The system supplies follwoing loads i) Lighting load of 50 kW p.f=1 ii) Induction motor load of 125 kW with a lagging p.f of 0.707 iii) A synchronous condenser of 75 kW at p.f 0.9 iv) Other miscellaneous loads of 25 kw at p.f 0.8 lagging. The voltage of the system is xxx V where xxx is 311

The system supplies follwoing loads i) Lighting load of 50 kW p.f=1 ii) Induction motor load of 125 kW with a lagging p.f of 0.707 iii) A synchronous condenser of 75 kW at p.f 0.9 iv) Other miscellaneous loads of 25 kw at p.f 0.8 lagging. The voltage of the system is xxx V where xxx is 311

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.16P: A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and...

See similar textbooks

Related questions

Q: To improve power factor by static capacitor method. If the capacitance per phase is increases, then…

Q: Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four…

A: to find the answers in the below steps

Q: A 200 – ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in parallel across a…

Q: A 80 MVA synchronous generator has Xs = j8Ω. The generator is supplying its rated power to an…

A: Given synchronous generator :80 MVA Xs = j8 Ω. bus voltage :33KV and power factor : 0.9

Q: A 6-pole, 3-phase, 60-Hz alternator has 12 slots per pole and four conductors per slot. The winding…

Q: A 4MVA, 13.3 kV, 60 Hz, 3 phase, delta connected alternator has an effective resistance of 5.2 ohm…

Q: Question 1 A 125 MVA, 20 kV, three-phase, wye-connected, 60 Hz, synchronous alternator is connected…

A: From the given data,to find the given answers to questions given = ?

Q: The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2…

Q: Two alternators are connected in parallel to feed a load together. The no-load frequency of the…

A: G1 has a no-load frequency of 51.5 Hz and a slope sP1 of 1MW/Hz.G2 has a no-load frequency of 51Hz…

Q: A 60 Hz, 33 kV, 3-phase alternator with earthed neutral has a reactance of 7 ohms per phase and is…

A: We have an alternator with earthed neutral which is connected to a bus-bar through a circuit breaker…

Q: Alternator A (100 kVA, 3-f, 240 V, 60 Hz, 1800 rpm) is operating in parallel with alternator B (125…

A: In this question We need to determine the pf of load. If Alternator A (100 kVA, 3-f, 240 V, 60 Hz,…

Q: A 1200 kVA, 6600 volt, 3-phase, Y-connected alternator has an effective resistance of 0.40 ohm and a…

A: Power factor :- It is the ratio of Active power to the Apparent power of the circuit. Power factor=…

Q: e star connected, 1500 kVA, 13 kV alternator has an armature res ous reactance of 8.0 ohms. When…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

A: In RL parallel connection branch resistor and inductor are connected in parallel with each other and…

Q: Explain the conditions of parallel connection of alternators and how these conditions are fulfilled.

A: If the value of the power demand is large then, it is not possible to provide the power by using a…

Q: How do the capacitor and inductor support the circuit in power factor improvement?

A: Capacitors and inductors are commonly used in electrical circuits to improve the power factor, which…

Q: An alternator of frequency 50.3 Hz is to be synchronized with an infinite bus of frequency 50 Hz by…

A: Given values are - Alternator frequencyfa=50.3HzBus frequencyfb=50Hz Given that alternator is…

Q: A single phase, 2000 V alternator has armature resistance and reactance of 0.8 ohms and 4.94 ohms…

A: Given, A single phase alternator has V= 2000 V R= 0.8 ohms X= 4.94 ohms I= 100 A Power factor,…

Q: 9.a. If a 33% load increase is suddenly applied to an alternator having a 25% reactance, the initial…

A: According to question we have to, 9(a). If a 33% load increase is suddenly applied to an…

Q: What is the relationship between primary induced emf( E1) and applied voltage (V1) of a Transformer?…

A: The relationship between primary induced emf( E1) and applied voltage (V1)

Q: The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10…

A: We have an step down DC chopper with, DC source voltage (Vdc) = 200 V Resistive Load Impedance (R) =…

Q: Does Clampor circuit change the peak-to-peak (i.e., rms value)? Justfy

A: According to the question we need to discuss. Does the Clampor circuit change the peak-to-peak…

Q: If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature…

Q: two synchronous generators are connected in parallel, feeding a load together. the frequency of the…

Q: The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine…

A: In this question per unit impedance given on some Mva and kv..We have to find new ou impedance on…

Q: We know there are few conditions for alternator synchronization. How many conditions are there?…

A: There are total 5 conditions of synchronization .

Q: Please solve the problem and show the circuit diagram. Thank you. 3. A 5 MVA, 13.2 kV, 3-phase…

A: An alternator/Synchronous generator is a type of electrical machine that converts mechanical energy…

Q: 65. A three-phase, 440 V, 60 Hz supply is connected to a three-phase, wye-connected induction motor…

Q: A three phase star connected, 1500 kVA, 13 kV alternator has an armature resistance of 0.9 ohm and a…

A: Given : Power = 1500 Kva Voltage =13 kV Ra= 0.9 ohm Xa= 8 ohm

Q: Generate a conclusion on this following statements: Determine and analyze the voltage regulation…

A: GIVEN: resistive load inductive load capacitive load DETERMINE: the…

Q: identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf…

Q: A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A…

Q: Draw a complete equivalent circuit of one phase only of a synchronous generator. Then draw the…

Q: A 9.9 kV, Y-connected, 3 phase alternator has a synchronous reactance of 8 ohms per phase and…

Q: e = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase…

A: 1)It is not possible that , current can flow in two directions at same time. However if we apply two…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

Q: A three-phase star-connected alternator is rated at 1500 KVA, 11 KV, The armature resistance and…

Concept explainers

Magnetic Moment

The magnetic moment is defined as the alignment of a magnet and its strength when the magnet is creating a magnetic field. There are number of examples of the magnetic moment, few are a current carrying conductor in the form of coil, elements at microscopic levels like electrons and many more.

Question

Propose size of the capacitor required to improve the pf of a single phase system to 98%. The system supplies follwoing loads i) Lighting load of 50 kW p.f=1 ii) Induction motor load of 125 kW with a lagging p.f of 0.707 iii) A synchronous condenser of 75 kW at p.f 0.9 iv) Other miscellaneous loads of 25 kw at p.f 0.8 lagging. The voltage of the system is xxx V where xxx is 311

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

As per bartleby honor code I can submit 3 questions So please answer all
A three-phase 3300V. 50 Hz star-connected alternator has an effective resistance of 0.5 ohm/phase. A field current to of 30A produces full-load current of 180A on short- circit and a line to line emf of 1000V on open circit Determine(i) the power angle of the alternator when it delivers full-load at 0.8p.f(lag) (ii)the SCR of the alternator D
8 = 0 Q1: What does happen if we change two currents? Q2: What does happen if we have a three-phase four poles machine? a Q3: What does happen if we have a two-phase two poles machine? Q4: What does happen if we apply a capacitance in phase b and then use same voltage for both phase. Dr. Ali K....p. . --
As per bartleby honor code I can submit 3 questions. Please solve b,d and e
The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10 ohm. The duty cycle is 0.4 the voltage drop across the switch may be taken as zero, Calculate : (a) Average and RMS value of output voltage. (b) Average and RMS value of output current.
Can we improve a leading load pf using a synchronous condenser? Explain briefly your answerin one(1) sentence.
b) Two alternators are connected in parallel to feed a load together. The no-load frequency of the first alternator is 51.5 Hz and its slope is 1MW / Hz. The no-load frequency of the second alternator is 51.0 Hz and its slope is 1MW / Hz. The total power of the load fed by these two alternators is 2.5MW and the power factor is 0.8. Accordingly, at what frequency does this system work and what are the power values transferred to the load by each alternator.
Two identical, 3-phase, Y-connected alternators A and B share equally a load of 10MW at 33kV at 0.8pf lagging. The synchronous reactance of each machine is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry 125A lagging current. What is the current supplied by alternator B?
A 80 MVA synchronous generator has Xs = j8Ω. The generator is supplying itsrated power to an infinite bus at a voltage of 33KV and a power factor of 0.9lagging.Determine the following:a) The generator emf (E) and the power angle.b) The maximum power (Pmax) that the generator can supply and the armaturecurrent (Ia) in this case (i.e. when the power is maximum) and what is thepower factor?
The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2 p.u. Then the p.u. impedance value of an alternator for the new base values of 13.8 kV and 50 MVA is......
Question 1 A 125 MVA, 20 kV, three-phase, wye-connected, 60 Hz, synchronous alternator is connected to a 20 kV power grid. The alternator has negligible armature resistance and synchronous reactance of 5 2/phase. The mechanical limit of the turbine powering the alternator limits its maximum power output to 100MW. (a) Calculate the value of excitation voltage (line to neutral with angle) needed for 50% maximum power (50MW) at unity pf. |E(LN) 8 (b) Find the alternator reactive power import/export if its real power output is now increased to 75% rated (75 MW) with the excitation unchanged. (1) Draw before and after phasor diagrams on the same axes (performance chart) to illustrate the two operational states. (ii) Calculate the alternator reactive power import/export when its real power output is increased to 75% rated (75 MW) with the excitation unchanged. Q3ph Import or export?
A 4MVA, 13.3 kV, 60 Hz, 3 phase, delta connected alternator has aneffective resistance of 5.2 ohm per phase and a combined armaturereactance of 54 ohm per phase. Determine the full load generatedvoltage per phase :a) At unity power factorb) At 0.8 power factor leadingc) At 0. 866 at power factor lagging Whole Solution