Given: Vbatt is 14.5V to avoid overcharging the battery. Vbatt falls to 11.4V due to discharge at night. Question: If VB = 8.1V and the minimum current for VB is 0.4mA, what should be the maximum resistance value of RB? (in Ohms)

Given: Vbatt is 14.5V to avoid overcharging the battery. Vbatt falls to 11.4V due to discharge at night. Question: If VB = 8.1V and the minimum current for VB is 0.4mA, what should be the maximum resistance value of RB? (in Ohms)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: If the surface leakage current is 2nA for a reverse voltage of 25V, what is the surface leakage…

Q: In NTC thermistor B describes the gradient of the resistive (R/T) curve over a particular…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Assuming that the diodes in the given circuit are ideal, v0?

A: The solution is as follows.

Q: The error for an ammeter is found as ±2%, the true range of the current it can give for 10 mA is

A: Given: The error for an ammeter, error=±2% Current, I=10 mA

Q: As the doping of a pure semiconductor is increased the resistance will Answer:

A: For a pure semiconductor if doping is increased, either free holes or electrons are created. These…

Q: Question 7 Semiconductors has number of valence electrons.

Q: Calculate the base current for this circuit. +12V 12.5 ka 2 ka silicon Select one: a. 0.904 mA O b.…

Q: Assume the diode emits green light when drawing 100ma of current. Assume Vcc=6V. What is the value…

Q: Find the current through the diode in mA. Blank 1 Answer must be with 2 decimal places. Do not…

Q: How much current is flowing through the diode below? =0.6V turnon 4 V 1kOhm 5 kOhm

Q: If the average of set of voltage reading is 54.2V. The precision for one of the reading 52.8, will…

A: Average of set of voltage reading 54.2V One Reading= 52.8

Q: 2. For w ard charast

A: It is given that:

Q: Characteristicof Diode Digi hat ltimeter 19v eheostat

A: Diode is always in forward bias. Since the N- terminal of diode is connected to negative terminal of…

Q: Q1. For the circuit shown in Figure below find the maximum and minimum values of zener diode…

A: In this question we will find minimum and maximum currents of zener diode...

Q: Trace the output of the network if the input is a 30V triangle wave, repeat for a sine wave of 8V .…

A: In the circuit, 2 zener diode is connected to back to back. Draw the output waveform 1. f the input…

Q: The figure open? to a battery. What is the total current drawn from the battery when the switch is…

A: In this question, We need to determine the total current in the given circuit. We know current I =…

Q: b. When the input is AC 110V @60Hz, Voltage output = 20V, Voltage ripple = 2V, and the maximum…

Q: Using the ideal model for the diodes, what is the current I in milliamps if V₁=2.5 volts and V₂=8.0…

Q: In figure, Vxy = ? %3D 6.2KN 1ΚΩ 3.3KN Tou 6802

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Estimate thermal voltage for 30o C.

A: The thermal voltage (VT) is a very important quantity in semiconductor physics. It is dependent on…

Q: R₁ = 50m2 M lov R₂=51² Find the current in the dioden

Q: One of the following elements can be used to make P-type semico Phosphor(P) Arsenic(As) Antimony(Sb)…

A: For p-type materials we need elements having three valence electrons.

Q: Three resistance 14. 5 Q, 25.5 Q and 60 Q are connected in series across 200 V. What will be the…

A: Given: Three resistances are connected in series, R1=14.5 ΩR2=25.5 ΩR3=60 Ω Supply voltage, Vs = 200…

Q: Q3/ Consider the circuit in Figure (2), answer (a)-What type of circuit is this? (b)-What is the…

Q: Resistance of 800 2 has a conductance of O125 millisiemens O 1.25 millisiemens O 12.5 millisiemens…

A: In this question we need to choose a correct option.

Q: v. D₁ + 4 D. A D 23 D₂4 Ve RS Intr. 220 -220-3 According to the applied input voltage, calculate the…

A: The above question is based on diode based full wave rectifier.

Q: On the second part, you did 60-60 because the charge didn't change. Is that correct?

A: Yes you are correct. The current through capacitor is the ratio of as change in charge to the…

Q: The diodes in the circuit given below are identical and each one is ideal. Accordingly, determine…

A: For first circuit shown below:

Q: Calculate the peak voltage of a main of r.m.s value is 22voltage

A: nature and is given by mathematical expression: v(t)=VmSinωt To solve above problem, one should know…

Q: How much work is done by a 12-V automobile battery in moving 5x102" electrons from the positive…

A: According to the question we have to find the value of work done.

Q: VT= 10 V A R₁ 150 $2 R₂ 15 $2 R3 1052 B + Lo

Q: 4. Consider the circuit in Figure 3. D1 is Gallium arsenide and D2 is Silicon, each has a forward…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: A barium titanate crystal has a thickness of 2 mm. Its voltage sensitivity is 12*10-3 Vm/N. It is…

A: Given, A barium titanate crystal having, Thickness, t= 2 mm Voltage sensitivity, g= 12×10-3 Vm/N…

Q: Determine the current across the 10-ohm resistor for the circuit shown below. Diodes are made of…

A: The solution is given below

Q: A bank of nickel-cadmium cells is used as the emergency lighting supply for a hospital. There are…

A: When batteries or cells are connected in series, their voltages add and their current capacities…

Q: 0₂ #2 Encontrar la potencia en la carga Ke + 1K LK 2K 3K 3K TIT 1K 4K3 TIT 5K R₁ Tit

Q: In a semiconductor it is observed that 80% of the current is carried by electrons and 20% by holes.…

Q: Given the Zener diode network shown, what is the voltage across R? express answer in volts + 40 V…

Q: H-W: Determine I, if the diodes are assumed to be ideal? Ans: 152 DI K ww D2 50Ω 3 V 20Ω

A: Circuit diagram is given, Given that diodes are ideal so taking diode voltage as 0.7 V.

Q: Sketch v, for the network + 20 V – 20 V + 10 ΚΩ 5 V Μ 1 ΚΩ • 2.2 ΚΩ 7V + + • 2.2 kΩ

Q: What will be the base current when base lead is open? a. Infinite b. Zero c. Increase d. Decrease

A: Given What will be the base current when base lead is open Choose the correct options a.…

Question

Given:

Vbatt is 14.5V to avoid overcharging the battery. Vbatt falls to 11.4V due to discharge at night.

Question:

If V_B = 8.1V and the minimum current for V_Bis 0.4mA, what should be the maximum resistance value of R_B? (in Ohms)

SW2
SW1
+
Vy
-УВАТТ
RA
RB
A
+
PV Module
VB
VA
5002
Vx

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Assuming that the diodes are ideal, find the values of I and V for the circuit.
5. Figure 7 shows a half wave rectifier circuit (a) and a full wave rectifier circuit (b). Answer the following questions: D1 Vin Vout Vin Vin +v Vout sine A 1 kHz Vin sine 1 kHz ov Figure 7
According to the figures, the required load for the zener diode to regulate in the circuit is minimum how many ohms is its resistance?
Solev this question it has 4 parts confusing me alot and X=167 and in part c there's a bit tricky with X by providing a condition so please check
What is the current through the zener diode? V₁ 13 V R₁ 1 kn express answer in mA 2 1 6V Vout
For solar cell the Open Circuit Voltage (Voc) occurs when O a. voltage is minimium f O b. voltage is zero ion O C. current is maximium O d. current is zero page
1. Assume the diodes below are ideal. What is the value of Vout? Vin + 5 V ww 2 ΚΩ M ww 3 ΚΩ 5 ΚΩ + D4 OV 11 20 mA Vout 10 ΚΩ D5 OV
For the diode circuit of the figure below: 1. Determine v, and sketch its waveform for at least 4 cycles 2. Determine the average (dc) voltage established the load Show the details of your work. Without a complete solution (step-by-step solution) will invalidate your answer. 120 V 2.7 kN -120 V
Find the equivalent resistance Rab for this circuit
C -Q (A) 0.25 uF 10V 2uF 4uF (B) Figure 3: 3. In Figure 3 the capacitors were discharged before being connected to the battery. (a) In Figure 3A the net positive charge delivered by the battery is +Q1 to C1 and a net negative charge -[Q2 + Q3] is delivered to C2 and C3 [-Q2 is delivered to C2 and -Q3 to C3]. From conservation of charge[net charge is zero since both the battery and the capacitors have a zero net excess charge] and path independence of the electric field[sum of voltages must add up to zero for a closed path or conservation of energy]: Q1 + (-Q2) + (-Q3) = 0 conservation of charge +%-왕-용 (True, False) = 0 conservation of energy +V - = 0 conservation of energy (b) If (a) is true then the charge Q1, Q2 and Q3 follow from above three equations as C1(C2 + C3) V Q2 = Ci + C2 + C3 C1 C3 Ci + C2 + C3 Q1 = Q3 = V, (True, False) C1 + C2 + C3 (c) In Figure 3A the net positive charge delivered by the battery is Qtot = Q1 = C1(C2+C3) v which implies an equivalent capacitance of Qtot…
Calculate the equivalent resistances Rin of the following circuits. (The resistance value of the diodes in the conduction will be 0, the resistance value of the diodes in the insulation will be taken as infinity. R1=10ohm
Determine the output voltage waveform for the below figure: 2.2kn 30V 40 out 12V 30 Y