For the network in Figure 2, show the number of steps which are needed to send a packet from PC1 to PC2? Then show the following information in packet header for every step: (1) Source MAC. (2) Destination MAC. (3) Source IP. (4) Destination IP MAC-0:0:0:2 IP= 192.168.1.2 MAC-0:0:0:3 IP- 192.168.2.2 2901 Router 1 2901 Router2 MAC=0:0:0:4 MAC=0:0:0:1 IP- 192.168.1.1 IP= 192.168.2.1 PC-PT PC1 PC-PT PC2 Figure (2).

Q: The Data field in both figures signifies the data from the application layer while the other fields…

A: Given that, Maximum transmissible unit or data packet size in transport layer= 1000 bytes Total…

Q: 2b AS 2 2a 20 AS 1 AS 3 AS 5 5d AS 4 5b

A: a)The answer is eBGP. Reason: in this case eBGP is inter-routing protocol.Through OSPF , AS3 is…

Q: In the figure, the communication link capacity between Router 1 and Router 2 is 3 Mbps. If a 2 Mbps…

A: Objective: Two routers are obtaining data traffic through a common channel. The channel capacity is…

Q: ridges are empty. List all ports on which a packet will be forwarded by bridges B1 and B2 for the…

A: We have a connection of multiple nodes with bridges and hubs. Here we need to find the path of ports…

Q: The figure shows a TCP transaction. Assume Host A always has data to send, and each packet has size…

A: A)   Here since 2nd packet is lost,   ACK#1 = ACK#2 = ACK#3 =100 (sequence number of 2nd packet)…

Q: Suppose there is exactly one packet switch between a sending host and a receiving host. The…

A: In any data transmission process, the end-to-end delay refers to the total time spent for…

Q: Consider the network depicted in the below figure. Suppose that router R1 receives a packet Pkt1…

A:

Q: Consider a network with 4 links between two hosts where the maximum allowable packet size is 1000…

A: Answers:-   1st method:-   To calculate the total time it takes to send 6000 bits from one host to…

Q: Explain how many headers an HTTP packet will most likely have as it travels the network between two…

A: Does each network device cross the box: In practice, packets include multiple headers, each of which…

Q: Suppose there is exactly one network device X between a sending host (host A) and a receiving host…

A: Option-The provided the choice is for sending from the source host to the network device probably…

Q: Refer to the figure below. The IP and MAC addresses are shown for nodes Petra and Bhoy, as well as…

A: A network is a system where computers, devices, or nodes are linked together for communication and…

Q: Q5: In following Figure, assume that the communication is between a processes running at Computer A…

A: Given:

Q: Suppose the MTU size is 1300 in an IPv4 network, if a packet size (with packet ID 15934) is 3400…

A: Below i have answered:

Q: A. What is the source/destination network- or link-layer address at the location (3)? B. What is the…

A: An IP address is a unique identifier assigned to each device connected to a network that uses the…

Q: Assume that there is a single router between Alice's host and Bob's host. The bandwidth of the first…

A: ANSWER:-

Q: The maximum packet size (Maximum Transmission Unit or MTU) of an IP packet including IPv4 header on…

A: Here is the explanation regarding the maximum packet size.

Q: Suppose there is exactly one packet switch between a sending host and a receiving host. The…

A: The following information is provided: R1 denotes the transmission rate between the sending host and…

Q: 3. An unencrypted DNS response packet captured by Wireshark on a DNS client has 3 protocol headers…

A: Given that An unencrypted DNS response packet captured by wireshark on a DNS client packet has 3…

Q: Given the network address 32.0.0.0/3, develop a scheme for 1000 subnets with at most 2000 hosts…

A: Given: network address 32.0.0.0/3, develop a scheme for 1000 subnets with at most 2000 hosts each.…

Q: In this question we consider a router that has to fragment an IP datagram to make it fit into a link…

A: Here, we are going to find out the offset value of second datagram after fragmentation. MTU is…

Q: The figure below shows a network of four clients: A, B, C, and D, connected through a router, X. The…

A: To calculate the total delay for each packet, it needs to consider both the transmission delay and…

Q: given to IP for C n MTU of 200 Byt

A:

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: A routing table is provided for the information.

Q: A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of…

A: Answer: a. 5h/(5h+M)

Q: Given a scenario where there three routers R1, R2 and R3. R1 is connected to Switch1, then Switch1…

A: The solution for the above-given question is given below:

Q: A router receives a packet from another network for device in the local network that the router…

A: Solution:

Q: A network system has 5 protocol layers. Applications generate messages of length M bytes. At each of…

A: If a netwrok system has ‘n’ protocol layers. Applications generate messages of length ‘M’ bytes. At…

Q: A network system has 4 protocol layers. Applications generate messages of length M bytes. At each of…

A: Data given in question:- Number of protocol layers = 4 Length of messages generated = M bytes Size…

Q: Propagation Nodal Queuing Transmission processing (waiting for transmission) Assume the two hosts on…

A: (A). Packet Length (L) = 1200 bytes = 8 x 1200 bits Transmission rate (B) = 3 Mbps = 3 x 106…

Q: The first of these packets is from your computer to the DHCP server telling it to release the lease…

A: This is because the address of the MAC is how machines interact on a subnet. As computer A sends…