For a falling head permeability test, the following are given: Length of specimen = 375 mm Hydraulic conductivity = 1.72 m/min. Area of specimen = 1875 mm2 What should be the area of the standpipe for the head drop from 625 mm to 300 mm in 480 seconds? Select the correct response: 88.63 mm2 56.24 mm2 93.74 mm2 53.18 mm2

For a falling head permeability test, the following are given: Length of specimen = 375 mm Hydraulic conductivity = 1.72 m/min. Area of specimen = 1875 mm2 What should be the area of the standpipe for the head drop from 625 mm to 300 mm in 480 seconds? Select the correct response: 88.63 mm2 56.24 mm2 93.74 mm2 53.18 mm2

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter6: Hydraulic Conductivity

Section: Chapter Questions

Problem 6.14P

See similar textbooks

Similar questions

A glass cylinder 5 cm internal diameter with a screen at the bottom is used as a falling head permeameter. The thickness of the sample is 10 cm. The water level in the tube at the start of the test was 40 cm above tail water level and it dropped by 10 cm in one minute while the level of tail water remained unchanged. Determine the value of the coefficient of permeability in mm/s. a. 5.9 x 10^-2 b. 4.8 X 10^-1 c. 2.15 x 10^-2 d. 625 X 10^-2
The initial head is 300 mm in a falling head permeability test. It drops by 10 mm in 3 minutes.How much longer (in seconds) should the test continue, if the head is to drop to 180 mm ? a. 1681 b. 7145 c. 1457 d. 2532
please provide a clear and correct solution, thanks!
3.) A SAMPLE IN A VARIABLE HEAD PERMEAMETER IS 8CM IN DIAMETERAND 100K HIGH. THE PERMEABILITY OF THE SAMPLE IS ESTIMATED TO BE 10X10 4 CM/S. IP IT IS DESIRED THAT THE HEAD IN THE STAND PIPE SHOULD FALL FROM 2,4cm To SRE OF THE SIZE OF THE STANDPIPE IN mm 12 cm IN 3min., DETERMINE THE
please answer all parts
A sample in a variable head permeameter is 8 cm in diameter and 10 cm high.The permeability of the sample is estimated to be 10 × 10^–4 cm/s. If it is desired that the headin the stand pipe should fall from 24 cm to 12 cm in 3 min., determine the size of the standpipe in cm which should be used. a.1.29 b.5.43 c.3.67 d.4.19
Refer to the constant-head arrangement shown in the figure. L Graduated flask Porous stone Soil specimen For a test, the following are given: •L=18 in. • A = Area of the specimen = 3.5 in.2 • Constant-head difference = h = 28 in. • Water collected in 3 min =21.58 in.3
Hi! Question is shown in the picture. It is required to find absolute permeability.The answer is: 1 Darcy
Liquids A, B and C, in the containers shown, have SG of 0.60, 1.00 and 1.60 respectively. At what elevation (EL. C) will the liquid C stand in each of the piezometer tubes? Round your answer to the nearest hundredths. Pair = 12.5 kPa EL. 8 A (SG =) EL. 6 B (SG =_) %3D EL. 2 C (SG = EL. 0
A constant head permeameter has a cross-sectional area of 175 cm2 and is used to measure the hydraulic conductivity of a field sample 40 cm long. If the permeameter discharges 100 ml in 320 seconds under a head difference of 60 cm. a. What is the hydraulic conductivity as measured in the laboratory? b. What is the intrinsic permeability of the sample given that water at 20 C is used for the test? c. Is Darcy's law valid under the given conditions (D = 50 mm)? d. What would be the in situ hydraulic conductivity if the regional groundwater temperature is 12 C
By keeping the water level constant at 42 cm according to the sample subcode, a permeability test with a permeability cell of 8 cm diameter was carried out in a laboratory environment with a temperature of 20 0C. As the pure water collected during the 1 minute measurement after the steady flow observed in the experiment is as given in the form; Evaluate the permeability of the floor by finding the permeability coefficient in cm / sec.
A glass cylinder 5 cm internal diameter with a screen at the bottom is used as a falling head permeameter. The thickness of the sample is 10 cm. The water level in the tube at the start of the test was 40 cm above tail water level and it dropped by 10 cm in one minute while the level of tail water remained unchanged. Determine the value of the coefficient of permeability in mm/s. Provide a Diagram. a.5.9 x 10^-2 b.4.8 X 10^-1 c.2.15 x 10^-2 d.625 X 10^-2