flows from a pressurized tank, through a 15-cm-diameter pipe, exits from a 5-cm-diameter nozzle, and rises 6 m above the nozzle as shown in Figure. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible. Air 1m 15 cm 5 cm

flows from a pressurized tank, through a 15-cm-diameter pipe, exits from a 5-cm-diameter nozzle, and rises 6 m above the nozzle as shown in Figure. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible. Air 1m 15 cm 5 cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A pump draws water from a large open sump through a short length of the suction pipe. The water is delivered through a 21.1 m length of 9 cm diameter pipe and via a submerged exit into an open tank. A control valve is installed in the delivery pipe, for which f = 0.0085. Dissipation other than friction and the loss at the valve may be ignored. The bottom of the tank is 10 m above the free surface of the water in the sump. What power will be required in kW if the water will be delivered to 1.5m above the pump?
Q1) Water flows from a pressurized tank (in figure below), through a 10.0 cm diameter pipe, exits from a 5.0 cm diameter nozzle, and rises 5.0 m above the nozzle. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible. 5.0 m 3 em Air 50 с 10 еш Fig. No. 1
6. The nozzle which furnished the water to a certain hydraulic turbine 275 mm in diameter and has coefficient of velocity and discharge of 0.98 and 0.955 respectively. The nozzle is supplied from a 60 cm pipe in which the water approached the nozzle with a total head of 330 m. Compute the energy per second delivered by the jet to the turbine and the energy measure in horsepower lost in passing through the nozzle.
The nozzle which furnished the water to a certain hydraulic turbine 275mm in diameter and has coefficients of velocity and discharge of 0.98 and 0.96, respectively. The nozzle is supplied from a 60cm pipe in which the water approached the nozzle with a total head of 330m. Compute the following: a. Energy per second delivered by the jet to the turbine. b. Energy measured in hp lost in passing through the nozzle.
Argon gas flows through a well-insulated nozzle at steady state. The temperature and velocity at the inlet are 570°R and 150 ft/s, respectively. At the exit, the temperature is 460°R and the pressure is 40 lb/in². The area of the exit is 0.0085 ft². Use the ideal gas model with k = 1.67, and neglect potential energy effects. Determine the velocity at the exit, in ft/s, and the mass flow rate, in lb/s.
5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. THANK SUNTETICE Full Michifo Nas s itset SCH
Question is in figure
Example 5&6.2: Water flows from a pressurized tank, through a 6-in-diameter pipe, exits from a 2-in- diameter nozzle, and rises 20 ft above the nozzle as shown in figure E5&6.2. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible. Air (1) 20 ft 2 ft 16 in. Figure E5&6.1 2 in.
A closed tank contains 20 m deep water. A hose is connected as shown such that the nozzle (diameter = 1cm) is directed straight up, If the air gage pressure inside the tank is 20©kPa, solve the actual mass flowrate if the coefficient of discharge through the nozzle is 0.6. AIR 20 m O 1.59kg/s O 1.22kg/s O 1.86kg/s O 1.33kg/s