Five grams of an organic solid is dissolved in 100 ml of H20 (solvent 1). Which of the following extraction methods will remove the largest amount of the organic solid from the aqueous solution? Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. Three 50 ml portion extractions with ether (solvent 2) a b C d Two 50 ml portion extractions with ether (solvent 2) One 150 ml portion extractions with ether (solvent 2) One 50 ml portion extractions with ether (solvent 2) Unanswered Submit

Five grams of an organic solid is dissolved in 100 ml of H20 (solvent 1). Which of the following extraction methods will remove the largest amount of the organic solid from the aqueous solution? Select an answer and submit. For keyboard navigation, use the up/down arrow keys to select an answer. Three 50 ml portion extractions with ether (solvent 2) a b C d Two 50 ml portion extractions with ether (solvent 2) One 150 ml portion extractions with ether (solvent 2) One 50 ml portion extractions with ether (solvent 2) Unanswered Submit

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Answer all questions
What mass of MgCl₂ 6H₂O is required to make a 0.200 dm³ stock solution containing 25.0 ppm Mg(II)? What volumes of this stock solution are required to make 10.0 cm³ standard solutions containing 5.00, 1.00 and 0.10 ppm Mg(II)?
If 80% of a desired compound is extracted into the organic phase in each step (leaving 20% in the aqueous layer), how many extractions are necessary to ensure that at least 99% of the compound has been recovered in the organic phase? 1 extraction 2 extractions 3 extractions 4 extractions
Given the following table, answer the questions below. Table 1: Solubility values of compounds X and Y in solvents D, E Solubilities in 100mL Solvent E Temperature 0°C 100°C 0°C 100°C 1 26 2 27 Compound Y 3 0.5 1 A solid mixture contains 30 g of X and 4 g of Y was dissolved in 100mL of a chosen solvent.
4. Could you use methanol instead of methylene chloride to do a liquid-liquid extraction of an aqueous solution? Briefly explain why or why not. T5-12
7- Place the stopper on the volumetric flask and mix the solution thoroughly by inverting and shaking the flask. Don't add water to a level above the line on the neck of the flask. beaker balance $4.68 stirrer bar 6 volumetric flask C D Conclusion: state the concentration of your solution. E E Analysis: a. Calculate the concentration of your solution. b. Why was it necessary to invert the volumetric flask? c. Why should the final solution be left stopper? d. If we filled the flask to above the line how would this have changed the concentration of the solution?
A tea bag containing 15 grams of tea leaves with 0.7% of caffeine was used in solid-liquid extraction with 200ml of distilled water followed by liquid-liquid extraction using DCM. If 50.0mg of caffeine requires 10 ml of water and 3.0ml of DCM to be dissolved, how much caffeine can be extracted using 70.0ml of DCM? a. 4.8 x 10^-2 b. 5.7 x 10^-2 c. 3.8 x 10^-3 d. 5.8 x 10^-3