For a coil having L = 2 mH, current flow through it is I = t²et then, the time at which emf becomes zero (a) 2 sec (c) 4 sec (b) 1 sec (d) 3 sec.
Q: Assume that the resistance = 3.9 ohms, the width of the rails is 2.2 m, the magnetic field magnitude…
A:
Q: A transformer has 390 primary turns and 9.1 secondary turns. (a) If Vpis 120 V (rms), what is V,…
A: Here, in this question, we will use the transformer equation which is, VpVs=NpNs=isiphere,Vp=Voltage…
Q: In HERTZ (rounded to 3 sig figs), approximately how frequently does this 1) device cycle through the…
A: Here we have given a differential equation of current.We have to study about the nature & other…
Q: Calculate the peak voltage of a generator that rotates its 200 turn, 0.100 m diameter coil at 3600…
A:
Q: For the circuit shown in Fig. Q2(b), assuming the switch has been opened for a very long time, when…
A: The switch was kept opened. hence, the inductor was initially uncharged. When the switch is closed…
Q: iven the signal is 8(t) = 2 sin(2710000t) + 0 What is the DC avg value in Volts?
A:
Q: The Emf is equal to ξ=46.1V, R=36.4Ω. What is the current flowing through R1 (in A)?
A:
Q: of current into or out of the page. Two paths are indicated for the line integral $ B.ds. What is…
A:
Q: A silver wire of radius 3.00 mm is used to make a coil. The coil should draw 10.0 A when connected…
A: The electrical resistance of a substance is the property that slows down the flow of charges and…
Q: In the potentiometer experiment, the slope of the calibration curve was found to be 25 V/m. When the…
A: Solution: Given that, the slope of the calibration curve is 25 V/m. The calibration curve is the…
Q: WR b. The power (P) supplied to an electric circuit is given by P i? dt. If i = 63 * I sin(wt), I is…
A: P=ωR2π∫02πωi2dtGiven that,i=63×Isinωt
Q: Problem 8: Suppose a large power plant generates electricity at 12.0 kV. Its old transformer once…
A: Part (a)Find the relation between current, power and voltage.
Q: A solenoid consists of 4200 turns of copper wire. The wire has a diameter of 0.200 mm. The solenoid…
A: -
Q: Calculate the intensities of the currents flowing in the other lamps, as well as the intensity of…
A: Current through L1=250 mA Current through L3=220 mA Current passing through the elements which are…
Q: R b N а +|E Emk ɛ = 400V, resistor R = 100, switch S and a toroid of N = 10* number of turns are…
A: Concept used: The energy of toroid depends on radius of toroid, current flowing through it , no. of…
Q: he current in an RL circuit drops from 0.80 A to 11 mA in the first second following removal of the…
A:
Q: In the figure, e = 94.8 V, R1 = 7.80 Q, R2 = 27.0 Q, R3 = 30.7 Q, and L = 1.65 H. Immediately after…
A: Since we answer up to three subparts, we will answer the first three. Please resubmit the question…
Q: A four pole machine generates 250V when operated at 1500rpm. If the flux per pole is 1.085x10^6…
A: In this case, a four-pole machine generates some voltage while operated at a certain speed. The…
Q: A 120.0-V motor draws a current of 5.92 A when running at normal speed. The resistance of the…
A: Given: V=120 Virunning=5.92 AR=0.629 Ω
Q: Question 1 For the given circuit below, determine the current ic(f) for t>0 assuming the switch has…
A:
Q: (b) Calculate the output voltage in Fig. Q4(b) given Rf=470k2, R1 = 4.3kN, R2 = 33kN and R3 = 33k2.…
A: R1 = 4.3 kΩ R2 = 33 kΩ R3 = 33 kΩ Rf = 470 kΩ
Q: In a circuit the switch S has been open for a long time. It is suddenly closed. Take emf=10.0 V,…
A: Given : ε = 10.0 V R1 = 50.0 kOhms = 50.0 × 103 ohms R2 = 100 kOhms = 100 × 103 ohms C = 10.0 uF =…
Q: Find the current in the switch at the same time. The current through the conductor at this time is…
A:
Q: In an RLC circuit, L=0.1 H, R=0.6; C=0.4F; and E(t)=60 V. Find the charge at time t. Assume the…
A:
Q: A metal rod makes contact with a partial circuit and completes the circuit. The circuit area is…
A: Given: B=0.150 T V=2.00 m/s R=3.00 ohm…
Q: A copper transmission cable (p = 1.72 × 10¬8 Qm) 250 km long and 20 cm in diameter caries a current…
A:
Q: R,=R_ R,=R R;=R R=R R3=2R
A: Voltage across R3 is V = 8V
Q: Use Ampere's Law to calculate the value of the line integral Φ B ds in a wire loop where the…
A: Here is the step-by-step explanation We will use Ampere's Law for a wire loop where the direction of…
Q: In the circuit shown in Fig, switch S1 has been closed a long time while switch S2 has been left…
A: Given data: The current through the resistor is i1=12.0 A. The rate is di/dt=-36.0 A/s. The final…
Q: A GFI may trip just because the live/hot and neutral wires connected to it are significantly…
A: Given: The variation in the length of the live and neutral wires trip the GFI.
Q: A motor has coils with a resistance of 25 Ω and operates from a voltage of 241 V. When the motor is…
A:
Q: Consider a series RC circuit as in Figure below for which R =5.2 MQ, C=3.2 µF, and ɛ=30.0 V. Find…
A: Given data: Resistance,R = 5.2MΩ = 5.2 × 106 Ω Capacitance,C=3. 2 μF = 3.2 x 10-6 F Voltage ε = 30…
Q: A circuit conducting loop lies in the xy-plane as shown. The loop has a radius of 0.2 m and…
A: When number of field lines linked with any closed loop changes, an emf is induced in the loop. Or…
Q: E: In an A. C. circuit, the flowing current is i = 5 sin (100 t - π/2) A and the potential…
A:
Q: Two circuits contain an emf produced by a moving metal rod, like that shown in the drawing. The…
A: (a) 1(b) 2(c) 8Explanation:
Q: The oscillating current in an electrical circuit is as follows, where I is measured in amperes and t…
A: Given data, Current I=4sin60πt+cos120πt
Q: 7. If the current flowing through the wires is given as i(t) = I, sin(@t), find an expression for…
A:
Q: The average television is said to be on 6 hours per day. Estimate the yearly cost of electricity to…
A:
Q: 59 In Fig. 27-51, R₁ = 20.0 2, R₂ = 10.0 22, and the ideal bat- tery has emf & = 120 V. What is the…
A:
Step by step
Solved in 2 steps
