Find V, u and S in steam table using ideal gas properties for air. and provide steam table where u get the value thanks Ideal gas properties Cair)0tto cycle@stete ICompiession nP,= ESk PaFind V (m/ag) , s( s;/kg-k) and2goku [Kjkg]Astate2Com bustion begin sFind c Wm"/1s, sc kjlks-k) andPaE 2135 KpaT2= 128.45 k@ stente 3Expansion beginsFind r (m?/eg),S(kjlky-k) and: 6000 kpaTz: 2047.17 K-Dstate u txper sidn PnasPy: 239-06 (paFind V(m?lleg), s {ki/hg-k) and@states fompecion Injtate 5 =State!%3D

Given: P1=85 KPaT1=290 KP2=2135 KPaT2=728.45 KP3=6000 KPaT3=2047.17 KP4=234.06 KPaT4=815.61 K

Answered: Find V, u and S in steam table using…

Engineering

Mechanical Engineering

Find V, u and S in steam table using ideal gas properties for air. and provide steam table where u get the value thanks

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: posses for a carbon dioxide gas at 1958.76 C in kj/kg. use

A: R for CO2 =0.1889 T= 1958.76C = 2262K W= mRT m=1kg

Q: A tank of 2m volume contains Saturated temperature oft 4oć, the tanke contains 50% iquid and 50%…

Q: 3 Water at 35 MPa and v = 0.15 m /kg can exist in Select one: a. Superheated only b. Sat. vapor c.…

A: Option a is correct.

Q: ease consider steam at 500 kPa and 300 C. Please determine a. a and g in kJ/kg. b. vR in ce/gm.

Q: = missing properties

A: Solution given below.

Q: An initially empty cylinder is filled with air from 300 K, 100 kPa until it is full. Assuming no…

Q: Arigid cylinder containing o.006m et nitrogen at 1-o4 bat, 15c , is heated reversibly until the…

A: Given: Volume of cylinder=0.006m3 Initial pressure P1=1.04bar Initial temperature T1=15°C or…

Q: Super heated water vapor 1kg, 20 bar, heated from 240c to 280c closed system. How much heat is…

A: Given data: Pressure, P = 20 bar Temperature, T1 = 240°C Temperature, T2 = 280°C

Q: What are the laws of thermodynamic that describing the behavior of perfect gas?

A: The thermodynamic laws that describes the behavior of perfect gas: Boyle's law Charles law Gay…

Q: Find the internal energy and enthalpy for ammonia in a state where the temperature is -60°F and the…

Q: 1. Find enthalpy if 5kg of certain gas go through a reversible non flow that has constant pressure…

A: Given Data: Mass of the gas, m=5 Kg The pressure of the gas, P=700 kPa

Q: 500 kPa, 100°C 800 kJ/kg 5000 kPa, u 5000 kPa. y = 0.06 m³/1

A: a) Here, P=500kPa T=1000C U=418.80KJ/kg V=0.001043m3/kg The values will be superheated condition.

Q: A 4 m3 cryogenic storage tank contains nitrogen at 110 K, with quality 25%. Saturated vapor is now…

A: Given dataV=4m3T=110Kx1=25%=0.25x2=0.65 Nitrogen

Q: A 1m3 tank contains 4kg of air which have undergone a constant pressure process at 728kPa to a…

Q: A 250 L rigid tank contains methane at 500 K, 1500 kPa. It is now cooled down to 300 K. Find the…

A: Given Volume, V = 250 L = 0.25 m3 Pressure, P = 1500 kPa…

Q: A piston cylinder containes 0.1 kg air at 100 kpa, 126.85 C which goes through a polytropic…

A: Given data: The mass of the air is m=0.1 kg The initial pressure is P1=100 kPa The final pressure is…

Q: Steam is expanded from an initial state of 1300 kPa and 410 deg C to a final state of 102 kPa and 95…

Q: find: Final Pressure, torr Change in entropy Work, HP

A: The pressure of the methane is P1=104.3 kPa. The temperature before compression is T1=140 °F. The…

Q: Air is expanded from 400 kPa, 600 K in a polytropic process to 150 kPa, 400 K in a piston cylinder…

A: Given Point 1 Pressure = 400 kPa Temperature = 600 K Point 2 Pressure = 150 kPa Temperature = 400 K…

Q: boling temperat 5F. the pecific enthalpy at the final of the cooling rocess in BTU/bm

A: We are to determine the enthalpy of steam under isochoric cooling 1 kJ/KgK = 0.2388458966 BTU/lb F

Q: How much entropy is transferred if 200 W of thermal energy are transferred to a heat sink at 300K?

A: Consider the schematic diagram of the thermal reservoir (Heat sink) extracting heat.

Q: Determine the following of water at 300o C and 10 bar relative to water at 200o C and 60 bar.…

A: Given Data T1=300°CP1=10barT2=200°CP2=60bar

Q: For water at 1 atm with a quality of 10%, find the volume fraction of vapor.

A: Data given - P= 1 atm = 101.325 kPa Quality x= 10% = 0.1

Q: The mixture is initially at 101 kN/m2 and 32o C. Afterward, the mixture is heated under constant…

Q: Nitrogen at 300K, 3 MPa is heated to 500 K. Find the change in enthalpy using a) Table A-2 b and b)…

A: To Find : The change in enthalpy . Given : The initial temperature is Ti=300K The final…

Q: A gas is heated in a rigid container of volume V. Derive expressions to evaluate how U and H vary…

A: A gas is heated in a rigid container of volume V.

Q: In an engine, the air in a piston-cylinder arrangement has a compression ratio of 0.1. It starts…

Q: 5. The piston/cylinder as shown in figure 2 contains 0.1 kg water at 500 C, 1000 kPa. The piston has…

A: Data given-. T1 = 500°C P1 = 100 kPa Specific volume v1s = v1 / 2 m = 0.1 kg Temprature of…

Q: sketch the device sketch (piston/cylinder) at state 1 and 2. Plot the process on a T-s diagram and…

A: Given Data: The initial temperature of the air is T1= 27∘C. The final temperature of the air is T2…

Q: Given the absolute pressure of 11.45 bars a. Find the saturation temperature b. Specific enthalpy of…

A: From steam table calculator

Q: How does steam at 400° C formed from water at 20°C,at 1atm. Explain in detail with the types of…

Q: A rigid tank of 5 m3 contains nitrogen gas at 800 kPa, 700 K. By mistake someone lets 1.2 kg flow…

A: Data given- V1 =V2= 5 m3 P1 = 800 kPa T1 = 700 K Now m2 = m1 - 1.2 kg T2 = 450 K P2 = ? For…

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Find V, u and S in steam table using ideal gas properties for air. and provide steam table where u get the value thanks

Ideal gas properties Cair)
0tto cycle
@stete I
Compiession n
P,= ESk Pa
Find V (m/ag) , s( s;/kg-k) and
2gok
u [Kjkg]
Astate2
Com bustion begin s
Find c Wm"/1s, sc kjlks-k) and
PaE 2135 Kpa
T2= 128.45 k
@ stente 3
Expansion begins
Find r (m?/eg),S(kjlky-k) and
: 6000 kpa
Tz: 2047.17 K-
Dstate u txper sidn Pnas
Py: 239-06 (pa
Find V(m?lleg), s {ki/hg-k) and
@
states fompecion In
jtate 5 =
State!
%3D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

None
Thermodynamics Please help. With a clear T-s diagram
For 5.6 pmole of neon (Ne) that undergoes a cooling process from 1 atm, 1400°R to 1 atm, 590°R. Find the absolute change in entropy change in S in Btu/°R.
Find the total enthalpy of 1.4 kg of steam that is at 350 kPa with a 0.36 quality?
Provide correct answer , Attach steam table for verification. 1)Find the specific volume and entropy of water at 100bar and 200°c
From a state defined 300 psia, 100 cu. ft and 245 deg. F, Helium undergoes an Isentropic process to 0.5 psig. Find: a. V2 and T2 b. Change in Enthalpy and Internal Energy c. Heat and Change in Entropy.
A Dry into the Saturated steam at 15 bar entering Dry no33yle Comes out at 2 bar and o-96 dry ) Find out the exit velocity of the steam neglecting entry velocity 6i) if 101. of heat drop is lost in f riction, find out the o seduction in exit velocity.
I need the solution for this problem pls. Thanks a lot.
QI/ A volume of the vessel A is 0.3 m contains ammonia at 25 °C, 90% Acaonia quality. The pressure of cylinder B will be floated at 200 kPa, cylinder B in the beginning is empty. The air is flowed into cylinder B when the valve is opened and reaches to equilibrium state of 200 kPa, 25 °C. Determine the heat transfer during the process.
Need Correct Solution.
7
can you write pressure, temp, volume for each state in chart. also show steps like including all calls, especially for p4