil (unused), and Nak (22%/78%) flowing in a 20-mm-diameter tube.…

A: To Find: The mean velocity the hydrodynamic entry length at temperature T=366 K. Given : The fluid…

Q: Water at a temperature of 20 oC with a mass flow rate of 0.015 kg/s enters the pipe 2.5 cm in…

A: Dear student, we are suppose to solve only 3 sub parts. Please post other parts as a separate…

Q: C Hot air enters a sheet metal duct located in a basement. Determine the exit temperature and the…

A:

Q: A cooling pipe with length of 0.55 m and inner diameter of 38.1 mm is constructed to coo ammonia gas…

A:

Q: Dry, compressed air at Tmi = 75°C. p = 10 atm, with a mass flow rate of m = 0.003 kg/s, enters a…

A: GivenTm,i=75°Cp=10atmm˙=0.003kg/sd=32mmlength,l=5mTs=25°Ch=3.58W/m2.k

Q: Water at 90° C and a rate of 0.5 kg/s is cooled to 45° C in a copper pipe of 2 cm outer diameter and…

A:

Q: Heat transfer problem Water flows through a thin-walled cylindrical tube of diameter 1 cm,…

A:

Q: determine the tube length required to heat the oil

A: Given: Di=3 cm Do=5 cm Ti=10oC To=30oC To determine:  Length of the tube

Q: Air with an average temperature of 25oC flows inside a tube arrangement consisting 10 rows of tubes.…

A: 1 2

Q: Air at p = 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L = 2 m) at an inlet…

A: Given data: ◆ The diameter of thin walled tube: D = 5 mm = 0.005 m ◆ The length of thin walled tube:…

Q: Q 2- The Nusselt number for flow in a tube is given by Nu = C₁ Rea Prb where the constants, C1, a,…

A: Given: The diameter of tube, d = 10 cm = 0.1 m The length of tube, L = 30 cm = 0.3 m Prandtl number,…

Q: Air at p 1 atm enters a thin-walled (D = 5-mm diameter) long tube (L= 2 m) at an inlet temperature…

A: Given dataD=5mm=0.005mL=2mp=1atmm˙=135×106 kg/sT=400KTso=160°CTmi=100°C

Q: constant cross-section, the Nusselt number at constant wall heat flux (Nug) and that at constant…

A: Given; A hydrodynamically and thermally fully developed laminar flow in which we have to find the…

Q: In a large student house in Sheffield, cold water is supplied by the mains water supply at a…

A:

Q: determine the heat rate entering the tube, in W

A: To Find : The heat rate entering the tube.Given : The pressure of air is  The Diameter of the tube…

Q: Steam at 280 oC, tube=26 W/m. It flows at a speed of 4.0 m/s along a pipe made of iron-steel…

A:

Q: A refrigerant 22 condenser has four water passes and a total of 60 copper tubes that are 14 mm ID…

A:

Q: An electric heater heats the inner tube walls of a concentric tube annulus at a rate of 2000 W/m.…

A: Given Data Rate of heat transfer is : q'=2000 W/m Inner diameter is : di=25 mm Outer diameter is :…