From the following data, calculate the concentration of the analyte in the sample read at 700 nm: Absorbance of unknown sample = 0.807 Absorbance of a 130 mg/dl standard = 0.234 Do not answer in image format. Maintain accuracy and quality in your answer. Answer completely.

Q: The glucose content of samples can be determined using Nelson’s test. The equation of the line for…

A: A numerical problem based on calibration curve that is to be accomplished.

Q: Suppose you start with a 175 mL solution. After adding 2 mL of titrant, you spectrophotometer…

A: The concentration of the unknown solution indicates the amount of the unknown substance that exists…

Q: The same chloride analysis but using a new method for which the standard deviation was not known,…

A:

Q: You are asked to do quality control and quality assurance during the determination of lead…

A: The limit of quantitation is given by the expression: Limit of quantitation=10 sm     where,…

Q: Zinc was analysed in acid mine drainage (AMD). The signal obtained from an AAS for the sample was…

A:

Q: in a standard addition calibration method, 50.0 ml volumetric flasks were used. A 5.0 ml aliquot of…

A:

Q: Sarah wasn't sure about Ben's results, so she repeated the experiment and found the best-fit line…

A: The molarity and volumes of reactants initially taken are: 5.00 mL of 0.002 M Fe(NO3)3 or Fe3+(aq)…

Q: student prepared a cereal sample solution using a procedure similar to that in Lab 5.  The original…

A: The linear regression equation of the calibration curve is y = 11898x - 0.0112  where y =…

Q: A solution with 0.083 7 M X and 0.050 0 M S9 gave areas AX = 423 and AS9 = 372. Then 10.0 mL of 0.05…

A: Given: A solution having 0.0837 M X and 0.0500 M S’ showed peak areas AX = 423 and AS’ = 372,…

Q: Sally obtains a standard calibration curve for their assigned food dye by plotting absorbance versus…

A: The objective of this question is to determine the concentration of the food dye in the original…

Q: To determine the instrument detection limit of Pb2+ ions, a student made 10 blank solutions and…

A: Given: Standard deviation of the signal = 0.199 Equation of the curve =, y = 3.413x + b From here…

Q: What is the importance of the following analytical methods in chemical analysis? i. UV-vis…

A:

Q: To quantify the Cadmium content in a water sample, 5 aliquots of 10 mL were taken, adding to each…

A: The amount of concentration in the sample can be calculated using the following formula. In this…

Q: A standard of solution was put through appropriate dilutions to give the concentrations of glucose…

A: Straight line equation can be written as:traight line equation can be written as:Using Linear…

Q: For the determination of Fe3 +, 25 mL of sample taken from sea water is diluted to 100 mL and a…

A: A question based on Beer-Lambert law, which is to be accomplished.

Q: for density is M/\ Calculate the molarity of solution prepared by weighing 6.34 g of NaOH using a…

A:

Q: The validation process comprises four main steps that are : hardware validation, software…

A: Validation in analytical chemistry is the process of verifying that a procedure yield acceptable…

Q: Sally obtains a standard calibration curve for their assigned food dye by plotting absorbance versus…

A: The objective of the question is to determine the concentration of the food dye in the original…

Q: Sally obtains a standard calibration curve for their assigned food dye by plotting absorbance versus…

A: The objective of this question is to determine the concentration of the food dye in the original…

Q: The Na* concentration in a blood serum sample was determined using the method of standard addition…

A:

Q: 3. The lead in a swab sample, lead standards, together with a blank were made up in 5.00 mL…

A: The amount of lead in the swab sample is approximately 9.44 µg.Explanation:

Q: The answer is 0.372 ug/mL

A: Please see the attached image for the solution.  If there are queries or if the image is not…

Q: To determine the amount of copper and the identity of the copper compound in the unknown sample, a…

A: A question based on general chemistry that is to be accomplished.

Q: 5.) The literature value for the Ksp of lead(II) chromate is 2.8 x 10 13. Calculate the percent…

A:

Q: The concentration of nitrite (NO₂) in the unknown sample was determined by a direct (ordinary)…

A:

Q: The mass spectrum of a vaporized sample of potassium is given below. Use the information on he…

A: formula used average atomic mass =total relative atomic mass respect to intensity of given different…

Q: Reagent Blank Absorbance Concentration of Stock Solution: 10 ppm Volume of Stock Solution (mL) Total…

A:

Q: a] An analyst would like to analyze the concentration of Mg2+ in a solution. He needs a calibration…

A: A question based on absorption that is to be accomplished.

Q: 0.1120 g of a solid sample containing copper was dissolved by acid and transferred to a 250.00 mL…

A: Here, by atomic absorption spectrophotometry the amount of copper (Cu) has been measured We know…

Q: Sally obtains a standard calibration curve for their assigned food dye by plotting absorbance versus…

A: Step 1: Relate absorbance to concentration using the calibration curve equationThe calibration curve…

Q: lassify the statements based on whether they describe the method of standard addition, the method of…

A:

Q: In the HQS-Mg fluorescence part of Lab 6, a calibration curve is made of fluorescence intensity vs.…

A: The objective of this question is to show the experiment, a series of standard solutions are…

Q: A peak clutes from a column at 29.1 min, with a width at half height of 13.8 s. How many theoretical…

A: The number of theoretical plates is a measure of the efficiency of a chromatographic column & is…

Q: A sample containing an unknown quantity of cadmium in a water sample gave a reading of 1.4 in an…

A: Given data: Reading for unknown water sample = 1.4, Concentration of known sample = 2 ppm, Reading…

Q: solution with %T = 75.9% has an absorbance equal to: A = log (1 T) T= (% T 100)

A: Relationship between absorbance and transmittance, A = - log T And Relationship between absorbance…

Q: Atomic absorption spectroscopy was used with the method of standard additions to determine the…

A: To determine the concentration of cadmium in the waste stream sample using the method of standard…

Q: calculate the concentration of analyte in the ORIGINAL sample in ppm. Report to 1 decimal place…

A: A 10.00 mL aliquot of the unknown was placed in a 100.0 mL volumetric flask and made up to the mark…

Q: The concentration of hydronium ions and hydroxide ions can vary widely in a solution, easily from 1…

A: The logarithm of a number is the power to which 10 must be raised to equal that number.

Q: What is limit of detection? What is standard deviation?

A: To determine: limit of detection and standard deviation