Fourth Problem: Any type of beam loaded with uniformly varying load.

Q: 3-5.7. A beam supports a load varying uniformly from an intensity w lb/ft at the left end to p lb/ft…

A:

Q: Learning Goal: To use the vector cross product to calculate the moment produced by a force, or…

A: A) Given,

Q: Examples Example (1) : The screw eye in Figure is subjected to two forces, F, and F,. Determine the…

A:

Q: From Figure, P is directed at an angle a from x-axis and the 200 N force is acting at a slope of 5…

A:

Q: An artist has designed a bell using a long piece of pipe as the vibrating sound source. The pipe has…

A:

Q: This plate (with mass, m=500kg) is supported by 3 vertical perpendicular cables attached at the…

A: Solution:

Q: is equivalent to

A:

Q: Problem 2) A pipe configuration is presented in the figure below. The support at point A is fixed.…

A:

Q: T1 T2 T3 30 30% T4

A: Given:The tensions  and  are equal.The diagram for the problem is given below;

Q: 13. Consider the system of planar rigid bodies as shown in figure. (a) Construct the free body…

A:

Q: Sketch a free-body diagram of each element in the figure. Compute the magnitude and direction of…

A: To find: The forces in each element. FBD: The free-body diagram is shown below.

Q: A vertical bar of length L with mass of 40 kg is rotated vertically about its one end at 40 rpm.…

A:

Q: 3) A point mass is attached to one end of a beam levered against a spike which acts as the pivot.…

A:

Q: Question 5 A crank arm consists of a sold segment of length bi and diameter d, a segment of length…

A: Apply force equilibrium condition along x direction.

Q: A-B = А. В.

A: Given: A→=13B→=23θ=100°To determine:A→.B→

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.