6. A synchronous motor can be used as a synchronous capacitor when it is (d) over-excited (a) under-loaded (b) over-loaded (c) under-excited 7. Synchronous motor always runs at (a) the synchronous speed (b) less than synchronous speed (e) both the speed and rotor flux (c) more than synchronous speed (d) none of the above 8. Change of D.C. excitation of a synchronous motor changes (a) applied voltage of the motor (c) power factor of power drawn by the motor (b) motor speed(d) any of the above (e) all of the above 9. The maximum value of torque that a synchronous motor can develop without losing its synchronism, is known as (a) slip torque (b) pull-out torque (c) breaking torque (d) synchronizing torque 10. The maximum power developed in a synchronous motor will depend on (a) the rotor excitation only (b) the supply voltage only (d) the rotor excitation, supply voltage and maximum value of coupling angle (90°) (c) the rotor excitation and supply volt-age both

6. A synchronous motor can be used as a synchronous capacitor when it is (d) over-excited (a) under-loaded (b) over-loaded (c) under-excited 7. Synchronous motor always runs at (a) the synchronous speed (b) less than synchronous speed (e) both the speed and rotor flux (c) more than synchronous speed (d) none of the above 8. Change of D.C. excitation of a synchronous motor changes (a) applied voltage of the motor (c) power factor of power drawn by the motor (b) motor speed(d) any of the above (e) all of the above 9. The maximum value of torque that a synchronous motor can develop without losing its synchronism, is known as (a) slip torque (b) pull-out torque (c) breaking torque (d) synchronizing torque 10. The maximum power developed in a synchronous motor will depend on (a) the rotor excitation only (b) the supply voltage only (d) the rotor excitation, supply voltage and maximum value of coupling angle (90°) (c) the rotor excitation and supply volt-age both

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

- In speed control of dc shunt motor, the speed is inversely proportional
4. A three phase, 50 Hz induction motor has a full load speed of 1440 rpm. The full load slip will be? a) 4% b) 5% c) 2.4% d) 3%
Draw Block diagram and transfer function of DC series motors
How rotor winding is derived the power in the three-phase induction motor? O a. from Single phase supply O b. from stator winding O c. None of the above O d. from slots
5
Rotor frequency
In which type of induction motor, external resistance can be connected? squirrel cage Slip ring capacitor start capacitor start and run
Discuss the possible situation that happened if the speed of a synchronous motor reaches the nameplate RPM
A 3-phase, 400/200 V, Y-Y connected wound-rotor induction motor has 0.06 Q rotor resistance and 0.3 Q standstill reactance per phase. To make the starting torque equal to the maximum torque, the additional resistance required in the rotor circuit will be O 0.24 0/phase O 0.42 0/phase O 0.34 Q/phase O 0.52 Q/phase
The difference between synchronous motor and induction motor
The rated speed of a three-phase, 2-pole, 50 Hz cage induction motor is more likely to be c) 3150 rpm d) 1750 rpm a) 3000 rpm b) 2850 rpm
Hdjjwjdjdnbe