Given the standard enthalpy changes for the following two reactions: (1) Ni(s) + Cl2(g)→NiCl2(s) AH° = -305.3 kJ %3D (2) Fe(s) + Cl2(g) FeCl2(s) AH° =-341.8 kJ what is the standard enthalpy change for the reaction: (3) Ni(s) + FeCl2(s)NiCl2(s) + Fe(s) AH° = ? kJ

Given the standard enthalpy changes for the following two reactions: (1) Ni(s) + Cl2(g)→NiCl2(s) AH° = -305.3 kJ %3D (2) Fe(s) + Cl2(g) FeCl2(s) AH° =-341.8 kJ what is the standard enthalpy change for the reaction: (3) Ni(s) + FeCl2(s)NiCl2(s) + Fe(s) AH° = ? kJ

Chemistry for Engineering Students

4th Edition

ISBN:9781337398909

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter9: Energy And Chemistry

Section: Chapter Questions

Problem 9.73PAE: 9.73 Without looking up any numerical data or doing calculations, predict whether the enthalpy...

See similar textbooks

Similar questions

Starting with equation 2.27 andthe original definitionof enthalpy, derive the fact that Cp-=Cv-+R
Would the amount of heat absorbed by the dissolution in Example 5.6 appear greater, lesser, or remain the same if the heat capacity of the calorimeter were taken into account? Explain your answer.
sample of natural gas is analyzed and found to be88.4% methane (CH4) and 11.6% ethane (C2H6) bymass. The standard enthalpy of combustion of methaneto gaseous carbon dioxide (CO2) and liquid water (H2O) is -891 kJ/mol. Write the equation for the combustionof gaseous ethane to carbon dioxide and water.Calculate the standard enthalpy of combustion of ethaneusing standard enthalpies of formation from Table R-11on page 975. Using that result and the standard enthalpyof combustion of methane in Table 15.3, calculate theenergy released by the combustion of 1 kg of natural gas.
One of the components of jet engine fuel is n-dodecane, C12H26(), which has a standard enthalpy of combustion of 8080.1 kJ/mol. (a) Write the thermochemical equation for the combustion of n-dodecane. (b) Use the standard enthalpies of formation in Appendix G to calculate the standard enthalpy of formation of n-dodecane.
Although the gas used in an oxyacetylene torch (Figure 5.7) is essentially pure acetylene, the heat produced by combustion of one mole of acetylene in such a torch is likely not equal to the enthalpy of combustion of acetylene listed in Table 5.2. Considering the conditions for which the tabulated data are reported, suggest an explanation.
When one mol of KOH is neutralized by sulfuric acid, q=56 kJ. (This is called the heat of neutralization.) At 23.7C, 25.0 mL of 0.475 M H2SO4 is neutralized by 0.613 M KOH in a coffee-cup calorimeter. Assume that the specific heat of all solutions is 4.18J/gC, that the density of all solutions is 1.00 g/mL, and that volumes are additive. (a) How many mL of KOH is required to neutralize H2SO4? (b) What is the final temperature of the solution?
What is the difference between the enthalpy of reaction and the enthalpy of formation? For what chemical reaction(s) are the two quantities the same?
A piston performs work of 210. L atm on the surroundings, while the cylinder in which it is placed expands from 10. L to 25 L. At the same time, 45 J of heat is transferred from the surroundings to the system. Against what pressure was the piston working?
The complete combustion of acetylene, C2H2(g), produces 1300. kJ of energy per mole of acetylene consumed. How many grams of acetylene must be burned to produce enough heat to raise the temperature of 1.00 gal water by 10.0c if the process is 80.0% efficient? Assume the density of water is 1.00 g/cm3
Ethanol, C2H5OH, is used as a fuel for motor vehicles, particularly in Brazil. (a) Write the balanced equation for the combustion of ethanol to CO2(g) and H2O(g), and, using the data in Appendix G, calculate the enthalpy of combustion of 1 mole of ethanol. (b) The density of ethanol is 0.7893 g/mL. Calculate the enthalpy of combustion of exactly 1 L of ethanol. (c) Assuming that an automobile’s mileage is directly proportional to the heat of combustion of the fuel, calculate how much farther an automobile could be expected to travel on 1 L of gasoline than on 1 L of ethanol. Assume that gasoline has the heat of combustion and the density of n—octane, C8H18(Hf=208.4kJ/mol;density=0.7025g/mL).
Write reactions for which the enthalpy change will be a. Hf for solid aluminum oxide. b. the standard enthalpy of combustion of liquid ethanol, C2H5OH(l). c. the standard enthalpy of neutralization of sodium hydroxide solution by hydrochloric acid. d. Hf for gaseous vinyl chloride, C2H3Cl(g). e. the enthalpy of combustion of liquid benzene, C6H6(l). f. the enthalpy of solution of solid ammonium bromide.
9.73 Without looking up any numerical data or doing calculations, predict whether the enthalpy change for each of the following reactions should he positive, negative, or zero. (a) H2O(l)H2O(s) (b) N2(g)2N(g) (c) CH4(g)+2O2(g)CO2(g)+2H2O(l) (d) CO2(s)CO2(g)