Answered: For a 3.6°, 2-0 bipolar stepper motor,…

For a 3.6°, 2-0 bipolar stepper motor, the stepping rate is 200 steps/second. The rotational speed of the motor in rpm is, (a) 30 rpm (c) 90 rpm (b) 60 rpm (d) 120 rpm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Question 2. Considering this figure. The firing angle is 45°, the motor current is 10 A, and the…

Q: Adding auxiliary winding in single phase induction motors.

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Design a LabVIEW program that sweep Servo motor from 0 degrees to the specified angle and repeat…

A: The given image is very blurred.Kindly upload it again.It is not possible to read it. My mother is…

Q: 6. A synchronous motor can be used as a synchronous capacitor when it is (d) over-excited (a)…

A: To feed more active power and less distortion, the High power factor concept is used. To improve the…

Q: A single-phase full-wave converter controls a separately excited DC motor speed. A full converter…

A: Given: A single-phase full-wave converter controls a separately excited DC motor speed. A full…

Q: What are the similarities between an open-type split-phase motor and a capacitor-start motor? Select…

A: Open-type split phase motor has a centrifugal switch that operates when the motor reaches 75% of the…

Q: 2. A 220V 30 6poles 50Hz induction motor is running at a slip of 3.5 %. Find the following: (a) slip…

Q: The O smaller O larger the number of poles used in a stepper motor, the better the resolution

A: here we have to give relation between the number of poles and resolution.

Q: An induction motor has 4 pole 50 Hz frequency find synchronous speed (rpm). If motor speed is…

A: Given values are - P=4f=50HzNr=1400rpm

Q: Give Some application-s of motor,

A: A brief about DC Series Motor DC Series Motors have high starting torque and their speed…

Q: Angular speed of a DC motor running at a speed of 1200rpm is

A: To determine angular speed (in rad/sec) from the speed given in rpm

Q: (C)-Draw the mechanical characteristic of shunt and series DC motors. dienas SKINVER

A: Graph are provided,x and y axes are labelled with typical notations.

Q: Explain in detail the braking of Induction Motors

Q: A 12-pole induction motor has a frequency of 60 Hz. Its synchronous speed would be: (a) 600 rpm (b)…

A: Given: Total number of pole, P = 12 Induction motor frequency, f = 50 Hz

Q: 16 In the speed current characteristics of DC series motor, the speed is decreasing when the…

Q: 7- A 6-pole, 50-Hz, 3-0 induction motor is running at 950 rpm and has rotor Cu loss of 6 kW. Its…

A: Given Two multiple choice questions based on motors. Please find the below attachment for clear…

Q: What are the options suits for a slip ring induction motor? (A) Slip ring induction motor has high…

Q: What are the differences between a squirrel - cage induction motor and a wound - rotor induction…

A: The main differences between a squirrel-cage induction motor and a wound-rotor induction motor lie…

Q: The Frequency of rotor eut of an 8-pole induction motor in 2HZ. If the Supply frego is 50 Hz, then…

A: The given data is shown below:

Q: The excitation circuit of a free-excited DC motor is a single-phase full- * wave uncontrolled…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should be…

Q: Squirrel cage induction motor has less efficiency. Select

A: In this we will write about squirral cage IM efficiency...

Q: series motors has a very high starting torque because its armature resistance is small O True O…

A: Given A true or false question based on series DC motor. Please find the answer below

Q: A 48kW, 600V, 1500 rpm separately excited de motor is controlled by single phase semi-controlled…

A: Armature resistance (Ra) = 1 Ω Field resistance (Rf) = 145 Ω Firing angle of…

Q: A three-phase induction motor with 72 stator windings is excited with a 50 Hz AC voltage source. The…

A: Given: A 3-phase induction motor has 72 stator windings. Excitation frequency, f=50 Hz Slip,…

Q: 4.16 Determine the charge density due to each of the following electric flux densities: 8хуа, +…

A: The formula for divergence changes as according to the co-ordinate system Here they have given…

Q: What is of the 1800 rpm the value 4 pole induction of the torque induction motor at change the…

A: Since you have asked multiple questions, we will solve one question for you. If you want any…

Q: n flux control method the speed of DC motor is obtained O Both above and below base speed O Above…

Q: (a) The typical starting current for induction motor (i.e., at s=1) is five to eight times of the…

A: Induction motor:- It is a AC motor that runs at lower speed than synchronous speed so it is also…

Q: Draw Block diagram and transfer function of DC series motors

A: A DC series motor venture is to show the electrical electricity into mechanical one primarily based…

Q: A six pole induction motor is connected to a 25Hz supply and at full load the rotor emf makes 105…

A: The relationship between supply frequency and rotor frequency is given as Fr=S*F Where Fr= Rotor…

Q: what is the advantage of a capacitor start induction run motor over a resistance start induction…

A: The advantage of capacitor-start induction-run motor over resistance-start induction-run motor is…

Q: Self-Lift P/O Luo- Dc-dc Converter i need explain

Q: A 3-phase, 400/200 V, Y-Y connected wound-rotor induction motor has 0.06 rotor resistance and 0.3 Q…

A: Given- A 3-phase 400/200 V, Y-Y connected wound rotor induction motor has, Rotor resistance, R2=0.06…

Q: Speed control of a 140 V, 1.68 kW DC motor single phase thyristor full wave AC-DC

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: The rated speed of a three-phase, 2-pole, 50 Hz cage induction motor is more likely to be d) 1750…

A: Given: A 3-phase cage induction motor has, Number of poles, P=2. Rated frequency, f=50 Hz.

Q: Problem 7 A three-phase, 60 Hz, six-pole, Y-connected, 480-V induction motor has the following…

A: A three-phase induction motor is a type of electric motor that creates a spinning magnetic field…

Q: For a particular application, a 6-phase stepper motor must be capable of stepping in 10° increments.…

A: Given: Stepping angle, α=10° Number of phases, ms=6 And npulse=120 pulses/s

Q: A 3-phase, 6-pole induction motor con- nected to a 50 Hz supply runs at 975 rpm on full load. Its…

A: Given, A 3-phase induction motor has P=6f=50 HzNr=975 rpm

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

For a 3.6°, 2-0 bipolar stepper motor, the stepping rate is 200 steps/second. The rotational
speed of the motor in rpm is,
(a) 30 rpm
(c) 90 rpm
(b) 60 rpm
(d) 120 rpm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three phase induction motor rotates at speed of 1455 r.p.m. when its synchronous speed is 1500 rpm. Find the value of speed of stator structure with respect to rotor field. O a. 45 r.p.m. O b. 1000 r.p.m. O c. -45 r.p.m. O d. -1000 r.p.m.
A DC motor should be operated in a strong field which is due to the What happens to if suddenly goes a) nothing, it continues rotating b) it over speeds c) it stops rotating current if moter if rotating to zero. as before
For a 1.8 degree, 2 phase bipolar stepper motor, steeping rate is 100 steps/seconds. The rotational speed of the motor in rpm is
S29
For a particular application, a 4-phase stepper motor must be capable of stepping in 22.5° increments. How many poles must it have? What is the rotational speed in RPM, when the control unit of the motor supplies 200 pulses per second ? Select one: O a. P = 4 poles, and nm = 750 RPM O b. P = 6 poles, and nm = 666 RPM O c. None O d. P = 8 poles, and nm = 520 RPM Clear my choice
Synchronous speed in RPM of 6 pole, 50 Hz, 3-phase induction motor will be: (a) 1500 (b) 3000 (c) 1800 (d) 1000
Starting methech speed motor. we use and Control poly phase Induction
The starting torque of slip ring induction motor is High Negligible Medium O Low
A 4 pole induction machine is working as an induction generator. The generator supply frequency is 60 Hz. The rotor current frequency is 5 Hz. The mechanical speed of the rotor in RPM is
Q.14. What is slip in an induction motor? Q.15. What is the value of slip at start in an induction motor?