Determine the values of resistance R and inductance L. need help on question C ，urgent

Q: The total charge stored by the series capacitors in the below figure is 515 pC. Determine the…

A: Given: Capacitors in series combination as,  with C1=5.72 pF, C2=3.32 pF, and C3 = 7.29 pF.  Total…

Q: (c) Measure the voltages of the resistor and capacitor and calculate the current using Ohm's Law…

A: Given:A circuit, we need to find:(c) Measure the voltages of the resistor and capacitor and…

Q: Find the equivalent Inductance between 'a' and 'b'. I L1= 15 mH, L2 = 40 mH, L3 = 40 mH, L = 40 mH…

A: I HAVE EXPLAINED IN DETAIL

Q: Calculate the inductance (H) of an air cored coil that has a length of 9 cm, a core with rectangular…

A: Consider the formula for the inductance of the air cored coil is, L=μN2Al Here, N is the number of…

Q: D I₁ + t=0 VR R - iR + UL elle L Vc + - Tic C

A:

Q: Assume all inductance values are known.  Please explain how to find the equivalent inductance as…

A: Step 1:Step 2:

Q: An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a…

A: Given: Inductor, L=0.2 H, Resistance, R=50 Ω, Frequency, f=60 Hz, Voltage, V=120 V.

Q: 12 when a inductor and resistor are connected in parallel, how many degrees out of phase are the…

A: In this question 12,  We need to determine the phase angle of current flow through the resistor and…

Q: What will be the resultant capacitance of the given combination? 1mF=2mF 3mF=4mF= 5mF

A: Given circuit,

Q: 2MF ㅔ C₁ THMF 24V 2MF 1. TOTAL CAPACITANCE- C4 똬 2mF -HICO AMF

A:

Q: Determine the waveform on the load: a) If this were a resistance b) If this were a capacitor

A: a) for resistive load

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.