For a system with total complex power of 10000 + 7500j VA, nominal voltage of 250 angle 30 deg. and 50HZ system frequency. Vrms. Determine the value of the capacitor needed to raise the power factor to 0.9 lagging. 233 uF 256 uF 245 uF

Q: The figure below shows a periodic voltage waveform. Determine: a) Period  b) Frequency  c)…

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: a capacitor C is connected in parallel to a resistor R across a 100V, 100Hz supply. The supply…

A:

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Square voltage wave

Q: In an electrical installation, the active power is 500 kW and the power factor is 65% (lagging). How…

A:

Q: A 60 Hz sinusoidal voltage with an RMS value of 440 V is applied to a TRIAC voltage regulator. The…

A: it is asked to find the output DC voltage of given TRIAC voltage regulator

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Given oscilloscope peak to peak voltage is 10Vp-p at certain frequency. Hence maximum voltage Vm=5V…

Q: A sinusoidal current has a rms value of 3 amperes, its peak to peak value will be 2.1213 amp 8.4853…

A: In this question we will find peak to peak value of sin wave....

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and…

A: time division - time/cm=0.2ms/cm voltage division volt/cm=1V/cm

Q: Change in DC voltage if capacitor increased to 100 F Vinm220 v f= 50 Hz V. R=10KO

A:

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 5ms/cm and the…

A: Here each square box is 1 cm x 1 cm And 1 cm length is divided into 10 parts.

Q: Ratio of dc output voltage to rms voltage is a. 0.318 b. 0.637 c. 0.45 d. 0.9

A: In half wave rectifier Vdc= Vm/π Vrms = Vm/2

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: Given: Vi = Vpeak Sin wt V Vpeak %3| = 5 V With the ideal foward voltage = 0.7V, draw the waveforms…

A: It is given that: V1=VPeak Sin ωtVPeak=5VRL=1KΩVD=0.7V

Q: The 60 Hz AC source and 240 V rms voltage provides a power of 5000 VA

A:

Q: R 200 Vs 120Vrms }60HZ 0° C. -j10 Calculate the magnitude of the voltage drop across the inductance.

A: Using voltage division rule we will find voltage across inductor.  Given inductive reactance = j5…

Q: 22. An inductor coil in series with an ammeter is connected across (to) a 120V, 60HZ rms 120 Z0°V).…

A: Solve above problem

Q: Determine and sketch the output voltage waveform for the circuit shown if the sinusoidal signal at…

A:

Q: )calculate the magnitude of the voltage across the j9 ohm inductor. b) calculate the magnitude of…

A: In order to determine the voltage and current across the required elements. The above circuit is…

Q: Calculate the reactance of an inductor of 20mH at a frequency of 100 Hz.

A:

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: i = 100 sin 314t 2n

A:

Q: Which DMM measurement would you expect based upon the red and black leads in this image? OOV 2.5 V 6…

A: Equipment Function Voltmeter Measure AC and DC Voltage Ammeter Measure AC or DC Current DMM…

Q: QUESTION 8 Ten volt (10V) magnitude sinusoidal voltage of frequency 1MHz is applied across a 100 Ohm…

A: In this question, we need to choose the correct option. What is voltage across the capacitor.

Q: The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal…

A: Given- dc current- Id=10 A, ac current- Ia=20 A, To Find- The rms value of the resultant current…

Q: A 60 Hz sinusoidal voltage with an RMS value of 240 V is applied to a TRIAC voltage regulator. The…

A: Given, TRIAC voltage regulator having RMS value of input signal, Vrms = 240V  Frequency, f = 60Hz…

Q: Determine the values of resistance R and inductance L. need help on question C ，urgent

A: Solution (c) -  The circuit diagram is shown below,

Q: A 50Hz ac signal is applied to an inductor with an inductance of 400 mH. How many will the reactance…

A: XL = 2πfL where XL is the inductive reactance in ohms, f is the frequency of the AC signal in Hz,…

Q: What is the frequency of the input signal if the measured capacitive reactance is equal to 28 Q.…

A:

Q: (b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: QUESTION 24 An inductor of inductance 40 ohms in series with a 30-ohm resistor is connected to an AC…

A: For Questions number 14  to 17, kindly mention the "previous question". Here we are solving question…

Q: 4. A single phase full wave fullycontrolled (means all switches are thyristors) bridge rectifieris…

A:

Q: The current waveforms of a capacitor are shown in Figure below. Determine the average, root mean…

A: Given:capacitor current waveform as,with Ipeak = 400A.we need to find:a) the average value of the…

Q: QUESTION 2 The peak-to-peak voltage is 40V, its rms voltage is 14.1 V 11.4V 13.3V 12.3 V

A: The peak-to-peak voltage, VP-P=40 V

Q: 6)For the CRO Sine waveform shown in figure, determine (a) Time period, (b) frequency, c) amplitude…

A: Voltage scale reading = 100 V Time scale reading = 50 sec a).Time period: Time period T = number of…

Q: A 90 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 30 mV . When this…

A: Capacitance: Capacitance of a capacitor is defined as the ratio of amount of charge stored in the…

Q: . Inductive reactance XL Capacitive reactance Xc Total impedance Z Under what frequency range can…

A:

Q: If a new line is added between buses 1 and 4 in a system, then  the  elements of the Ybus affected…

A: The fallowing are the elements that are effected by the adding of an element between 1 and 4 buses:

Q: 20. If a 12-uf capacitor has a capacitive reactance of 54.2 ohms, the value of w is A. 1537.5. B.…

A:

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).