Given the second order system below: A G (s) = g? +Bs+A Where A = 392 and B = 16 Determine the peak time (write the answer in four decimal places)

Problem #3: The DE10-Lite board has three clocks that can be seen in the table below: Table 3-2 Pin Assignment of Clock Inputs Signal Name ADC CLK_10 FPGA Pin No. Description PIN N5 MAX10_CLK1_50 PIN_P11 MAX10 CLK2_50 PIN_N14 10 MHz clock input for ADC (Bank 3B) 50 MHz clock inputiBank 3B) 50 MHz clock inputiBank 38) VO Standard 3.3-V LVTTL 3.3-V LVTTL 3.3-V LVTTL You need a clock of 2.5 MHz for your circuit, and for that reason you are going to use a Ipm_counter as a frequency divider shown here: Parameter PM SVALUE Value LPM AVALUE LIM MOBULUS LPM DRCTIN LPM WIDTH LPM_PORT UPOOWN LPM_COUNTER ell If the input boardClock is connected to PIN_N5, find (a) LPM_MODULUS and (b) the minimum width of q[..] LPM_WIDTH. (c) What bit of q[..] you will pick as your 2.5-MHz clock?

Cylindrical metallic parabolic trough solar thermal collectors. 1. Does not rotate. 2. It rotates around one axis only. 3. It rotates around two axes only. 4. They can produce a temperature of20-100 °C. 5. They can produce a temperature of200-400 °C. 6. They can produce a temperature of2000-4000 °C. O 1 + 4 only. O 2 + 5 only. 2 + 6 only O 3 + 5 only.

Read and Solve carefully please Write clearly and Box the Final answer Hint : Enter your answer to the 2nd nearest decimal place in percent.

QUESTION 29 Select all signals that are inputs for the 8088. Use the schematic for our board. OSC DEN* CLK RESET DT/R* INTA* INTR ALE READY NMI

Please draw the timing diagram with explanation   Please answer in typing format please ASAP

Please finish this quickly, make sure its accurate tho. thank you

Please answer in typing format solution please only typing format   Please I will like it please Thanks in advance

An LM317 is connected between two decoupling capacitors. There is a 220ohm resistor between the output pin and the adjust pin. Note the voltage drop between the output and adjust pins is 1.25V. Find the resistor needed between the Adjust pin and ground to ensure 5 V is dropped across the load. Enter your answer in ohms: _ohms

a 40% duty cycle clock signal is low for 10ns. What will the clock frequency be?  I got 60MHZ. But i'm not sure I did it right. Could you help me out?  Thank you.