For the circuit shown in the following figure with Is = 150UA, Boc = 75, Vcc = 18v, and Rc = 1kn, find: (a) the Q-point (Vce and Ic) and (b) the saturation value of the collector current.
Q: f the density and atomic mass of copper are respectively 8.80 x 103 kg/m3 and 63.5 kg/kmol (note…
A:
Q: Given that the density of aluminum is 2.7x103 kg/m , find the drift speed of the conduction…
A:
Q: Consider a resistor of resistivity 4.12 × 10-8 Ω • m. If an electric field of 19 V/m is applied…
A: Electric field and resistivity relation is E=ρJ Here ρ is resistivity, E is electric field and J is…
Q: (a) In the figure what value must R have if the current in the circuit is to be 0.96 mA? Take &₁ =…
A: Given data: Current (I) = 0.96 mA = 0.96 ×10-3 Aε1 = 2.9V and ε2 = 4.7Vr1 = r2 = 3.3 ΩRequired:The…
Q: Silicon is a semiconducting metal with a resistivity of 640 . m. HINT (a) Determine the current per…
A: Given value--- resistivity = 640 ohm m. voltage = 4.92 V. length = 1.79 mm. We have to find---…
Q: A 15.5 V battery is connected to a 102 Ω resistor. Neglecting the internal resistance of the…
A:
Q: metal object having a length (10m), cross section area (0.5 mm2), and resistance (0.52) is connected…
A: Temperature , room temperature , T = 298 K To find = Thermal velocity
Q: pered section. The wire is copp= = a current. Assume that the curr rion area through the wire's…
A:
Q: Nichrome alloy has a resistivity of 110 × 10−6 Ωcm. From a roll of nichrome wire of 2.5 mmdiameter,…
A: Given, Resistivity ρ=110×10-6 ohm cm diameter=2.5 mm radius r=1.25 mm L=1 Area of the roll of…
Q: Consider a resistor of resistivity 1.59x10^-8 ohms•m. If an electric field of 19 V/m is applied…
A: Let the resistivity of the material of the resistor ρ, the electric field applied on its ends be E,…
Q: (A) If the resistor color code has measured values between 7.79 2 and 8.61Q, what is its nominal…
A: There are many types of resistors used in electronic appliances, both fixed and variable. The most…
Q: Consider three resistors; 0.5 kΩ, 5 kΩ and 7 kΩ, connected in parallel with a power supply of 5 V.…
A:
Q: 1. Current flows in circuit are governed by Kirchoff's laws. It states that the algebraic sum of the…
A: Given equations are: I1+I2-I3=02I1+5I3=62I1-4I2=4 Initial estimates: I1=1.2 I2=-0.5I3=0.8…
Q: A wire with cross-sectional area "A", length "l" and conductivity "σ" is subjected to a potential…
A:
Q: If the density and atomic mass of copper are respectively 8.80 103 kg/m3 and 63.5 kg/kmol (note…
A:
Q: A phosphorus-doped silicon wafer for an electrical component has an electrical resistivity of 8.33 ×…
A: Given information: The electrical resistivity of phosphorus-doped silicon, ρ=8.33×10-5 Ω·m The…
Q: (a) In a section of wire of cross sectional area A, length Ax, where the charge carriers with charge…
A:
Q: 5 The resistivity of Nichrome is about 100 times that of copper, a typical good conductor. a copper…
A:
Q: In a 100-m-long conductor of cylindrical cross-section (radius ro = 5 mm), the axial current density…
A: Given that, Length of conductor, l=100 m Radius, r0 =5mm Axial current density, J=z^2 A/m2…
Q: Suppose you wish to fabricate a uniform wire from a mass m of a metal with density Pm and…
A: The Resistance is given by R=ρlA where ρ is the resistivity of the material…
Q: SA: A solar cell operating at a temperature of T=300K has the following specifications T= 5x10° Sec,…
A:
Q: A straight, cylindrical wire lying along the x-axis has a length L and a diameter d It is made of a…
A:
Q: Consider a resistor of resistivity 4.84 x 10-80.m. If an electric field of 18 V/m is applied across…
A: The resistivity is given as, ρ=4.84×10-8 Ω·m, The strength of electric field is given as, E=18 V/m,…
Q: what is the CB ratings Icb (market available CB's ) of a distribution board for a group motors as…
A: Option b is the correct answer
Q: Figure Q.1(a) shows a DC voltage, Vab connected to a series of three resistors structed using…
A:
Q: A plastic tube of length 1=25 m and section diameter D=4 cm is immersed in a silver solution, and a…
A:
Q: A rod of semiconducting material of lenght L=3 m and cross-sectional area A=4.5 mm^2 lies along the…
A: Ohm's law states that the current flowing through a conductor is directly proportional to the…
Q: A hollow cylindrical tube with a rectangular cross section has external dimensions of 0.5 in. by 1…
A: The area of cross section of the tube is A=L1W1-L2W2=1×0.5-1-2×0.050.5-2×0.05A=0.14…
Q: ake into account a wire made of aluminium with radius 0.001m. If there is one conductium electron…
A:
Q: via: Ohm's Law states that across a resistor, the voltage of, resistance of, and current through the…
A:
Q: 1. What length of copper (p=1.78 x 100m) wire 1.2 mm in diameter is needed to make a 20-Q resistor…
A: Part(a) Length of copper wire. part(b) Length of Nichrome wire. Given, ResistivityρCu of copper…
Q: A cylindrical rod of semiconducting material with length L and cross-sectional area A is doped so…
A: A cylindrical rod of semiconducting material with length L and cross-sectional area A is doped so…
Q: An axial dipole-dipole configuration is given below. (a) What is the geometrical factor for the…
A:
Q: Pure silicon crystal of length 1(0.1m) and area A(10 m²) has the mobility of electrons (₂) and holes…
A:
Q: A nichrome rod of length LN = 78 cm is connected in series (end to end) to a carbon rod of length LC…
A:
Q: Example 3: The charge flowing through the imaginary surface in Fig. 7 is 0.16 C every 64 ms.…
A: Since you have asked multiple questions, we will solve the first question for you. If you want any…
Q: Resistor 10 Q Resistor 51 Q Light bulb (first 3 pts) Light bulb (last 10 pts) Slope (V/A) 9.896V/A…
A: Ohms law is given by the equation V=IR where V is the voltage, I is the current and R is the…
Q: iven that the density of aluminum is 2.7x10³ kg/m³ , find the drift speed of the conduction…
A: Given:- The density of the aluminum is 2.7 X 103 kg/m3 Current I= 10 A Cross- sectional area A=…
Q: If R Ro[1+ a(T-To)], find: = (a) the temperature coefficient of resistivity, a, in terms of R, Ro,…
A:
Q: using the transfer function Vo(s)/V:(s) using Simulink and matlab For C= 1.4 mF, L= 0.06 H, R1 = 120…
A:
Q: When applying an electric field of magnitude 20.07 megavolts per meter across a resistor made from…
A:
Q: The ratio arms of the Kelvin bridge (shown) are R1 = R2 = b = a = 350 12. The galvanometer has an…
A: Step 1:(A) The deflection of the galvanometer (in mm):The deflection of the galvanometer can be…
Step by step
Solved in 3 steps