Answered: Give the Formulas of Average Value and…

Engineering

Electrical Engineering

Give the Formulas of Average Value and RMS Value of a waveform

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.1MCQ: The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax

See similar textbooks

Related questions

Q: 41. Given v = what time does v reach 0 V? At what time does it reach 23 V and -23 V? 30 sin(wt –…

A: Given: v=30sinωt-45° ω=40π rad/s

Q: Consider the sinusoidal given in the figure below, determine the amplitude, period, frequency and…

Q: Draw rough sketches showing the following: a. A current which lags the voltage by 60°. b. A current…

A: Phasors rotates in anti clockwise. Current lags the voltage means current comes after voltage.

Q: (Square wave) 10 V | 2 3 t (ms) -10 V

Q: Determine the rms current in the figure for Vrms = 16 V and C = 74µF V f=10 kHz C

A: RMS voltage is given Vrms=16 V. Capacitance C=74 μF. Frequency f=10 kHz.

Q: b) Determine the voltage ??(??) and current ??(??) sinusoidal forms. Sketch one cycle of the…

A: Given;I=100∠-20°mAVs=120∠30°Vf=60 HzC=35μFDetermine;voltage=?current=?sinusoidal wave form

Q: shown in the Vps low is Write the FORMULA for the total impedance of the circuit Zut= R²+ cL- Write…

Q: Given the ff. 1 kHz 5V peak-to-peak sine wave. 0-3.3 V square wave with a period of 12.5μs 200 Hz…

Q: Q.1). Find the average and R.M.S values for the current waveform shown below. 60 40 20 I (s) 1ms 2…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: What would be the angular delay of the new set of waveforms if we change the resistors' value in…

A: The angular delay is dependent on inductive reactance, capacitive reactance and resistance. It is…

Question

Give the Formulas of Average Value and RMS Value of a waveform

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequeney of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms . (iii) Determine phase relationship between voltage and current waveform.
Given the figure below. Find: a. RMS value of the waveformb. Average value of the waveform
(b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using oscilloscope. The voltage waveform produced Root Mean Square (RMS) value at 75 V with positive-going zero crossing at 30°. While the RMS value of current is 66.71 A with negative-going zero crossing at 0.349 rad. Assume the frequency of both waveforms is 50 Hz. (i) Sketch the voltage and current waveform in the same axis by showing the important point. (ii) Determine instantaneous voltage when t = 8ms - (iii) Determine phase relationship between voltage and current waveform. (c) From the measurement process, the circuit generated two different outputs, V,(t) and V,(t) with the same peak voltage. The V,(t) lagging V,(t) by 100°. If V,(t) =150sin(1000t – 40°)V , determine the RMS value and phase angle of.
Q2. For the Periodic Waveforms shown in the Figure, determine for each : Frequency, Average Value over half a cycle, RMS Value, Form Factor, and Peak Factor. 100 75 Voltage (V 50 25 20 40 Time (ms) 10 30 -100
For the waveform, determine
Find the RMS value of a 50% chopped ac wave
Find the RMS value..
Indicate the rms value and frequency in Hz of a voltage signal with value 200sen(1000t+30°) V
13. determine the frequency of a sinusoidal wave that has an equation of e = Emsin270t A. 42.97 Hz B. 24.79 Hz C. 35.14 Hz D. 45.54 Hz 14. The rms value of half wave rectified sine wave is 100A. its maximum value is: A. 198 A B. 202 A C. 200 A D. 199 A
A wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A. Find the rms value of the resultant current in the wire.
b) Determine the voltage ?(?) and current ?(?) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors ?L, ?r and ?c. e) Sketch the phasor diagram showing ?s, ?r, ?r, ?c and ?.
A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth harmonic, both of the harmonics being initially in phase with each other. (a) Determine the rms value of the fundamental and each harmonic. (b)Write down an expression to represent the complex voltage waveform if the frequency of the fundamental is 31.83 Hz.