V:..H.W. .mp4www.DANDICAMCOH.W. 1 Poly-phase SystemsA three phase, four-wire, 208 volt, CBA system has a wyeconnected load with Z, = 60°,2, = 6/30° and Ze = 5/45°. Obtain the three line currents and the neutral current(in a polar form)after finding O2 and 03.A'120/031002B-120/150

H.W. 1 Poly -phase Systems A threephase, four-wine, 208 volt, CBA ystem has a wyeconeted load with Z, = 60°, 4 = 600 and e = 545°. Obain the thre line curents and the neutral curent(in a polar form) after finding 02 and 03.

H.W. 1 Poly -phase Systems A threephase, four-wine, 208 volt, CBA ystem has a wyeconeted load with Z, = 60°, 4 = 600 and e = 545°. Obain the thre line curents and the neutral curent(in a polar form) after finding 02 and 03.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Two 240V fluorescent lighting units are arranged to minimize the stroboscopic effect. The active and…

A: The solution can be achieved as follows.

Q: 3. Two circuit elements in series consume 60 VAR when connected to a 120 – V, 60 – Hz source. If the…

A: Total supply voltage = 120 V. pf is 0.6 . Input VAR = 60. Input watt = 60/tan(x). So watt = 60/tan…

Q: Three identical capacitors of 10 micro farad are connected in star across a 400 volts, 50Hz, 3-phase…

A: Given 3 identical capacitors connected in star to a 3 - phase power supply. we need to determine…

Q: Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and…

A: In this question we will write relation between voltage and current and power factor ....Also find…

Q: This course Time left Find the value of i2, 14 and i5 if i1-3A, 13=1A and i6-1A. 10 oh 20 ohm 15 ohm…

Q: You make a circuit with a function generator at 1.02 kHz battery, a 43.0 Q resistor, and a capacitor…

A: The RC series circuit with a voltage source is shown below: The RMS voltage across the capacitor…

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…

A: Given data : distance D=25 feet

Q: 57. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following…

A: This question belongs to circuit theory . It is based on the concept of ac analysis for circuit . It…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: A 3 phase 200 MVA capacitor bank is to be switched off (disconnected) the grid that operates at…

A: Restriking voltage: It refers to the transient voltage that appears across the contacts of a…

Q: The generator convert from PV to PQ if the active power of the generator exceed the * maxinum and…

A: The generator convert from PV to PQ if the active power of the generator exceed the a) maximum and…

Q: CI (). Tre dentical capacitor are connected in delta to 430 Volts, = 50 Hz, 3 phase supply.If th…

Q: A Cock-eroft Walton type voltage maltiplier has 7 atagea with capacitance tranaformer secondary…

A: COCKROFT-WALTON VOLTAGE MULTIPLIER: The Cockcroft–Walton (CW) generator is an electric circuit that…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: UIN: 14V = 6A in the direction shown. choice of node or loop I = 6A R=20 R= 1O 1ER, = 10 R- 10 R- 20…

Q: 8 - What is the time it takes to complete a cycle in AA? A) Positive alternans B) Period C)…

A: What is the time it takes to complete a cycle in AA?

Q: Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method…

A: The electrical circuits have resistance, inductance and capacitance as their elements. In the…

Q: Determine: (i) Frequency of oscillations (ii) The maximum value of RRRV (iii) Time taken to…

A: Given, I(rms) = 8000 A L = 2.5 mH C = 1.4*10^(-7) uF

Q: 13. A circuit is composed of a resistance of 22 ohms, an inductance of 0.11 henry and a capacitance…

Q: • Show the voltage waveforms across each half of the secondary winding and across RL. Find the…

Q: A 20 Ohm resistor is in series with a 30 Ohm Inductive reactance. If they are connected to a 40 Volt…

A: In this question, we need to determine the angle between phase voltage and voltage across inductive…

Q: a) If the operating frequency increases in Figure below, the current_____and phase angle______ ? A)…

A: Current through the series circuit is the ratio of voltage and impedance. The total impedance of…

Q: An inductor is connected in parallel with a 6540 resistor and a function generator. The applied…

A: Let current through the resistor be IR and current through the inductor is IL and I be total source…

Q: Q1: A 50HZ,11KV,3-ph,alternator with earthed neutral has a reactance of 50\ph and is connected to…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: Design a short circuit shunt stub that will match a 50 ohm line into a 100 + j100 ohm load.

A: We need to design a short circuit stub that with match a 50 ohm line into a 100+j100 ohm load.

Q: 2-2. A single-phase half wave circuit has Vs = 230 V with a R load of 100 . Find the average load…

A: In this question, we need to determine the average current Io of single phase half wave rectifier.

Q: The system supplies follwoing loads i) Lighting load of 50 kW p.f=1 ii) Induction motor load of 125…

Q: A voltage and current applied to a single phase load is v= 26 cos (300t+35) and i= 19 cos (250t-…

A: Given: v=25cos300t+35°i=19cos250t-20°

Q: please include the request below with the phasor diagram C ii) Construct the new phasor for E’…

Q: 15. You are working on a power factor correction installation, and you notice with a clip-on ammeter…

Q: In a series AC resistive circuit: O a) voltage leads current by 90°(degrees). b) current leads…

A: Option c Current and voltage are in phase

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question, We need to determine the peak voltage Across the load and average power P? We…

Q: A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power…

A: The power factor for series RL circuit can be written as, p.f=cosθwhere…

Q: 2. A resistive load of 1002 is connected through a half-wave SCR. circuit to 220V, 50 Hz, single…

A: Given data: The resistance is R=10 Ω The given voltage is V=220 V The frequency is f=50 Hz The…

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per…

A: Given data, D=42 feet Standard data, For Falcon ACSR(steel) Diameter=0.5150 inch

Q: A single phase, 60Hz, 200-km medium nominal-T transmission line receives 700 MW at 0.95 lagging pf…

Q: a) Measure the phase shift of these two signals. b) Is Vout leading or lagging Vin? c) Is Vout…

A: Need to measure the phase shift of these two signals, analyze Vout leading or lagging Vin? and need…

Q: Can you help me provide recommendations to improve harmonics and flicker- in three phase power…

A: The harmonics in a system can be explained as the integral multiple of the fundamental frequency.…

Q: AC V, f A ac xuf ac V ac 21. The simple AC powered circuit above is being measured for AC current…

Q: 3.The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4…

A: The e.m.f induced in one conductor = 8.11 V No. of slots (S) = 120 Synchronous speed (Ns) = 720…

Concept explainers

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.

Question

V:..
H.W. .mp4
www.DANDICAMCO
H.W. 1 Poly-phase Systems
A three phase, four-wire, 208 volt, CBA system has a wyeconnected load with Z, = 60°,
2, = 6/30° and Ze = 5/45°. Obtain the three line currents and the neutral current(in a polar form)
after finding O2 and 03.
A'
120/03
1002
B-
120/150

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Solution

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10 and 15 amperes. Assuming IA to be the reference phasor, IB leads IA by 30°, and IC lags IA by 65°, calculate the total current and the angle it makes with the reference.
1. Find the required single-phase excitation voltage at rated voltage and frequency, in Volts 2. Find the required single-phase excitation voltage when both terminal voltage and frequency are 80% of their rated values, in Volts
Please answer this problem Determine the Resistance Value and reactance of the rotal impedance
Three identical capacitors of 10 micro farad are connected in delta across a 415 volts, 50HZ, 3-phase supply. What value of capacitance must be connected in star to take the same line current and line voltage? Phase current in star Phase current in delta Value of Xc in star Capacitance in star
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
Compute the magnitude of the voltage in units of Volts (enter value only, not units) for a componet with phasor current and impedance specified below - I = 2AZ0° Z = 10445°
3. An inductor having a 50 ohms resistance and 100 ohm inductive reactance is connected to a 100 volts, 60 hz a-c source. Draw the phasor diagram and waveform diagram of the current and voltage of the circuit showing their phase an
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
Three identical capacitors of 15 micro farad are connected in star across a 425 volts, 50HZ, 3-phase supply. What value of capacitance must be connected in delta to take the same line current and line voltage? Phase current in star Phase current in delta Value of Xc in delta Capacitance in delta
3. If the ratio of V/F has been kept constant and the observed value of hysteresis loss at rated frequency of 50 Hz is 18 W, the measured value of core losses is 35 W, Find the total core losses at the frequency of 60 Hz. 02:
For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms
12. The generation of "back voltage" is a significant factor for which of the following? O A. Capacitive reactance O B. Phase shift O C. Effective value D. Inductive reactance