For the figure shown below. Determine the force exerted on the bar ABC by the cylinder with a mass of 33 kg in the direction towards point B? 20° 45° 2m a 1m 1m Determine the force in the cable? Answer: Determine the normal force at section a-a in the direction towards the cross-section? Answer: Determine the shear force at section a-a in this direction Answer: Determine the bending moment at section a-a in a counterclockwise direction? Answer:

Q: Nut 17.0 N 37° 25.0 cm

A: The text provides the following information:The force applied to the wrench is 17.0 NThe distance…

Q: Rotate the objects shown below by the indicated amount. Sketch the result in the space provided.…

A: Find Rotate the object about the given axis.

Q: State the difference between the eutectic and eutectoid points.

A: Eutectic point: In the iron carbon phase diagram at 2 percentage of carbon is called eutectic point.…

Q: 3.00- 1.25-

A:

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: Referring to the figure, calculate for the following:a) Component of the 800 N force in the…

A: Step 1: Step 2: Step 3: Step 4:

Q: I didn't understand how you fond the angle teta

A: For solution refer below images.

Q: What is the maximum magnitude of the bending moment caused by force G? If none, enter zero. Do not…

A: It is required to determine the magnitude of the maximum bending moment by the force G.

Q: Rotate the objects shown below by the indicated amount. Sketch the result in the space provided.…

A: the solution is provided in the picture attached below.

Q: R.75 00.63 THRU $5 01.123 0.250 E 1.38 0.63 mm radius hole partially through the part 0.63 mm radius…

A:

Q: Locate the center of mass of the homogeneous solid block. 250 mm 200 mm 150 mm 100 mm 150 mm 150 mm…

A: Given:-  To Find:-  Center of mass of the homogenous solid block

Q: - х a = 6 in b = 0.7 in C = 2 in

A:

Q: Calculate y, the distance from the base to the position of the Neutral Axis of the T-section shown…

A:

Q: In an experiment, an engineer wants to compare the torsional capacity of two shafts of the same…

A: Given data is

Q: 2? Would it be .4070? Or would it be .4070/.4

A: 2) it would be .4070/.4065

Q: 1-8. Determine angles a, b, and c (Figure P1-8). a 35° FIGURE P1-8

A:

Q: QUESTION 2 A shaft rotates at 300 rpm. 1), If it carries a spur gear that delivers 5 hp to a mating…

A: Given: N=300 rpm

Q: What is the direction of the edge formed between the intersection of (211) and (102)?

A: