For the simply supported beam shown and its cross-section, and considering the values L, and t assigned for each student as in the table provided. Answer the following questions. (a) Locate the most critical point on the beam (i.e what is the distance from point A, and where exactly on the cross section). (b) Draw shear moment diagrams and perform complete analysis for expected points to get the point with the maximum principal stresses and the maximum shear stress and draw the oriented elements for those stresses. 2 kN

Q: Attention !!!! Please clarify this . When they go to calculate both the normal stress of the bolt…

A: Step 1: Step 2: Step 3: Step 4:

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: - 750 mm G. D 225 mm F 900 mm E 1200 mm-

A: Find the reactions at each joint and force in rope.

Q: The metal bar shown is subjected to a 4000 lb. tensile force. What is the tensile stress in the bar?…

A: Given data D=0.5 inF=4000 lb

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: Given parameter,Yield stress for channel shaped section,           Yield stress for the rectangular…

Q: Determine the shear stress Try that acts at point A. Express your answer to three significant…

A: Solution: GIven Data: d = 40 mm Fx = 1350 N Fy = 540 N Fz = 920 N

Q: 1. The built-up beam pictured on the right is subjected to an internal moment of M = 75 kNm. a) At…

A: *The internal moment acting on the structure is M=75 kNm. *The total length of the T section is…

Q: The rod has a diameter of 40 mm. It is subjected to the force system F₂ = 1300 N, Fy = 600 N, F₂ =…

A: The rod diameter d =40 mm = 0.04mThe force systemFx= 1300NFy= 600NFz= 900NFindThe Normal stress act…

Q: P1: If the coefficient of static friction at A is us= 0.2 and the collar at B is smooth so it only…

A: Given   Coefficient of friction = 0.2                  Diameter, d = 100 mm = 0.1 m…

Q: What is the Moment–Curvature Relationship?

A: Moment curvature relationship is used to determine the load and deformation behavior for a concrete…

Q: What is the Share Force (in KN) at a point 0.6L (where L is the length of the plank) given that: F1…

A:

Q: Determine the distance to the neutral axis from the top surface of the cross sectional shape shown…

A: Given: The cross-section area is given below,

Q: dimensions, L1 = 6.8 in and L2 = 3.3 in, determine the polar moment of the weld about its centroid.…

A:

Q: -61.M Figure P1-61 shows the shape of a slug from a sheet of aluminum 5.0 mm thick shear stress in…

A:

Q: 0.54 kN A 200 mm C A L 1.35 kN D E 500 mm 400 mm 0.54 kN B -300 mm

A: Given

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.