An LM317 is connected between two decoupling capacitors. There is a 220ohm resistor between the output pin and the adjust pin . Note the voltage drop between the output and adjust pins is 1.25V. Find the resistor needed between the Adjust pin and ground to ensure 5 V is dropped across the load. Enter your answer in ohms: _ohms

Q: 39. Once triggering on, the SCR (with the cathode connected to common) will conduct for the…

A: SCR: It is a semiconductor device. It has 3 layers. When the NPN and PNP are attached to each other…

Q: (2) A controlled half-wave rectifier has a 240 V rms 60Hz ac source, The load a is R=30 Ohm resistor…

A: Given,    A controlled half wave rectifier,       Vrms= 240V         f = 60Hz         R = 30 ohm

Q: A 60 Hz sinusoidal voltage with an RMS value of 120 V is applied to a single-phase half-wave SCR…

A:

Q: For the full wave rectifier circuit shown in Figure 1, calculate: 1) The maximum current through the…

A:

Q: Check all the correct statements. The forward voltage in diodes is larger than its reverse voltage.…

A: 1. The forward voltage in diode is larger than it's reverse voltage To "turn on" and lead current…

Q: a A forward buck regulator has V 15 V. The average output voltage required is V₁ = 6 V with…

A: It is given that:

Q: The diodes in the circuit in Figure Q7 have V₂ = 0.7. Determine the output voltage Vo and the…

A: Given, Vγ=0.7V1=2VV2=3VTo calculate,Vo=?ID1,ID2,ID3  and I

Q: 1) The following is not an example of a Thyristor a) A Silicon Unilateral Switch b) A TRIAC c) A…

A:

Q: The Circuit Below shows a basic Buck-Boost Converter with a highly inductive Load. With a Deliberate…

A: In the given circuit firstly we have to find the duty cycle Duty cycle = 0.55+17×0.2100Duty cycle…

Q: 55. A full-wave rectifier with a capacitor-input filter provides a dc output voltage of 35 V to a…

A: Given in the question: DC output voltage, VDC = 35V Resistance of the load, RLOAD = 3.3KΩ Ripple…