Given the accompanying tabulation are the observed data for a traverse obtained from a transit-tape survey. Determine the latitudes and departures of each course and balance these quantities by employing the Transit rule. Tabulate values accordingly.

Q: 9. COMPASS the observed and calculated data for two different transit- tape surveys: RULE. Given in…

A:

Q: Q3): The following data were collected while running a closed traverse ABCDA starting from A toward…

A:

Q: In a traverse, the latitudes and departures were observed to be: Σ latitude 1.45 m Σ departure =…

A:

Q: Three triangulation stations A, C and E are points on the shore whose position were observed  from…

A: Formulae required to solve this question are basic traingle formulae Sum of angles in a triangle is…

Q: Station Angles No. of Measurement A 53° 4 B 57° 69 3

A:

Q: (D) (ENL) (ESL) (EED) (E WD) For each set of survey data, determine the linear mis- closure, the…

A: Surveying is a branch of the construction industry when balancing between different points on the…

Q: Given in the accompanying tabulation are the observed data for an open traverse which was made…

A:

Q: ONS:Given in the accompanying tabulation are the observed data for a closed traverse obtained from a…

A:

Q: Stadia Tacheometric Survey Problem 3. In the figure, the difference in elevation between observed…

A:

Q: The observed interior angles of a closed traverse are as follows: A = 153°30’00’’, B = 58°20’00’’, C…

A:

Q: The data from a closed traverse survey PQRS (run in the clockwise direction) are given in the table…

A: Given survey table,

Q: 15.15 The manufacturer-specified accuracy for a PPK survey is +(5 mm + 1 ppm) at 68% probability.…

A: To calculate the 95% error for a control baseline observed using the stop-and-go method, one can use…

Q: DEFLECTION ANGLE TRAVERSE. The following are the mea- sured deflection angles for a closed traverse:…

A:

Q: Simple supported beam with point load (Pu=100 kN) at mid span, what is the value of shear force at…

A: Option C ( 50 kN) is correct

Q: Traverse Surveying Question In a closed loop traverse of 1 km total length, the closing errors in…

A: Given data- A closed loop traverse- Total length L=1 km=1000 m, Closing error in departure = 0.3,…

Q: From the given data table below compute the following: (refer to the data table below) a)…

A:

Q: A survey party proceeded to do their stadia survey work as follows: the transit was set up at a…

A: Consider the free body diagram (a) In tachometry survey, Instrument has two constant K&C…

Q: INSTRUCTIONS: Given in the accompanying tabulation are the observed data for a closed traverse…

A: Here we use that sum of latitude and departures is zero if it's not its error  Then we use following…

Q: A survey party proceeded to do their stadia survey work as follows: the transit wasset up at a point…

A: C = 0.30 m From tacheometry survey, we know D = KS+C where D = horizontal distance between two…

Q: 1.. Determine the distance between survey stations R and S, which are separated by a body of water.…

A: We are given Angle R-ST = 67o11'39" Angle T-RS = 33o49'38" We know that sum of angles in a triangle…

Q: Based on the following survey data an angle is measured repeatedly using the same equipment and…

A: Most probable value is the arithmetic mean of the observed readings. If weightage is given for…

Q: 1. TRANSIT RULE. Given in the accompanying tabulation are the observed data for a traverse obtained…

A: We can adjust the Traverse by 2 methods  Transit method  Compass method

Q: INSTRUCTIONS: Given in the accompanying tabulation are the observed data for a closed traverse…

A: Sign convention: N-E : Both positive S-E: Latitude negative and Departure positive N-W: Departure…

Q: 1. A tachometric surveying was performed by a surveyor. The transit used has a stadia interval…

A: Stadia interval factor = 90.98 Stadia constant = 0.16 m The instrument is set up between two points…

Q: Solve the following problems showing your complete solutions. Draw the figure completely labelled…

A: GIVEN DATA:- LINE LENGTH BEARING 1-2 56M S50015'E 2-3 50m S40025'E 3-4 30m S60045'W 4-5…

Q: A level loop was run and the raw elevations in Table 2 were calculated based on backsights and…

A: True Elevation of BM are given in the figureRaw elevations are given in the table.StationRaw…

Q: Surveying Question: A differential leveling circuit starts at benchmark Concrete Benchmark…

A: Rise and Fall method has been used for the calculation of elevation of unknown benchmark,…

Q: Given in the accompanying tabulation are the observed data for traverse obtained from a transit tape…

A:

Q: 3. COMPASS RULE. Given in the accompanying tabulations are the observed and calculated data for a…

A: The corrected sum of all latitudes and departure must be zero.

Q: 1. A tachometric surveying was performed by a surveyor. The transit used has a stadia interval…

A:

Q: Interior Angle Traverse The observed interior angles of a closed traverse are as follows: A, 153°…

A: Determine the angular closure and adjust the measured angles by assuming the angular error is of the…