Answered: For the circuit shown in Figure below…

For the circuit shown in Figure below find the reading of the idealized ammeter if the battery has an internal resistance of 3.26 92. 25.0 V + 45.0 Ω ww 18.0 Ω ww 15.0 Ω A

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter3: Electric Circuits

Section: Chapter Questions

Problem 11RQ

See similar textbooks

Related questions

Q: determine the currents and the voltages with kirchhoff's law 2200 A 0.3 1502 A 4V 200N A

Q: 1. 500 VA -120/240 -120/240-60HZ 1) Turns ratio (n) 2) Isec 37 I pr.

A: The apparent power, The voltage ratio, 120/240 VThe frequency,

Q: Three 47.1 ohm resistors and three 17.1 H inductors are all in series with a 37 volt battery and a…

Q: The conductance of a 9230 resistance is a) 1.08 * 103 mho b) 1.08 * 104 mho c) 1.02 * 103 mho d)…

A: The value of the resistance is given as R=923 Ω. The corresponding value of the conductance (in mho)…

Q: In a resistive load, the current angle

A: In the question, The current angle when load is resistive type.

Q: Match each type of transducer with the corresponding physical phenomenon, law, or property where it…

A: We are given with the following choices: Lorentz law Charge Faraday's law Ohm's law Capacitance…

Q: Determine the required peak reverse voltage rating in the following circuit. R₁ 1 ΚΩ www Vs 200 Vpk…

A: Peak Reverse voltage: Peak reverse or peak inverse voltage is the maximum voltage across the diode…

Q: Give me right solution according to the question. Determine Rout (in kΩ) for the figure.

A: By small-signal analysis, we will find out output impedance.

Q: 3. Describe why Noise Margin is there in Digital Circuits and what will happen if we do not involve…

A: Since there are multiple questions uploaded within the same question, so solving the first question…

Q: Calculate the value of RB in ohms. at VCC=19 V, IB=27 uA, and VC=6V and B=65

Q: In the figure below, the voltage reading of the multimeter (Pr1) will be -5 V if V, 10 V and V, 5 V.…

Q: 7V - www 31 31 um 12 ↓ 212 D₁-12 wn 21 fv J 13 1₁-13 2^ www 22 avi 1₁-12-13 31 1₁-12-13

Q: Use the circuit shown below to solve. a) Find the numerical value of vx. b) Find the power delivered…

A: KIRCHHOFF’S VOLTAGE LAW: Kirchhoff’s voltage law (KVL) states that the algebraic sum of all…

Q: The maximum power that can be generated by a wind turbine is called Select one: O Cut-in Power O…

A: Rated power is the maximum power that any plant will generate.

Q: What is the voltage will produce 3A through a circuit that has 15ohms of resistance?

A: We need to tell about voltage .

Q: Three resistance 14. 5 Q, 25.5 Q and 60 Q are connected in series across 200 V. What will be the…

A: Given: Three resistances are connected in series, R1=14.5 ΩR2=25.5 ΩR3=60 Ω Supply voltage, Vs = 200…

Q: 10 0 45 Q 25 Ω L00 V 20 Q ww

Q: Figure 5 shows a current series feedback amplifier. The sampled current signal is the output…

Q: In figure below, The potential across the resistor is equal to: L 650 mH 120 V 60 Hz R472 :1pF

A: In parallel connection voltage is equal among all branches.

Q: In the figure below, explain in what situation ammeter A reading will be nonzero.

A: Given : In the circuit they have mentioned transformer with both primary and secondary windings.…

Q: How much resistance must be inserted in series with a 0.96-H inductance to limit the current to 0.25…

A: To solve above problem, one should have basic idea about working of AC circuits. Above given circuit…

Q: Determine the output voltage Vout of the summing amplifier shown in Figure 6 below. 10 K 0.1V o 22 K…

Q: Two 115-V incandescent lamps A and B are connected in series across a 230 V source. If lamp A is…

A: According to question diagram will be,

Q: lout Q1 BO Bi, Q2 E Figure 2 Figure 3

A: We will find out current gain for given circuit .

Q: Two (2) 115 V incandescent lamps A & B are connected in series across a 230 V source. If lamp A is…

A: v= 115 volts A is rated 75 watts B is rated 50 watts.

Q: If a circuit has a resistance of 3002 and a series inductance of 5002, what is the relationship…

A: The solution is given below

Q: When the voltage source is turned off in a simple circuit consists of a resistor and an inductor,…

A: Given, When the voltage source is turned off in a simple resistor and inductor (RL) circuit, the…

Q: How much energy must a 24-V battery expend to chargea 0.45 µ F and a 0.20µ F capacitor fully when…

A: Given:- Value of battery=24 V Capacitor C1= 0.45 μF Capacitor C2 =0.20 μF We have to find required…

Q: A direct current (DC) of 4A flows into a previously uncharged 20 pF capacitor for 3 ms. Determine…

Q: An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have…

A: An ammeter design If half scale current = 0.5mA Internal resistance Rm= 50 ohm What is value of…

Q: (A) 0.25 uF 10V 2uF 4uF (B) Figure 3: 3. In Figure 3 the capacitors were discharged before being…

A: NOTE: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Question

For the circuit shown in Figure below find the reading of the idealized ammeter if the battery
has an internal resistance of 3.26 9.
25.0 V
+
45.0 Ω
ww
18.0 Ω
www
15.0 Ω
A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction about the given question

VIEW

Step 2: Calculation for the reading of ammeter

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
How much resistance must be inserted in series with a 0.96-H inductance to limit the current to 0.25 A from a 120-V 60 Hz power line?
A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
The conductance of a 9230 resistance is a) 1.08 * 10-3 mho b) 1.08 * 10-4 mho c) 1.02 * 10-3 mho d) 1.02 * 104 mho
In the given figure, the potential difference between points P and Q is – 2A 20 Pe ww ww 80 10V
An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have internal resistance of 50 (2 and half scale current of 0.5 mA. Ra and Rb will be --- ohm Ra= 0.05005 , Rb=0.01001 Ra = 0.04004 , Rb = 0.01001 Ra= 0.05005 Rb= 0.04004
0.5) A full-wave rectifier with L-C filter is shown in figure 3. If the resistance of the load is 2002, detemine the ripple factor. 100mH 52 Vs 470 µF RL Vs = v2 5 Sin 314t %3D
subject: Fundamentals of Electrical Circuit Please provide the answer with clear solution.
In volt ampere characteristics the current increases with voltage a. Equally b. Sinusoidal c. Unequally d. Exponentially
Q2) Consider the circuit in Figure (3), and answer 3 branch only. a) What type of circuit is this? b) What is the total peak secondary voltage? c) Find the peak voltage across each half of the secondary. d) Sketch the voltage waveform across RL. 4:1 120 V rms RL 1.0 k2 D2 eelee
ANSWER QUICKLY
2. A wire carries a current i 3cos314t A. What is the average current over 6 seconds?