5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. SERENAY SIDE. BAUHERRE S THISTERIS TALSUALAR

5-64. A thin rubber tube of 25 mm inside diameter is used to siphon water from the large tank of Figure 5.56. To prevent the tube from collapsing, the pressure inside the tube can not be less than 50% of the pressure outside the tube. Determine the smallest value of h to prevent the siphon from stopping due to collapsing of the tube. 2.5 m 5 m Figure 5.56 System for Exercise 5-64. SERENAY SIDE. BAUHERRE S THISTERIS TALSUALAR

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q4) The system in Figure is used to calculate the pressure pl in the tank by measuring the 15-cm height of liquid in the 1-mm-diameter tube. The fluid is at 20C°. Calculate (1) the raising fluid due to capillary force. (2) the pressure at the surface of tank. 15 cm P1
In fig. if H= 88 inches, the difference in pressure =---?(the fluid is water) Piezometer (static) tube- -Pitot tube 2 BAR CO -Fluid stagnates at point 2 (v₂ = 0) 357.6. lb/ft2 O 243 lb/ft2 O 457.6 lb/ft2. O
1. Water flows through a horizontal, 0.5-m-diameter pipe at a rate of 0.9 m³/s (Figure below). It is ejected from the pipe through a 0.25-m-diameter nozzle. Determine the force (F) that holds the nozzle in place if the water pressure in the pipe just upstream of the nozzle is 283 kN/m² (kPa). F Fpl V₁. in F H Vout 2. Given H= 1.8 m & D = 0.2 m through the hole in the open top container. Determine the head losses through the tank outlet if the exit discharge were 0.163 m³/sec.
5-9 A 0.75-m³ rigid tank initially contains air whose den- sity is 1.18 kg/m³. The tank is connected to a high-pressure supply line through a valve. The valve is opened, and air is allowed to enter the tank until the density in the tank rises to 4.95 kg/m³. Determine the mass of air that has entered the tank. 2.83
No wrong answer please. A closed tank 3m in diameter and 3m high is filled with water and rotates about its axis at 100 rpm. A pressure gage at the center of the top reasds 30 kPa. During the rotation. (a) Determine the equivalent height of the fluid above the topalong its periphery. (b) Determine the pressure at the outer perimeter at the bottom of the tank. (b) Determine the pressure at the bottom of the tank at the center.
tank contains water upto a height of 1 m above the base. An immiscible liquid of sp. gr. 0.8 is filled on the top of water upto 1.5 m height. Calculate : () total pressure on one side of the tank, () the positiom of centre of pressure for one side of the tank, which is 3 m wide.
2.6 An open tank contains water upto a de pth of 2 m and above it an oil of sp. gr. 0.9 for a depih of 1 m. Find the pressure intensity (i) at the interface of the two liquids, and (ii) at the bottom of the tank.
height of water the pressure intensity : () at the interface of the two liquids, and (ii) at the bottom of the tank. [Ans. () 1.57 N/cm", (il) 3.04 N/em 6. An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of 2 m. Find 7. The diameters of a small piston and a large piston of a hydraulic jack are 2 cm and 10 cm respectively, A force of 60 N is applied on the small piston. Find the load lifted by the large piston, when: (a) the piston at the same level, and (b) small piston is 20 cm above the large piston. The density of the liquid in the jackis [Ans. (a) 1500 N, (b) 1520.5 NJ kg given as 1000 - 8. Determine the gauge and absolute pressure at a point which is 2.0 m below the free surface of water. Take [Ans. 1.962 N/cm? (gauge), 12.066 N/cm? (abs.)] - atmospheric pressure as 10.1043 N/cm?. 9. A simple manometer is used to measure the pressure of oil (sp. gr, = 0.8) flowing in a pipe line. Its right limb is open to the atmosphere and left…
Question 1 1.1. Calculate the total force (kN) on the bottom of the closed tank shown in the Figure below if the air pressure is 62 000 Palgage). Air 0.45 m Oil (sg -0.85) 0.80 m Water 1.5 m 1.1 m If the length of the tank in the Figure below is 1.45 m, calculate the total force on the bottom of the tank. NB: The tank is open on top. 1.2. im Tank is 1.45 m long Oil 1.25 m (sg 0.80) Water 2.5 m 2.0 m
Water fills the pipe AB such that the absolute pressure at A in 400 kPa The inner diameter of the pipe is 45 mm The density of the water is 1000 kg/m¹ Acceleration due to gravity is 9 81 m/s² (Eigure 1) Figure 0.3 m B 0.4 m 1 of 1 Part A If the atmospheric pressure is 101 kPa. determine the resultant force the water and surrounding air exert on the cap at B Express your answer to three significant figures and include the appropriate units. View Available Hint(s) HA F-0.5810³ Submit 4 Previous Answers N ? X Incorrect; Try Again: 3 attempts remaining CotINI