For the loaded beam shown in Figure 3, it's required to:. (a) Calculate the reactions at the roller support B and the Pin support C, (Hint: draw the beam to scale 1: 50) (b) Draw to scale Icm:5KN the shear force diagram. (c) Draw to scale 1cm:10KN.m the bending moment diagram. 15 kN 4 kN/m 22 ΚNm E 2m 4m Figure 3.

For the loaded beam shown in Figure 3, it's required to:. (a) Calculate the reactions at the roller support B and the Pin support C, (Hint: draw the beam to scale 1: 50) (b) Draw to scale Icm:5KN the shear force diagram. (c) Draw to scale 1cm:10KN.m the bending moment diagram. 15 kN 4 kN/m 22 ΚNm E 2m 4m Figure 3.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Determine the maximum shear in kips for the beams shown below using the method of consistent deformations. Select the reaction at the interior support to b the redundant. two decimal
A solid 0.66-in.-diameter shaft is subjected to the torques shown. The bearings shown allow the shaft to turn freely. Determine the shear stress magnitude in shaft (1). 10 Ib-ft 50 lb-ft 70 Ib-ft 30 lb-ft 1594psi 2126psi 1981psi 1786psi 2936psi
Determine the reaction at the support of the beam/frea, shown in the figure using the Force Method Analysis. Draw the shear and bending moment diagram
Handwritten pls. I believe the answer is 16.7
Beam PORS as in Figure Q1 is pin connected at P and S. (a) Develop the shear force (V) and bending moment (M) as function of x for section RS, taking point P as the origin. (b) Draw the shear force and free body diagrams of the entire beam and indicate all important points on the diagrams. [Note: All calculations must be clearly shown] 40 kN 10 kN/m P S 20 kN.m 4 m 2 т 4 m Figure Q1
Draw the Bending Moment diagram for the frame shown below
The beam shown in the figure has three supports and a distributed load is applied to everything long with an intensity q = 5 Klb / ft. Determine the reactions at supports A, B, and C.
4.)show complete solution, final answer should be in two decimal only, i will automatically give upvote.
ANSWER TYPEWRITTEN FOR UPVOTE. SKIP IF YOU ALREADY DID THIS OR ELSE DOWNVOTE
please answer correctly