Q.18: For the circuit shown if Vs=5020°Vms. findthe value of coupling coefficient "K" and put162the dots on the coils, when the consumedVs+$52$10 2power at (100) resistor is (40W)?(Ans.: 0.823 & series opposing)4.67 2wwQ.19: For the circuit shown:12JIQ

Answered: Image /qna-images/answer/a0047a81-2289-4ea4-b47d-dfcefc6d891a.jpg

Answered: For the circuit shown if Vs=5020°Vms.

Engineering

Electrical Engineering

For the circuit shown if Vs=5020°Vms.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Consider a DVR compensated single phase system as shown below. a) Without DVR, find the load…

Q: Q/2/Determine the input impedance (ZT) and current (IT) of the series network consist of (R = 50, X₁…

A: In this question, We need to determine the equivalent impedance ZT and total current IT Also…

Q: In the circuit given on the side Ra=Rb=Rc=Basic frequency of 13 Ohm loads it is powered by an AC…

A: In the given circuit diagram,

Q: The ac/ac shopper fed from a single:phase V(t)=250 v2 sin(62.832t) V AC Source is compressed with…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Zener Diode Applicatio 6. Determine the minimum input voltage required for regulation to be…

A: In this question We need to determine the minimum input voltage required for established the given…

Q: Discuss the methods used to minimize inductance in transmission lines and their effects on signal…

A: Twisted Pair Configuration: Twisting adjacent signal lines in a transmission system helps minimize…

Q: An equilateral transmission line (3-4) has a corond Power Loss of 53kw at lo6kv P and a loss on 98kw…

Q: A transmission line delivers 1200MW at 500kV and 85% power factor. The series impedance of the line…

Q: A 3 phase 170KV, 50 HZ transmission system is 170km long. The resistance is 0.5Ω/km/phase,…

Q: Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one end by…

A: Given: Characteristic impedance, Z0=50 Ω Load impedance, ZL=j50 Ω

Q: es could the Network Laws have over the simple Series and

A: The various network laws such as the KVL and the KCL is used to determine the current and voltage of…

Q: [Q8] Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one…

A: In this question we need to find a VSWR of the given transmission line.

Q: A high-voltage transmission line with a resistance of .39ohms/km carries a current of 1030A. The…

A: The performance of a power system depends mainly on the performance of transmission lines in the…

Q: For a transmission line, the value of the open circuit and short circuit impedance are 100 ohm and…

A: If ZOC is the open circuit input impedance and ZSC is the short circuit input impedance of a…

Q: 11.a. A fiber link has a polarization mode dispersion of 4.2 ps/√km. The fiber link is 5 km. What's…

A: This is a basic problem of opttical fiber communication The solution is given below

Q: Given a telephone transmission line of 100 mile long has Zo=685-j92Q, a=0.00497 neper/mile and…

A: A telephonic transmission line is used to transmit data from one point to another point. The…

Q: The value of symmetrical short circuit current is ___________________ at time t=0. Zero Minimum…

A: In this answer let us discuss the concept of short circuit current and try to find its value at t=0.

Q: With the conditions given below, if voltage is v(t) = 8sin4000pit mV, with the osciloscope, What…

Q: For a single phase ac voltage controller/chopper, which is d series R (=8[Ohm]) and L(=30 [mH])…

Q: For a single phase ac voltage controller/chopper, which is designed by using thyristors, with the…

A: In this question we need to find a average power absorbed by the load

Q: e-phase 50 Hz transmission line is 160 km long. A load with a compl VA, 0.8 lagging power factor at…

Q: an overhead line is connected to a terminal apparatus through a length of single phase cable, the…

A: Types of waves Incident wave Reflected wave Refracted wave

Q: In the circuit given on the side Ra=Rb=Rc=Basic frequency of 13 Ohm loads it is powered by an AC…

A: In the given circuit diagram,

Q: A long transmission line of 370 N surge impedance is connected to two cables each of surge impedance…

A: According to question we have to calculate the value of junction voltage, current wave and voltage…

Q: For a single spine field, treated with 6MV (dmax = 1.5cm) to a depth of 5cm at 100cm SSD. What is…

A: Mayneord F factor is used to correct for the change in beam size when extending the SSD for a…

Q: What is the location of the dominant poles of a closed-loop system which is required to have step…

Q: The char. impedance of the trans. line is 50-Ohm and the resistance of it is 0.1Ohm/meter. What will…

A: For the distortion less transmission line the attenuation constant is independent of the frequency.…

Q: Normalized admittance values zL= 0.4 - j0.3 with two load impedances connected in parallel with a 50…

A: To find the distance of voltage maxima and minima, we need to first calculate the wavelength of the…

Q: [j0.11565 j0.045807 Ljo.04580 j0.13893 between buses 1 and 2, what is the new Zpus? A two-bus system…

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: 1. Discuss the influence of the bypass, coupling, internal, and stray capacitances on the frequency…

Q: Q1) For the circuit shown below, Vab = 240415°, Zy = (12 + j15) 2, the phase sequence is positive.…

A: given data Vab=240∠15 Zy=12+j15

Q: a line characteristic impedance 600 ohm and 3 db loss is a half wavelength .it is fed by a source of…

A: A line characteristic impedance 600 Ω and 3 dB loss is a half wavelength. It is fed by a source of…

Q: a) Draw the schematic diagram of LVDT. Explain the operation of the same.

A: As per Bartleby guidelines, we are allowed to only solve one question please ask the rest again.…

Q: lectrical transmission line cable is su O N/m and the maximum sag is 18m,

A: Given: Supported between tower apart length = 150m Cable weight (w)= 30N/m Maximum sag (h)= 18m

Q: Q.NO. 1: We have a variable resistive load and a DC source as given in the following circuit. The…

A: Given data, DC Voltage VDC=2500 V Maximum current Imax=100 A Load resistance RL=10 kΩ to 5 kΩ

Q: O What is the advantage of using graded index fiber over step index? Explain with diagram.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The ladder diagram of AND gate will have two Normally open contact in series. Select one: True…

A: Given Ladder diagram of AND gate have two Normally open contact in series

Concept explainers

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.

Question

Q.18: For the circuit shown if Vs=5020°Vms. find
the value of coupling coefficient "K" and put
162
the dots on the coils, when the consumed
Vs+
$52$10 2
power at (100) resistor is (40W)?
(Ans.: 0.823 & series opposing)
4.67 2
ww
Q.19: For the circuit shown:
12
JIQ

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 132 Kv, 50 Hz, 3-phase tensmission line delivers a load of 5omw at 08 lagging Pf. the transmission line have: A-D: 0 95 Lu" 190 C-0. Ool5 B-96 using Nominal Tto Calculade: regulation of the line and charging Curent?
Answer part no. d , e, f, g
3) Pina the . OTFT of ) x(n)= a pmd
Don't copy from internet
i need the answer quickly
Dc circuit analysis : nodal, loop, and superfositiron a) In the Circuit given, deactivate the GV Source byusing Cny DC analysis calculate lo Cnd Vo due to the technique, 12V Sourd. b) Deactivale the DC Circuit analysis Vo 12V source and use any tech niquet calculate the to and due to the lev source. ) Calcu la le the nit lo and Vo due to both Sources.
-d.com/webapps/assessment/take/launch.jsp?course_assessment_id=_168587_1&course_id=_69233_1&content. & A Seanav videos .Lecture Recording... 4 My Drive - Google.. * Question Completion Status: Problem Continues: In the circuit below, calculate the phase angle of the phasor current through the inductor L2 in mA. 4.7 KO -j8 KO R2 L = 20.34125.6° mA 4 KQ 4.7 KO C1 R3 R1 L1 ll j1 KO j8 KO ll E L2 Save All Answers Save and S 57°F Clear
Where does a phase replicating VFD derive a third phase?
Derive the expression for the average and rms load voltage for a three phase HWCR operating with an RL type load. ? What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be ideal. Supply voltage is 330 sin 314t. Also calculate the RMS power .?
Determine the charging current (Ic) at 50 Hz of a single-conductor EHV transmission line having voltage to ground of 500 kV and capacitance per unit length of the conductor to ground 2 nF/km.
A 60-2 transmission line is connected to a 75-2 resistive load. If the incident voltage is 5 V rms, then the reflected voltage is: a) -1.026 Vrms. b) -0.832 Vrms. c) 0.556 Vrms. d) 1.569 Vrms. e) 2.320 Vrms.
Blue is the numerical answer, I need a detailed solution.